What should I pay attention to when a new car is on the road, and what should I pay attention to whe

What are the precautions for a new car?

Forehand grip to avoid accidental injury.

The first is the steering wheel. The first thing to pay attention to when driving is the correct use of the steering wheel: when holding the steering wheel with both hands, the left hand is on the steering wheel.

At nine or ten o'clock, hold it with your right hand.

Three- or four-point orientation, so that the posture of the left hand is high and the right hand is low, and it is more labor-saving when turning. Importantly, when using this position, the right hand has little effect on the left hand when controlling other mechanisms such as the gear knob.

Some people are accustomed to using the backhand method of pulling out the steering wheel, this posture uses the steering wheel, if there is an accident, the return force of the steering wheel will cause accidental injury to the operator's arm.

Don't always put your left foot on the clutch.

Many people develop the habit of stepping on the clutch before braking and always putting their feet on the clutch when learning to drive. But in fact, this habit only accelerates the wear rate of the clutch plates, and it is also unsafe. If you press the clutch first and then the brakes at high speeds, the car loses the brakes of the engine, and is actually in a free state, and it is easy to lose control.

Therefore, if there is an emergency, immediately apply the brakes sharply to avoid accidents, and then make up for the second kick. Then, according to the situation, release the brakes, step on the clutch, change to the appropriate gear and drive normally.

Get into the habit of braking with your engine.

It is often said that "the old driver drives with the accelerator, and the new driver uses the brake to drive", which is what it means. Old drivers generally have a prediction of the driving situation, such as how far away from the intersection, how long it will take for the green light to turn red, he will release the accelerator first, let the car slide with gear, reduce the speed of the car by braking the engine, and stop lightly in the right situation and wait for the red light.

Novices generally either grab the lights or drive at normal speeds, and stop the car with one foot in front of them. For example, when encountering a curve, the old driver will "slow in the oil and get out quickly", release the throttle at a certain distance before entering the corner, rely on the engine brake to slow down, and then turn to the outside road to cut into the center of the bend. Novices generally go to the bend and slow down by braking to enter the corner.

Compared with the two, it is obvious that the method of controlling the car with the throttle is more fuel-efficient and has less impact on the life of the car.

Drive on ramps and keep your distance away.

Novices should pay attention to judging the distance between the cars when following the car. For example, if your speed is 90 kilometers per hour, the distance between you and the car in front should be kept at about 100 meters, so that once the car in front is in condition, there is enough distance for you to take measures. In case of rain and snow, the distance between the vehicle in front and the car in front should be appropriately increased than usual; On the uphill section or overpass, when the speed of the car is relatively slow, the distance should also be appropriately increased to prevent the vehicle in front from slipping when starting on a half-slope.

Pay attention to the traffic rules and have all the documents.

When a new car is on the road, it should be noted that: 1. Control the speed, and the engine speed should be controlled at 2000 to 4000 rpm per minute; 2. When driving, try not to mess with spring or maintain a constant speed for a long time, run in the engine through different gears when manually transmitting the car, and run in the engine through different speeds for automatic transmission cars; 3. When a new car is on the road, it is necessary to conduct a comprehensive inspection of the car, which can be through the sound of the engine or the display of the car dashboard; 4. Reasonable run-in tires can extend the service life of car tires, and the new car will drive at a moderate speed at the beginning of 100 kilometers to avoid emergency braking during driving.

1. It is very important to warm up the new car at the start, especially in winter, the temperature of the engine that has just started is low, and the lubricating oil in each part is not enough. There are the following precautions for the departure of a new car. 1. Adjust the speed: When the new car starts, the speed must be adjusted.

In a car during grinding, the engine speed needs to be adjusted to 2,000-4,000 rpm. If the engine speed is too high and too late, it is easy to cause abnormal wear and tear, and the engine cannot be fully ground. The cost of car maintenance may increase in the later stage.

2. Please pay attention to the speed change: the new car needs a reasonable run-in. Try not to maintain a certain speed for a long time while driving.

When driving in manual transmission, the engine can be accustomed to different gears. In the case of automatic shifting vehicles, the engine needs to be adapted at different speeds. 3. Run-in tires:

New car tires also need to be run-in to achieve better results. Reasonable run-in tires can extend the service life of car tires. The first 100 kilometers of the new car are driven at a moderate speed to prevent the phenomenon of emergency braking while driving.

Emergency braking not only causes an impact on the braking system during the run-in, but also increases the shock load on the chassis and engine; 4. All-round inspection: When a new car departs, it is necessary to conduct all-round inspection of the car. Veteran drivers with rich driving experience can judge the use of the car by the sound of the engine, and can also determine the use of the car through the display of the car dashboard.

The red warning light is on, and you must find the parking strip for flame-out detection.

