How to hit a jump ball with a regular nine cue

In terms of hitting the ball, the jump ball is somewhat similar to the tie stick, with the back hand of the club raised high, but the two techniques are completely different. If you want to hit the jump ball, the inclination angle of the cue stick should be at least more than 30 degrees, most of the time it should be more than 45 degrees, use the vigorous stick to hit the cue ball at the middle point or slightly up, the left or right will become a curve ball and lose the crosshair.

The so-called toning rod refers to the strength of point A and point K, which use eight to ninety percent of the strength to hit. The range of application of the jump ball is limited, first of all, the back hand should be in the range that can be raised high, and the obstacle ball is too far or too close to the cue ball. The easiest jump ball to play is usually the cue ball close to the cue ball, the obstacle ball is about a foot away from the cue ball, and it only blocks a small part of the goal route, because in this case the back hand is easy to, and the cue ball does not have to jump very high, you can start from this kind of ball.

The greater the strength of the toning rod and the higher the angle of the club, the more obvious the effect of jumping the ball.

The jump ball is an advanced skill in the freestyle nine-ball, and the accuracy of such an awkward stroke is bound to be greatly reduced, so it is very risky, so don't try to jump unless you have no other choice. But on the other hand, it would be a pleasure to hit a good jump shot and it would be the biggest reward for a golfer.

Billiard jumping poles can be played with a forehand, a backhand, or a flower ball.

1. Forehand technique.

You can use a V-shaped stick, aim at the bottom of the cue ball, adjust the angle and then play the rod, the key is to hit the lower part of the ball, and the angle between the cue stick and the table should be large.

2. Behind-hand technique.

The backhand technique should be fast, accurate, ruthless, straight, and not long, so as not to slide the rod, and the cue ball will hit the cue ball in a short time, so that the cue ball and the table will instantly collide and squeeze each other, so as to bounce up.

3. Flower ball play.

Flower ball play needs to hit the point directly below the cue ball, do not hit the bottom of the cue ball, so as not to dig sweet potato foul, jump the ball should first judge the distance relationship between the obstacle ball and the cue ball and the sub-ball, if the obstacle ball ion ball is too close, the cue ball does not have enough space to hit after jumping, it is easy to cause the first hit to other sub-balls and foul, if the obstacle ball is close to the cue ball, you need to use the "short game" jump ball.

If there is only one ball between the obstacle ball and the cue ball, the "special jump ball method" of the short game can be used, and the back hand posture is like "holding a pen", and the cue ball and the table form an angle of about 80 degrees, so that the mother and the ball can produce the effect of "jumping up immediately" after being hit.

How to hit billiards:

Push brother Xun Huai score:

Hold the stick horizontally, hit the center of the cue ball, when the cue ball collides with the target ball, the target ball advances, the cue ball also follows the target ball at the same time, slowly moves in the same direction, and slowly stops after traveling a distance, which is the way to play the ball propulsion.

Set-pieces: Horizontal holding of the pole to throw the wrist out of the pole is to use the explosive force of the wrist to hit the center of the main ball slightly lower hit point, the cue ball slightly slid forward, when the cue ball collided with the target ball after the main ball transmitted all its forward momentum to the target ball, the target ball then moved forward and the cue ball lost power, it stayed in the position of colliding with the target ball, so it is called a set piece.

Pull-up ball: hold the rod horizontally, swing the wrist to hit the middle and lower part of the main ball, use the strong explosive force of the wrist swing, make the cue ball reverse and slide forward, at the moment when the cue ball collides with the target ball, the Mu Chang Jian standard ball is knocked forward and the cue ball is released by the reaction force of the collision, and then rotates backwards and retreats, so it is called the trolley ball.

There are several conditions for playing a jumping pole in billiards:

1. The table should be good and elastic, because the jumping pole required by the national standard is a high pole jump, and the ball must be bounced up with the help of the elasticity of the table;

2. The leather head of the cue should be hard, and it is not because you can't jump the club because you can't do it, but because the leather head is too soft and there is no sail performance;

3. The posture should be right, and the club should stand up at a certain angle; Congratulations.

4. The tracing point should be correct, aiming at the middle and upper part of the billiards, and not biasing left and right. If you get all these points right, the high pole jump is easy.

Yes. Jumping is the process of hitting the cue ball so that it jumps over one or more obstacles in front of it and hits the target ball. If you want to play the jump stick ball, you must raise the tail of the cue ball and hit the top half of the cue ball, otherwise the foul play will make the cue ball cross the obstacle ball.

Also pay attention to the high rack, low hitting point, and fierce shots.

When playing billiards, it is necessary to understand how to use the cue, what part of the ball is played and the rotation changes that the ball will produce, the reaction of the two balls after the main ball actively hits the target ball, and the direction of the state of the sail source.

The point where the cue hits the cue ball when the cue ball hits is the collision point, and when facing the cue ball at eye level, it is a circular surface, and the surface of the center of the circle is full of points that can be hit, but when hitting, it is necessary to consider the direction of the hit and the rotational force.

When playing billiards, there are generally three kinds of movement skills, namely low club, stopper, and high club.

When the low game is played, the white ball is retracted after the shot, and the place of hitting the ball is generally below, and it should be noted that the shot should be fast when hitting the ball, and the shot should be heavier.

