Will the fault light turn on if the oil is added too much, and why is the indicator light still on w

Hello. The fault light will be on, you can take a large syringe and connect it to the infusion hose, pull out the oil dipstick, insert the hose and use the syringe to suck some out. Ask oh thank you.

Hello. It will be bright, it is not good for the engine, it is recommended to drain the oil in time, I wish you a happy car! If my reply can help you, please help choose it, thank you very much!

Hello, it will be bright, if there are more, it should be pulled out, I hope it will help you, hope!

There is nothing to do with changing the oil and the reminder light, the reminder light is to tell you to replace the maintenance, after the change, you must reset the maintenance lamp, some cars can use manual control reset, and some need the computer to modify the reset setting for the next maintenance mileage, your car is just to change the oil, and there is such a situation without doing the next step of maintenance to zero.

1. Under normal circumstances, the oil indicator of the ignition switch instrument should be on, and the oil indicator should be extinguished after the fire.

If the oil is normal, check whether the oil alarm switch and wiring are normal, if there is no problem with the above, it is best to go to the repair shop to check the engine and oil pump problems.

2. After the engine starts, the generator and the oil pump start to work, at this time the generator has begun to generate electricity, and the oil pump works to make the oil reach a certain pressure to meet the needs of the engine, so the two alarm lights will go out, which means that the system is running normally.

If the engine has been started and the alarm light is still on, it means that the power generation part of the car is faulty or there is a problem with the oil pressure, and the engine needs to be turned off and then the car is tested (mainly the oil part, if the engine continues to work in the oil pressure alarm state, it may cause serious damage to the engine).

If the car's engine oil supplement light is lit for a short time, this is normal, because after the car turns on the ignition switch, the engine is undergoing self-inspection, and the owner only needs to wait for the vehicle to start normally, the engine will work normally, and the signal of insufficient oil will disappear.

Discover car engines.

When the fuel replenishment indicator light is on, it should be checked immediately in the 4S shop, and it should not continue to drive, otherwise the engine loss of the car will further increase, and in serious cases, it will cause irreversible harm to the engine itself.

First, what you said is just that the lamp should be a maintenance reminder light, changing the oil and the reminder light is not related, the reminder light is to tell you to replace the maintenance, after the replacement to reset the maintenance light, some cars can be manually controlled to reset, some need the computer to modify the reset setting for the next maintenance mileage, your car is just a change of oil, there is no next step of maintenance to zero there is such a situation.

Second, you may be talking about the oil pressure lamp, if the oil pressure indicator light is on, then it is a fault, not by oil change can be solved, occasionally bright, some of the viscosity of the oil can be used temporarily, the light will go out, but not a long-term solution, this needs to be repaired to judge the engine ** problem targeted maintenance can be solved, such as instrument, oil pressure sensing plug, line, oil pump, engine size tile gap is too large and so on.

The oil lamp is on, indicating that the oil pressure is seriously insufficient. Generally, it is mostly caused by a lack of engine oil!

You'd better check the dipstick right away, and add a little if it's not enough. If you force the engine to drive in case of a serious shortage of oil, in case the car has a problem, it is a serious failure.

First of all, you need to change the oil, and then you need to use the computer to troubleshoot, so that the indicator light is not on. If it lights up again after a while, you need to see if there is a problem with the sensor.

There are many cases, the most common being a broken oil induction plug or a wiring tie. It's best to go to the 4S store to check it out.

Check whether the oil induction plug is faulty.

There are many cases where the oil sensor plug is broken, or the wiring is hit.

No! Because the order of the working principle of the engine is: the starting motor runs first, so that the engine produces motion inertia and then ignition, and at the same time injects gasoline into the cylinder, and the gasoline does work after combustion.

On the one hand, it outputs power. On the other hand, with the continuous injection of gasoline to produce continuous movement, when the ignition is turned off, the throttle valve is closed, and the engine stops working after the spark plug is not ignited. In fact, the engine oil does not participate in the combustion of the engine (microscopically, it will actually enter in trace amounts due to the difference in the tightness of the piston rings), but it is a trace amount and will not affect the engine work.

Just lubricate other parts that need to be lubricated outside the cylinder.

So: even if you add too much, it will not affect the engine work. However, due to the addition, the internal oil pressure is too high, which causes the internal pressure of the entire engine mechanism to be high, resulting in the internal lubrication resistance of the engine becoming larger, resulting in the decline of engine performance.

No, the oil light is on, to be precise, the oil pressure is too low, only to cause the failure, generally speaking, it is the oil pump damage or the oil is too much carbon blockage caused by too much oil, easy to increase fuel consumption, the engine is easy to burn oil, oil leakage ......Hope it helps