How to solve the abnormal noise of automobile glass lifting

Generally speaking, our window glass, in the regular lifting and descending, will produce the phenomenon of aging of the rubber guide groove, after a long time, the car glass will have a slight jam, this situation can be treated with window lubricating oil, directly spray it on the rubber, so that on the one hand can be lubricated, on the other hand, it can also maintain the toughness of the rubber.

If we lift the car glass, not only there is an abnormal sound or even a side tilt, or the lifting does not respond, it is likely to be caused by the loss of initialization data of the window, at this time we have to initialize the window, after the car is on fire, pull the switch up.

There is also a situation, the window glass lifting has an abnormal sound, because in the window rubber guide trough, there is dust accumulation, the resistance increases, it will make an abnormal sound, we only need to clean the glass guide trough, the specific method is to wet it with a rag and wrap it to one end of the chopsticks, fix it with a rubber band, and then reach into the glass guide trough and slide back and forth to clean it, if you use the dial wax to maintain the interior of the interior sprayed some in the glass guide trough, the effect will be better.

There are three ways:

1. Clean the dust of the sunroof slide rail and apply lubricating oil;

2. Tighten the loose screws;

3. Replace the sunroof seal.

1. Remove the dust on the sunroof slide rail, and apply some lubricating oil on the slide rails on the left and right sides of the skylight, especially the abnormal noise parts can be appropriately coated more.

2. Some loose fixing screws are tightened, and the chute is cleaned regularly.

3. Because the sunroof sealant is often exposed to the sun and rain, it should be replaced regularly.

If the vehicle is driving on bumpy roads, try not to open the sunroof, because if the vibration between the sunroof and the slide rail is too large, it will cause deformation of the sealing parts, and in severe cases, it may also cause damage to the motor. Therefore, when the vehicle passes over a bumpy road, it is best for the owner to close the window to avoid causing more damage to the vehicle.

Sunroof daily maintenance skills:

1. Pay more attention to the status of the sunroof guide.

It is necessary to get into the habit of checking the sunroof rails, and if you wait until there is an abnormal situation to remedy it, it will be too late.

2. The frequency of use of sunroofs should not be too high.

Although the sunroof is also part of the window, its mechanical structure is not the same as that of the door window, and it is also much more squeamish.

3. Don't open the sunroof immediately when the car is cold in winter.

Winters in the north are unusually cold, and after the car is parked overnight, the edge of the sunroof may be frozen with dew and cannot be opened for a while. At this time, you must not open the sunroof immediately, because the snow in the sunroof trench will increase the resistance of the sunroof opening, and blindly operating the sunroof will cause the sunroof switch motor to burn.

4. Check the drainage status of the skylight before the rainy season.

The sunroof actually "enters the car", but the water seeping into it will flow out of the car through the drainage hole of the sunroof bracket and will not enter the cabin. However, if you find that the edge of the sunroof in the cabin will seep or even leak after rain, then it is necessary to check whether the drainage hole of the sunroof is blocked.

1.The main reason for the loose fastening screws is that the glass regulator guide rail is different, and you can go to the repair shop to tighten the loose windows for professional maintenance;

2.Replace the sealing strip of the window or spray it on the rubber with lubricating oil to lubricate and maintain toughness;

3.If the glass regulator makes abnormal noise, there may be foreign objects in the glass guide rail, so you can clean up the debris in the glass guide rail by yourself or go to the cleaning shop for professional cleaning. The specific method of cleaning is to wet it with a rag and wrap it to one end of the chopsticks, fix it with a rubber band, and then slide back and forth into the glass guide groove to clean it.

Here's how:

1. First of all, determine which door of your car has abnormal glass noise, if you are not sure, then close all the doors and raise and lower the windows one by one in the driver's seat, so that you can judge the abnormal sound of the glass.

2. After determining the abnormal noise of the glass, raise the abnormal noise window to the top, and then take out the prepared table wax (sold in the car supplies market or equipment store), and spray the table wax on the gap between the planting strip (the sealing strip on the outside of the window glass) and the glass outside the window, not too much, but to spray evenly, after spraying, lift and lower the glass two or three times in a row, so that the abnormal noise will disappear or be reduced.

