Smart projection How to install software on XGIMI projector,Watch live TV

XGIMI projector does not have built-in TV software,So you need first-party software。 And XGIMI has some restrictions on third-party software installation packages,In order to break through the restrictions,You can** below the [XGIMI Special Edition] of the ant market to the U disk。

Then the U disk is connected to the XGIMI projection,Open the U disk; You can also open the USB flash drive from [My] - Explorer].

Find the installation package of the USB flash drive and install it.

<> TV home.

Installation Software Method:

1. Start XGIMI projector.

It is recommended to install a third-party app market directly.

XGIMI projector installs software through two methods: USB disk or optimization master+USB disk,You can install TV home by watching live TV,It has been used for several years。

How to connect the XGIMI projector to the mobile phone:

1、Connect XGIMI projection and mobile phone in the same LAN,Open the screenless assistant TV application in XGIMI projection。

3. Enter the screenless assistant on the mobile phone, click the upper right corner of the home page to enter the remote control interface, and then tap the upper right corner to enter the connection interface.

Routine maintenance methods for projectors

When the projector switches from the power-on state to the shutdown state, there should be at least an interval of about 5 minutes of heat dissipation time. Because the power supply of the projector adopts the method of switching power supply to reduce and stabilize the mains power, when frequently turning on and off, the high-power switch tube and transformer used in the projector power supply work at a higher frequency, and the switch tube will produce considerable power consumption in the process of frequent switching.

The fundamental thing to extend the life of the bulb is to first shut down safely, fully dissipate heat, and then keep the use environment clean and tidy, and use it in too humid places will also shorten the life of the bulb. However, in order to improve the utilization rate of the light source, many projector products are equipped with good heat dissipation design, as well as some other means, so that the life of the lamp has a better extension.

The above content reference: Encyclopedia - projector.

1. Plug the power cord into the DC IN port behind the projector.

2. Connect the power adapter, connect the power supply and turn it on.

2、Touch the black key in the middle of the disc to turn it on,You can also use the remote control of accessories,But we need to match the device first,Press and hold the back button and home button on the remote control,The two buttons selected in the picture can be paired with"Hidden polar meterZ4X"Successfully paired。

3. Just press the power button (red button in the upper left corner) to turn on the power.

5. Adjust the screen projection settings first, when the projector is placed at an angle, you need to set the projector, and the stove next to the stove will correct the projected picture, press the button selected in the remote control to set the projection mode, select "Projection settings" to select the projection method, turn on the "projection correction", and select automatic correction.

First of all, under the end of the Teno Xun machine [XGIMI] (XGIMI's official application software), the mobile phone and projector.

Keep it under a LAN and connect according to the tether spine prompts.

The fourth option at the bottom is Apply.