How do physical and chemical inspectors do a good job in safety production? Any good suggestions?

Just do it seriously, be careful, and don't be paralyzed.

Dear, hello, I am happy to answer for you, chemical laboratory technicians correctly master the inspection safety technology 1, laboratory technicians must change work clothes and wear personal protective equipment according to the relevant requirements before entering the laboratory; 2. Before using the instruments and equipment, check whether the instruments and equipment are normal and whether the power supply is well wired. When the instrument and equipment fail, the cause should be found out and the fault can be eliminated before continuing to be used. Instruments and equipment are not allowed to run with illness, resulting in potential safety hazards.

After the instrument and equipment are used, it should be restored to the required position and the power supply should be disconnected; 3. During the experiment, pay attention not to leak the liquid into various instruments, especially the buried part of the live part, to prevent disasters or electric shock accidents; 4. For the equipment that generates high temperature in the work of the electric constant temperature drying oven, the strict leather cavity should be strictly followed by the equipment operation procedures to avoid being burned during the operation; 5. The safety management of flammable, explosive and hazardous chemicals shall comply with the "Safety Management System for Flammable, Explosive and Hazardous Chemicals in Laboratories"; 6. The laboratory must be kept quiet, and it is forbidden to make noise, frolic, eat and store food indoors. 7. Do not move the laboratory instruments and equipment at will; When inspecting and maintaining instruments and equipment, it must be carried out with the power supply cut off; 8. When conducting toxic and harmful gas experiments, ventilation must be done; 9. Laboratory technicians should do a good job in preventing heat stroke, skidding, lightning strike, poisoning, electric shock, and falling from height. When an accident occurs, effective measures should be taken immediately to deal with it in a timely manner and reported to the relevant leaders; 10. After the experimental test is completed, the instrument, electricity, water, etc. should be turned off for inspection, and the instrument can be left only after confirmation; 11. Destroy the remaining flammable and explosive drugs in a timely manner; 12. It is forbidden to place flammable, explosive and other dangerous drugs near fire, electric heating appliances or other heat sources; 13. When evaporating, distilling or refluxing flammable and explosive drugs, the laboratory technician shall not leave without authorization, shall not use open flame for direct heating, and shall use water bath, sand bath or oil bath to heat according to the boiling point, and should pay attention to indoor ventilation to avoid excessive steam concentration; 14. When pouring or using flammable and explosive drugs, there shall be no open flame nearby, and when inadvertently dumping flammable and explosive drugs on the laboratory table or on the ground, the nearby heating source should be immediately disconnected, and the liquid should be sucked dry with towels and rags to strengthen indoor ventilation; 15. The laboratory technician must fully understand the characteristics of the experimental reaction and the chemical reagents used.

Before the experimental reaction is understood, the amount of sample should start with the minimum amount. For dangerous experiments, corresponding protective measures should be prepared and how to deal with accidents in the event of accidents; 16. It is not allowed to mix all kinds of chemicals arbitrarily. It is strictly forbidden to use unlabeled reagents; 17. The use and operation of flammable and explosive drugs should be carried out in the fume hood, and the operator should wear corresponding safety protective equipment; 18. Check the storage, use and requisition records of drugs once a month, and check whether the accounts are consistent with the inventory quantity of drugs.

The temperature and ventilation of the drug depot should be checked frequently. There should be no peculiar smell and smoke in the warehouse, and any abnormalities should be dealt with immediately; 19. Smoking is strictly prohibited in the laboratory; When using an electric stove, asbestos boards or bricks should be placed at the bottom;