How long does it take for a new sticky fish tank to release water, and how long does it take for a f

After the fish tank is glued, it is generally necessary to wait 3-4 days before releasing water.

If it is exposed to the sun, it can be released in 1-2 days. Sticky fish tanks are generally made of glass glue.

When sticky, it must be applied evenly, otherwise there will be pores, which will leak. If there is a water leak, be sure to find out where the leak is first, and then repair it from the outside with glass glue.

The fish tank newly glued with glass glue can only be released after the glue is completely solidified, and the fish can be raised after the trapped water is completed. Glass glue is a commonly used adhesive, the main components are sodium silicate and acetic acid and organic silicone. The curing time of glass glue increases with the thickness of the bond, for example, 12mm thick acid glass glue, it may take 3-4 days to set, but in about 24 hours, 3mm of the outer layer has cured.

When bonding glass, it has a peel strength of 20 pound-inches after 72 hours at room temperature. Due to the different types of glass adhesive formulations, the curing time is also different, please refer to the product manual. The completion time of trapped water raising depends on the feeding situation, raise ordinary goldfish, put some baking soda in tap water, and you can raise it immediately.

To raise marine fish and live corals, it takes more than a month for the living stones of the Berlin system to open the tank and burst algae.

As long as there is no problem with the glue, it can be used in 2 days. It is normal to have a sour taste, after the fish tank landscaping is done well, you can not immediately release the fish when it is filled with water, you must first raise the water for 10 days to a month after putting two irrelevant fish to test the water, and you can officially release the fish after a few days.

The new sticky fish tank should wait for the adhesive to fully cure before releasing water.

Generally, it is better after 24-38 hours.

The new tank is watered for 6 to 9 days before the fish can be released.

Steps: 1. Disinfect and sterilize the new fish tank first, and then fill the fish tank with water. Because the water contains a lot of chlorine, the water in the tank should be dried for 2 to 3 days.

2. After 2 to 3 days of water raising, the water quality environment should be reasonably regulated according to the conditions of the aquarium organisms raised, and the temperature, pH, and hardness should be adjusted to the required range, and the fish tank should be oxygenated for 24 hours in advance.

3. Finally, it is necessary to establish a nitrification system, after raising water, it is necessary to put nitrifying bacteria to open the filter, and after the process of water quality from clear to turbid and then clear, you can start to raise fish, which generally takes about 4 to 6 days.

First, the new fish tank needs to be kept in water for a few days before the fish can be released.

It takes seven days for fish to be released in the new tank. If you want to raise fish in a new fish tank, you need to raise good water, and the water needs to be filtered, aerated and cultivated, and this process takes about seven days, so it will take at least seven days before the fish can be released. In addition to being clean, it is more important to cultivate beneficial bacteria and establish a complete ecological cycle so that fish can grow healthily.

2. What to do before raising fish in a new fish tank.

1. Disinfection: The new fish tank should be disinfected before raising fish. The method of disinfection is very simple, and the general drug used is potassium permanganate.

But chlorine dioxide can also be used.

After mixing it with dissolved oxygen, soak the inner wall of the fish tank and you're done. The soaking time does not need to be too long, potassium permanganate can be soaked for about 1-2 hours.

2. Cultivation: Before raising fish, we must raise water, and the most important thing in raising water is to cultivate bacteria. Cultures are mainly used to culture nitrifying bacteria.

This is an aerobic bacterium, which can convert ammonia nitrogen.

Converted to nitrate.

In this way, the water quality is better maintained, and it is also helpful for the health of the fish. To cultivate bacteria, you need to pour nitrifying bacterial liquid, and at the same time, you need to turn off the lights and explode oxygen to accelerate reproduction.

3. Test the water: In order to ensure that the water in the fish tank has been raised, you need to put a few fish to test the water. Fish testing the water usually have to choose a little more solid skin, so that it is more certain whether there is a problem with the water.

If there is no problem with raising for about half a month, you can put other fish, and if you get sick, you need to turn the tank again.

Fish can only be released after 5-6 days in the new tank. Generally, it takes 2-3 days to trap the water, and then it takes 1-2 days to fill the oxygen and establish a nitrification system, during which the water quality will first become mixed and then clear, and the fish can be released after the water is clear. However, for the sake of insurance, it is best to put a few fish to test the water first, so as not to open the tank well, resulting in the fish getting sick and dying.