If the abnormal noise still exists, it means that the fault may be inside the glass regulator, please ask a professional to deal with it.

What should I do if there is an abnormal noise when the window glass is raised and lowered?

Is there an abnormal sound when the window glass is lifted and raised? Auto mechanics demonstrate tips and solve them easily by yourself!

The gap of the sealing strip of the door and window card slot is easy to bring dust and particles into the process of glass lifting, and the glass rubs against it during the lifting process, resulting in abnormal noise. If dust and particles accumulate more and more, causing damage to the lifting motor, it will cause abnormal noises and even affect the lifting function. Workaround:

Remove the foreign matter in the card slot and clean it.

It is recommended to go to the repair shop to check [If there is a problem with the car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】

What may be the cause of the abnormal noise of the right window glass: If the abnormal noise you describe refers to the abnormal noise generated in the process of glass lifting, then it may be the sound of the running parts such as the glass regulator and the glass lifting motor, or the abnormal noise caused by the friction between the window glass and the glass guide groove in the process of lifting, if the abnormal noise you describe refers to the abnormal noise generated by the right front door in the process of driving, Then it should be when the vehicle is driving on a bumpy road, etc., the door trim panel or other parts inside it have a large fitting gap caused by the abnormal noise, but the specific problem needs to be specifically analyzed, the problem of abnormal noise of the maintenance vehicle must be inspected on the spot, and according to the conditions of abnormal noise and the nature of the sound and the source of the comprehensive analysis can make an accurate judgment, so it is recommended that you go to the repair shop to conduct on-site test inspection and judgment of the vehicle according to the above analysis. This kind of problem is easy to judge and eliminate after on-site test inspection.

Generally speaking, our window glass, in the regular lifting and descending, will produce the phenomenon of aging of the rubber guide groove, after a long time, the car glass will have a slight jam, this situation can be treated with window lubricating oil, directly spray it on the rubber, so that on the one hand can be lubricated, on the other hand, it can also maintain the toughness of the rubber.

If we lift the car glass, not only there is an abnormal sound or even a side tilt, or the lifting does not respond, it is likely to be caused by the loss of initialization data of the window, at this time we have to initialize the window, after the car is on fire, pull the switch up.

There is also a situation, the window glass lifting has an abnormal sound, because in the window rubber guide trough, there is dust accumulation, the resistance increases, it will make an abnormal sound, we only need to clean the glass guide trough, the specific method is to wet it with a rag and wrap it to one end of the chopsticks, fix it with a rubber band, and then reach into the glass guide trough and slide back and forth to clean it, if you use the dial wax to maintain the interior of the interior sprayed some in the glass guide trough, the effect will be better.

One, in fact, it is very simple, you can buy a bottle of lubricant to spray it, there are lubricants specially used for car windows, there are many on the Internet, you can take a look at it yourself, buy it and match it. The effect is still quite good.

Causes of abnormal noise in car glass:

Weatherstrips deteriorate and need to be replaced. Car seals are made of rubber, and one of the major characteristics of rubber is that it will age. Weatherstrip aging can cause the glass regulator to stick to the seal, resulting in slow glass lifting with a squeaky sound.

There is sediment in the glass tank and the glass tank needs to be cleaned. If the car is driving on a road with a lot of sand, more or less sand will get into the glass trough. If there is more sand in the glass tank, the friction between the glass and the groove will increase, and the glass will make a squeaking sound when it is lifted and lowered.

Glass regulators have been running for a long time and lack lubrication. Just apply some lubricant.

The lifting of the door glass is carried out by the lower lifting mechanism. Although the lifting mechanism is hidden in the middle of the door, the pervasive dust can always penetrate it. In addition, the lifting rails and cables are coated with butter, which makes it easier for dust to stick.

