When booting up, press del to appear how to install the glgabyte uefldualblos system

Hello, you can set the hard disk to boot.

1. First of all, press F1 when booting up (all kinds of computers have different buttons) to enter BOIS

2. After entering, set the hard disk to boot (refer to the reference material for detailed method).

Problem analysis: The computer automatically enters the CMOS interface of the motherboard when it is turned on, if you rule out human error to enter (you can press the ESC key to exit), it means that the computer fails to pass the self-test when it is powered on, which is generally a CMOS parameter error or hardware failure. Common phenomena include battery failure, misconfiguration, poor memory or hard disk contact, etc., which need to be investigated one by one.

Solution: 1. Battery failure: If the system time in the BIOS is wrong, it may be that the motherboard battery fails, causing the computer to call the default parameters of CMOS, if it is inconsistent with the local hardware environment, the computer cannot be started normally. You can purchase a motherboard battery to replace it, then turn on the computer and press the DEL button (F2 or other designated hotkeys for notebooks) to enter the CMOS interface, and reset the correct parameters, and finally press F10 to save and exit the reboot.

2. Configuration error: This situation will also occur due to the manual configuration of CMOS parameters that do not match the local hardware environment. In general, you can press the F1 key to skip the non-fatal error and start the computer directly according to the prompt message on the black background and white text on the screen, or press the del key to enter the CMOS, then press F9 to load the predefined parameters or select Load optimized defaults or load fail-safe defaults, and then press F10 to save and exit the restart.

3. Hardware failure: If the above operations are invalid, it means that there is a problem with the hardware, generally because the memory and the hard disk are in poor contact or the hard disk master boot record is damaged, and the memory or hard disk needs to be reinserted and unplugged, or the hard disk master boot record is repaired or the system is reinstalled or the hard disk is replaced.

This situation may be due to the fact that the computer cannot detect a certain hardware during the self-test or is stuck in the detection of a certain hardware.

1. Keyboard and mouse, the boot self-test will detect the mouse and keyboard, if there is a problem, it will cause the card to the self-test interface, the solution is to unplug the keyboard and mouse, check whether it passes the self-test, if it passes the self-test, replace the mouse and keyboard.

2. Hard disk and optical drive, the most likely is the hard disk and optical drive, the desktop needs to open the chassis, unplug the power cord of the hard disk optical drive to see if it passes the self-test, if it passes, further rule out the problem of hard disk or data cable.

3. If none of the above is true, then the most likely thing is that there is a problem with the motherboard BIOS and needs to be returned to the factory for repair.