Come on, how long does it take for the fish tank to be filled with water? I think that when the fish tank is finished, the water will stop for another hour and a half, and then put the fish in, so the water is lukewarm, so it won't die, if it's cold, the fish will die, and when you change the water, the water is warm, so you can't change it all, so half of the warm water, half of the cold water.

The fish tank is cleaned first and then put water in, so you can release the fish after the water is put in. Because releasing water into the fish tank is the last step before releasing the fish in.

The following is for reference.

After applying glass glue, the surface will solidify after a few hours because it comes into contact with air.

After the surface is cured, it will take a few days for the uncured glass glue inside to dry and cure completely.

The glass glue must be completely dried and cured before it has the strongest adhesion.

In particular, the bottom glass glue is related to the key to whether the fish tank will leak after bonding.

Therefore, it is recommended to wait patiently for 5 days before putting water into the fish tank.

After the new fish tank is glued, according to the thickness of the glue line and the thickness of the glass, it needs to be placed in a dry and sunny place for 3 to 7 days before testing the water.

When testing the water, you should add water slowly, and let it stand for 24 hours after adding water to the maximum capacity of the fish tank. It is normal for the fish tank to have a sour smell of glue line, and the fish tank can not be released immediately after the landscaping is set up, and the fish need to be raised for more than ten days before the fish can be officially released.

Fish Tank Installation Steps:

First, the location.

To install the fish tank, first of all, put it in a predetermined position to see if the bottom is flat, and at the same time whether the height is appropriate, because it usually needs to be fed and changed water, so it can not be placed too high or too low. At the same time, it is also necessary to pay attention to the overall force of the fish tank, and do not put anything on it, so as not to cause uneven force and crack the fish tank.

Second, put in the bottom sand.

Once the fish tank is placed, you can pour the bottom sand into the tank. The bottom sand can play a role in filtration, and at the same time, it can also fix aquatic plants, so it is necessary to control its thickness according to the situation, generally about 3-5 cm. It should be noted that in order to prevent the sand from being washed away, be sure to find a plate first, put the sand in it, then slowly add water, and then take out the plate when it is full.

3. Install the equipment.

In addition to the bottom sand and some landscaping, the fish tank also needs a lot of auxiliary equipment, the common ones are filters, heating rods, oxygenation pumps, etc., and some need protein skimmers and carbon dioxide supplementation equipment, etc., put these equipment into the fish tank to check whether it can work normally, especially filtration, generally open for a day first.

Fourth, open the tank to raise water.

After the above is ready, you can prepare to raise water, inject the trapped water into the fish tank, pour in the appropriate amount of nitrifying bacteria, and then turn off the lights and burst the oxygen for a period of time, waiting for the water quality to be turbid and clear, you can start fish farming.

The 1 meter 2 fish tank is placed in the water for 7 10 days after the glue is played, and the glass glue is a chemical product, and the fish tank can be placed in a ventilated and cool place for 7 10 days to start fish farming. Before raising fish, the fish tank can be disinfected by pouring potassium permanganate solution into the tank. After that, you can place a few fish in the tank, as long as the fish can survive in the tank for more than half a month, you can start to release the water to raise fish.

1 meter 2 fish tank after glue placed 7 10 days to release water, glass glue belongs to chemical products, with a certain toxin, after the fish tank glue, it will be placed in a ventilated and cool place to store 7 10 days can be released.

Before the fish tank is discharged, the tank needs to be filled with water, pour in potassium permanganate volume solution, soak for a few hours and then drain the water, and then clean the fish tank with clean water to ensure that there is no drug residue.

After that, you can put hungry nitrifying bacteria in the fish tank to ensure that the water is clean and thorough. Then you can place a few fish in the tank, as long as the fish can survive in the tank for more than half a month, it means that the tank can be successfully opened and you can start to release the water to raise fish.

The newly bought fish tank must go through the process of disinfection and water raising, and the fish can be broken into the tank for a day, and if the fish are raised, they must be disinfected for 1 day, and the water time is about a month.

First fill a tank of water, check if there is any leakage, if not, sprinkle a few packets of salt, soak in very thick salt water for 2 days, then pour it out, rinse repeatedly.