At this time, you only need to clean the dust butter on the rail of the lifting mechanism and add new butter to eliminate the abnormal noise. As for the failure of the lifting motor, it may be caused by frequent manipulation of the glass lifting, which can only be solved by replacing the lifting mechanism.

Hello landlord, if there is an abnormal noise in the new car, it is recommended to go directly to 4S Ha. Free treatment during the warranty period, it is estimated that it is caused by foreign objects in the glass cracks.

The treatment method of abnormal noise of automobile glass lifting is as follows:

1. When there is a lot of dust in the rubber guide trough of the window, which leads to an increase in resistance and causes abnormal noise, it is necessary to clean the glass guide trough if you want to solve this situation. Prepare the rag and chopsticks, wet the rag with water, wrap it around one end of the chopsticks and fix it with a rubber band, and then slide the end into the glass guide trough back and forth until the internal organs of the guide trough are removed. <>

2. When the rubber in the rubber fiber guide trough of the vehicle's glass is aging, it will cause a slight jam in the window during the lifting period, resulting in abnormal sound. In response to this phenomenon, you can use window lubricating oil to deal with it, which is very affordable and easy to use. Not only does it act as a lubrication, but it also maintains the toughness of the rubber, so that the two-pronged approach eliminates abnormal noises.

1. Introduction 1: The window is used on the car for ventilation and the setting outside the car, by opening the window can be a good way to realize the air in the car and the air outside the car to exchange and circulate, so as to maintain the freshness of the air in the car.

2. Introduction 2: After opening the window, you can talk to the personnel outside the car, so that you don't need to open the door to get off the car to communicate with the people outside the car, saving a lot of trouble, especially in rainy days, so the window is very important as a window for external communication.

Summary. Hello dear! <>

Car glass maintenance method: use the special wiper blade for the car, replace the front windshield in time to avoid scratching, use the special glass water for the car, add smooth and reduce the wear and tear of the front windshield, do not use the wiper to deal with the sundries on the front windshield, remove the glass with a towel to avoid scratching, and use the wiper to wipe off the dust and other things on it when it rains, so as to avoid scratching the front windshield.

How to deal with the abnormal noise of automobile glass lifting.

Hello dear! <>

The treatment method for abnormal noise of automobile glass lifting is to apply the window lubricating oil to the glass sealing strip of the window glass to lubricate it, replace the window glass sealing strip, remove the deplication trembling in the window glass guide rail, and tighten the screws or buckles inside the window glass. <>

Hello dear! <>

Automobile orange Jingpai car glass maintenance method: use the special wiper blade for the car, replace the front windshield in time to avoid scratching, use the special glass water for the car Yuanhe, add smooth to reduce the wear and tear of the front windshield, do not use the wiper to deal with the front windshield if there are sundries, remove the glass with a towel to avoid scratching the glass, and use the wiper to wipe off the dust and other things on it when it rains to avoid scratching the front windshield.

If the car glass is lifted abnormally, it may be caused by the aging of the glass strip or the abnormal noise of the glass lifting mechanism.

Under the door glass, there is a sealing strip. If the strip is aged, the friction between the strip and the glass will increase, and the lifting glass will make abnormal noise. The solution is also very simple, you can replace the glass sealing tape with a new one, or you can spray it on the tape with a special spray, so that there will be no abnormal noise when the glass is lifted and lowered.

If the glass lifting mechanism is abnormal, you need to go to the repair shop to disassemble the door trim and check the glass lifting mechanism. If the glass lifting mechanism is damaged, it needs to be replaced.

When the car is used for a long time, there is often a strange sound of socks and glass lifting, and the glass lifting is not smooth. Most of this is caused by the aging of the glass strip, which only needs to be sprayed with a professional spray.

There are many sealing strips on the car body, so these rubber products will age with the increase of use, so we should pay attention to the maintenance of these rubber products when maintaining the car. If the tape is not well sealed, the tape should be replaced in time. Poor tape sealing can cause rainwater to leak into the car when it rains.

Try not to park your car in the sun, as this will accelerate the aging of the sealing tape.

Millions of car purchase subsidies.