When stopping, it is necessary to make the white ball change direction after hitting the wall or the ball, and the left or right side of the ball when hitting the ball cannot be changed due to the change of the point of impact.

When hitting the ball, the high club is to heel the white crack filial piety ball after hitting the ball, and the position above the ball is hit, and the hitting strength is moderate, not too heavy.

1. Forehand technique: all use V-shaped frame rods.

2. Rear hand technique: the rod should be fast, accurate, ruthless, straight, and not long, so as not to slide the rod. The cue ball hits the cue ball in a short period of time, so that the cue ball and the table instantly collide and squeeze each other, so as to "bounce up".

3. Hitting point: directly below the cue ball. Note:

If the obstacle ball is too close, the cue ball will not have enough space to hit after jumping, and it is easy to foul the other sub-balls first; If the obstacle ball is close to the cue ball, a "short game" jump ball is used. Tip: If there is only one ball between the obstacle ball and the cue ball, you can use the "special jump ball method" of the short game

The back hand position is like "holding a pen", and the cue ball forms an angle of about 80 degrees to the table, so that the cue ball can "jump immediately" after being hit.

4. Please see the overall demonstration effect. Pool ball, also known as American billiards, is called "pool ball" because of the use of various dice balls marked with numbers, that is, flower balls. The games include the number ball, the number 9 ball and the number 10 ball.

Answer by raising your backhand and hitting the cue ball above 45 to give the cue ball a downward force. Whether it is a cue ball, table mud or marble slab, it has a certain elasticity, and the cue ball bounces up through the reaction force to achieve the purpose of jumping.

First set the hand frame normally, aim at the target ball you want to play, then turn your left hand to the elevated position, try to hold the middle and back third of the cue stick with your right hand at about 45 degrees from the table, hit the upper middle of the cue ball, aim slightly lower, and use force thoroughly, but do not pestle other people's mud.

Use the ** force of the table to make the cue ball over the obstacle ball. Control your power according to the distance you are going to go. The basic skills of billiards include high rod, shrinking rod, deflection, jumping ball, etc.

Many skills evolved from these fundamentals, such as braking balls, jumping balls, deflections, high band spins, and curveballs (banana balls).

[Correct Jumping Ball]: This is mainly with some beginners who can not correctly understand the jumping ball, in the ball room, I often see some beginners, friends who have just come into contact with billiards, when there is an obstacle ball in front, the cue stick hits the bottom of the cue ball, and the way to exert force is to pick up when the stick is out. Usually we say"Pout", this is a foul, the correct jump ball, is to raise the back tail of the cue club, hit the cue ball 1 2 or more is a reasonable jump ball action.

Jumping ball principle]: Raise the back hand, hit the cue ball 1 2 or more, give the cue ball a downward force, whether it is the cue ball, table mud, marble slab, have a certain elasticity, through the reaction force to make the cue ball bounce up, to achieve the role of the jump ball.

How to jump the ball]: First, make full use of the force to shake the wrist"Don"Force, no"Ramming"Some bar friends will have such a misconception when playing ball, the greater the power, the higher the probability of the cue ball jumping. Although the words are good, but the understanding of the big power of the bar friends is occasionally biased, the power is large, it is penetrating, crisp, deep and long, just like using a hammer to nail nails, you seem to be a very hard hammer, but you can't nail in, but some people seem to be very relaxed, but the nail will go in after a while, here is the force of the deep, thorough, brittle.

This requires a lot of practice, and there is no self-instruction.

I put the cue stick up on top of the cue ball. The left (right) side can be used, note: the main control power and the take-out lever are required"Fast".

After the rod is played, the cue ball rotates the scale distance and position! That's what we're calling"Tie the rod"Finish. Still, watch more.

Ask more. Practice a lot; in order to improve the level of billiards skills. You have time to practice!

It takes a lot of practice to get the effect you want.

That's a bit more complicated

If you want to play a jump ball without a low club, you need to use a stick, which requires a high level If you want to learn, you can go to the billiards training school to learn!

The first is the playing stick, which is used to hit the ball normally on the table;

The second type is the punch, which is used to tee, because the nine-ball tee requires a lot of strength, if you use the batting rod to kick off, it will damage the cue stick, and the life of the cue is shortened, the ram is invented for this, the wooden rod is harder, and the leather head is mostly made of bakelite, in order to have better explosive power for the tee.

The third type is the jumping stick, because the rules in the nine-ball allow jumping over the obstacle ball to hit the target ball, so prepare a jumping stick to hit the jumping ball, the length of the jumping stick is about three-quarters of the length of the hitting stick, so the design is to better play the jumping ball.

The jumping rod itself is a punch bar, but the interface is designed in three-quarters of the way, and the remaining back lever can be removed, and the remaining part can be used as a jump bar.

The first horn is the "plastic" part between the leather head and the maple, which looks like plastic, in fact, the first horn of some poles is made of special fibers, and this kind of horn will not stick to the chocolate powder.

A set of nine-clubs usually includes a batting, punching, and jumping club.

Playing rods, as the name suggests, must have good performance!

Punch rod, each game ball is used at most once, to protect the rod, to be a little harder, the leather head is best to be bakelite, so that it is not allowed to rot!

The jump stick is used for the jump ball, and if the target ball is blocked by other balls, you can use the jump stick!

The anterior horn is the milky white part of the skin under the head!

There are a lot of materials for the first corner, but metal certainly can't!