The new car on the road has the following precautions: 1, control the speed: when the new car is on the road at the beginning, you need to control the speed, in the run-in period of the car, the engine speed should be controlled at 2000-4000 rpm, the engine speed is too high, easy to cause abnormal wear, the number of hidden can not let the engine get full run-in, the later may increase the cost of car maintenance;

2. Pay attention to the speed change: the new car needs a reasonable run-in, try not to maintain a constant speed for a long time when driving, and the engine can be run in through different gears when driving a manual transmission car.

3. Tire running-in: new car tires also need to be run-in to have a better use effect, reasonable run-in tires can extend the service life of car tires, the new car in the initial 100 kilometers, at a moderate speed, to avoid the phenomenon of emergency braking during driving, emergency braking not only makes the braking system in the run-in impact, but also increases the impact load of the chassis and engine; Potato Hall.

4. All-round inspection: when the new car is on the road, it is necessary to carry out a comprehensive inspection of the car, the old driver with rich driving experience can judge the use of the car through the sound of the engine, and can also determine the use of the car through the display of the car dashboard.

Millions of car purchase subsidies.

When a new car is on the road, you must pay attention to these aspects: control the speed, pay attention to the speed change of the car, pay attention to the run-in of the tires, check in all directions before driving, maintain it when it is due, never kill the steering wheel, and never refuel until the fuel tank bottoms out.

1.Control the speed of the vehicle: When a new car starts on the road, you need to control the speed of the vehicle.

In the running-in stage, the engine speed should be controlled at 2000-4000 rpm. If the engine speed is too high, it is easy to cause abnormal wear, and the engine cannot be completely run-in, which may increase the maintenance cost in the later stage.

2.Pay attention to the shifting: new cars need to be reasonably run-in. Try not to maintain a constant speed for long periods of time while driving. When driving a manual transmission car, you can get the engine running in different gears. If it is an automatic car, it needs to drive at different speeds in the engine.

3.Tire running-in: New car tires also need to be run-in to have better service results.

Reasonable run-in tires can prolong the service life of car wheel keichi tires. When a new car is driven for the first 100 kilometers, emergency braking needs to be avoided during driving. Emergency braking not only shocks the braking system during break-in, but also increases the shock load on the chassis and engine.

4.Full inspection: When a new car is on the road, a full inspection of the car is required.

Experienced drivers can judge the use of the car by the sound of the engine, and can also judge the use of the car by the display of the car dashboard. If there is a red warning light, you must find a parking belt to check the flame-out.

Millions of car purchase subsidies.

The correct way to run a new car is to drive at as low a speed as possible. Generally, the maximum speed is within 50-100 km/h. Do not allow the engine to idle for too long before starting.

Emergency braking should be avoided within 300 kilometers of the initial driving period; Within 1000 km, the throttle should be fully open. Precautions during car approach are as follows: Not suitable for high-speed driving:

There is a speed regulation at the beginning of the new car, which is generally within 50-100km h. It is generally stipulated that in the first 1000 kilometers, when the throttle is fully open, the car defect speed can not exceed 80% of the maximum speed, and it is required to observe the engine tachometer and speedometer in use, so that the engine speed and speed work at medium speed. Not suitable for full load operation:

A new car driving with a full load can damage machine parts. Don't run long distances, either, as this will increase the continuous working time of the engine and aggravate the wear and tear of parts. Emergency braking is not suitable:

Emergency braking will not only impact the braking system during the run-in, but also increase the shock load on the chassis and engine, so do not use it for the first 1000 km. In case of emergency, try to press the clutch pedal first to reduce the impact on the engine. When driving, change gears in time.

Do not drive in high speed and low gear or drive in low speed and high gear, and do not use one gear for a long time.

The precautions for novices to drive on the road are as follows: 1. Pay attention to braking skills: do not panic when encountering brakes, when judging that the brakes are about to be braked, slowly and continuously step on the brakes, evenly reduce the speed, when the body is about to stop, a little bit of loosening the brake pedal until the body is stable, and the sudden braking will produce greater wear and tear on the wheels and brake pads, which is not good for the vehicle.

2. Pay attention to the lights, don't turn on the high beams: don't turn on the high beams when following the car, don't turn on the high beams in the urban area, and turn off the high beams when the car comes from the opposite side to avoid accidents. 3. Precautions for novices when crossing corners:

Curve driving is to slow down before entering the corner, the right foot on the brake, can warn the vehicle behind, after entering the corner, continue to put the right foot on the brake, remember to hold the steering wheel steady, to the corner after half of the pass, see the straight began to accelerate, the curve drive must not be too fast, the control is not good to allow the macro branch cover is prone to accidents. 4. The slower the road driving, the better, and drive at a moderate speed: if conditions permit, drive close to the speed limit to keep up with the speed of the overall traffic flow, and ensure safety while ensuring driving efficiency.