Volkswagen Magotan parking system failure, help

My car has also encountered such a problem, you can go to the 4S shop for diagnosis, and the result can be obtained immediately, generally the switch is broken! If it is the technology of the 4S shop, you can rest assured, the Magotan car only needs to be plugged into the professional maintenance computer (the 4S shop has) will immediately know that there is a problem with your car, Magotan belongs to the digital model, any electronic accessories have problems will be displayed on the maintenance computer! The landlord can rest assured!

Abstract]: A 2010 Volkswagen Magotan sedan with a mileage of about 60,000 km. The owner reflected: the car parking brake indicator flashed.

After picking up the car: the maintenance personnel detected the parking brake control unit and found that the fault code 02434 - the power supply of the left channel of the control unit was missing. Check the relevant fuse and find that it has been blown out. The resistance of the fuse output to the tie iron is measured, and it is found to be in the state of short circuit.

The parking brake control unit controls 2 parking brake servo motors, so the control unit needs to be supported by a high-power power supply. In fact, the control unit is powered by 2 fuses, which are SD30 and SD310 respectively, and the fuse that blows is SD30, which is connected to the T30 13 pins controlled by the parking brake control unit.

Disconnect the parking brake control unit plug-in, measure the resistance of the T30 13 pin on the wiring harness side to the tie iron, and find that it is a short circuit. It can be seen that the short circuit point is located in the line between the output end of the fuse SD30 and the Ding 30 13. Dismantling the armrest box and inspecting it, it was found that the power cord of the parking brake control unit was short-circuited with the body.

Old Maitan. The brake failure performance of the brake failure is that the small yellow light begins to turn on.

The solution to the failure of the Magotan parking brake: the brake fault light is generally lit after starting, if it is not lit, it means that your braking system is faulty. The small yellow light is always on, which is usually the brake fluid.

Missing or excessive wear of brake pads. It is recommended that you first check whether the brake fluid is enough and whether the brake pads are overworn; Add brake fluid or replace brake pads. Generally, there is no fault in the braking system, which is the handbrake.

The switch is a problem.

The main reason for the failure of the parking brake is that the gap between the friction pad and the brake drum is too large, and there is oil stain on the friction plate and brake drum or the friction plate is seriously worn, the rivet is exposed, and the surface hardening causes slippage.

Volkswagen Magotan parking light on, fault code 02442

Explain that the brake fluid level of FAW-Volkswagen Magotan is low, and the brake fluid level is lower than the safety line, resulting in the lights of the station, and the brake fluid needs to be replenished in time, that is, the brake fluid is stopped, and the specific operation steps of FAW-Volkswagen Magotan plus brake fluid are as follows: 1. Open the door of the cab of FAW-Volkswagen Magotan on this side. 2. Pull the hood switch on the left side of the driver's leg of the FAW-Volkswagen Magotan version.

3. Lift the hood of the FAW-Volkswagen Magotan engine upward. Fourth, use the support rod to support the hood of the engine of FAW-Volkswagen Magotan to ensure that the support is firm to avoid danger during operation. 5. Unscrew the lid of the brake fluid storage tank of Volkswagen Magotan and add the brake fluid to the MAX line.

Jane is old.

The function light of the operating unit is broken or short-circuited to the ground [car questions, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

Explain that FAW-Volkswagen Magotan brake fluid level is low, brake fluid.

The surface is lower than the safety line, causing the parking light to be on, and the brake fluid needs to be replenished in time.

That is, brake fluid, the specific operation steps of FAW-Volkswagen Magotan plus brake fluid are as follows:

1. Open the door of the cab of FAW-Volkswagen Magotan on this side.

2. Pull the hood switch on the left side of the driver's leg of FAW-Volkswagen Magotan

3. Lift the hood of the engine of FAW-Volkswagen Magotan upwards.

Fourth, use the support rod to support the hood of the engine of FAW-Volkswagen Magotan to ensure that the support is firmly solid to avoid danger during operation.

5. Unscrew the lid of the brake fluid storage tank of FAW-Volkswagen Magotan and add the brake fluid to the MAX line.

Summary. Hello dear, happy to answer your <>

Volkswagen electronic parking failure: Here are some possible solutions: Reset the electronic parking system:

Sometimes the failure of the electronic parking system is due to the error of its control unit. In this case, you can try to fix the problem by resetting the electronic parking system. You can either follow the steps on your vehicle's instructions or go to a professional repair site.

Replacement of faulty parts: If the failure of the electronic parking system is due to a damaged or failed component, it may be necessary to replace the corresponding part. For example, if an electronic parking switch fails, it may need to be replaced.

Software Update: <>

Sometimes electronic parking systems fail because their software is outdated. In this case, you can head to a popular authorized repair site for a software update.

How to solve the parking failure of Volkswagen electronics.

Hello dear, happy to answer your <>

Volkswagen electronic parking failure: Here are some possible solutions: Reset the electronic parking system:

Sometimes the failure of the electronic parking system is due to the error of its control unit. In this case, you can try to solve the problem by resetting the electronic parking system. You can either follow the steps on your vehicle's instructions or go to a professional repair site.

Replacement of faulty parts: If the failure of the electronic stop system is due to a damaged or inefficient component, the corresponding component may need to be replaced. For example, if an electronic parking switch fails, it may need to be replaced.

Software Update: <>

Sometimes electronic parking systems fail because their software is outdated. In this case, you can head to a popular authorized repair site for a software update.

A fault is a phenomenon in which a system or equipment does not work properly or an error occurs due to an abnormality or operating state. There are many causes of failure, such as hardware failure, software failure, electrical failure, environmental factors, etc. The performance of the equipment decreases, or even cannot work, which brings inconvenience and impact to the work and life.

Therefore, timely troubleshooting is an important means to ensure the normal operation of equipment or system. In automobiles and other mechanical equipment, failure <>

Warnings are usually issued to drivers in the form of fault lights, Hu Zheng alarm sounds, etc.

Electronic Parking Brake P light flashes.

During the operation of the vehicle, the P light of the Electronic Parking Brake (EPB) flashes, indicating that the electronic parking brake system is malfunctioning. EPB system failures can be caused by a variety of reasons, such as sensor failure, electronic control unit (ECU) failure, electronic handbrake motor failure, etc. If the EPB system fails, it is recommended to go to a professional car repair center as soon as possible for inspection and maintenance.

If the EPB fails, the handbrake may not work properly <>

It may affect the safety performance of the vehicle. Do not attempt to operate or adjust the EPB system before inspection and repair, as it may further damage the vehicle or endanger driving safety.