I got a little bit of 502 glue on my fingers, so what can I use to get rid of it?

Mix hot water with laundry detergent, soak your hands in it, and it's enough! ~~

502 glue sticks to the fingers, you can use table salt and warm water, and the cleaning method is as follows:

Preparation: table salt, a bowl of warm water.

1. After the finger is stained with 502 glue, wash it with cold water immediately to make its reputation guess the surface lump.

2. Then soak your fingers in warm water, as shown in the figure below

3. Then sprinkle some jujube deficiency and salt on your hands, as shown in the following stool staring picture:

4. Rub the glue on your hands, as shown in the figure below

5. Finally, rinse your hands again, as shown in the figure below

1. When the hand occupies 502 glue.

When we can use a wet towel to apply it to it, after a while, the 502 glue will become soft, while applying the wet towel to our hands, try to choose a warm or hot wet towel, do not soak it in cold water, so that the effect may be slower.

2. You can also put a basin of warm water, and then put the soap into the warm water to make some soapy water, soak the hands with 502 glue in the water containing soap, and after a while, scrape the 502 glue with your fingernails, and the 502 glue will fall off.

3. In addition, we can also use insulating oil, and the effect is not good, because 502 glue will immediately become soft once it encounters insulating oil, and then we can wash it off directly, but it is more difficult to find the real insulation, and many of the ones on the market are fake, basically not playing any role, so it is not recommended to use this method.

4. Soak in hot water for more than ten minutes, you can also soak 502 glue softly, 502 is on the hand, if not a lot, we can ignore it, every time you take a bath, the friction between the hand and the body will slowly rub off the 502 glue and fall off naturally.

Soak your hands in hot water for a while, you can soak 502 glue softly, and you can remove it.

502 glue is difficult to remove on your hands, teach you a trick, skillfully clean without leaving a trace.

1.Wind Oil Essence Method: Drop some wind oil essence on the sticky finger, wait for absorption after dropping, and gently rub the finger until it is open after 10 seconds.

2.White vinegar method: Prepare a bowl, pour some white vinegar into the bowl, put the sticky fingers into the white vinegar to soak, and gently rub the fingers until they are rubbed apart after 1 minute.

3.Soap method: Prepare a bowl of hot water and a piece of soap, cut some soap into the hot water with scissors, stir the soap until it melts, put the sticky fingers into the soapy water to soak, and gently rub the fingers until they are rubbed apart after 1 minute.

Here's how to quickly wash off the 502 glue on your hands:

1. Apply a wet towel directly to the glue stain, 502 will become soft after a period of time, and then wash it off;

2. Rinse with hot water a few times, repeatedly apply thick soap on the viscose part, don't be in a hurry to rinse, rub and dig back and forth on the viscose part with the soap with your fingernails, and it can be removed after about a few minutes, which is fast and effective.

3. Rinse with cold water first, then add vinegar and soak in warm water, the effect is also very good;

4. You can use gasoline solvent and wash it on your hands.

5. Soak it in hot water, just soak it for 5-10 minutes.

While 502 brings convenience, sometimes it will accidentally stick to things that you don't want to paste, and the ways to remove them are:

1. Use banana water to drop on the glue stain, and at the same time use the old toothbrush to continuously stir and brush, wait for the glue stain to become soft and take off, then rinse with water, brush repeatedly, and brush until it is clean.

Put an absorbent cloth on the back of the garment with glue marks, then apply some white vinegar to the glue marks, and finally scrub it clean with cotton dipped in water.

2. Drop 502 in the same place to melt the original 502, and then quickly wash it off with water, which is very smart!

3. With insulating oil, pour the insulating oil in the transformer on the table, and the 502 glue will quickly become soft and can be rubbed off quickly.

Glue is a kind of resin glue, as long as an organic solvent that dissolves the resin, such as acetone, is used.

However, acetone is toxic if inhaled, so pay attention to how to use it, and you can stuff the adhesive part into the bottle. It is said that if you freeze it in the refrigerator, the glue will fall off, so you can try it first.

5. Stick 502 glue on a small area, as long as you soak it in hot water, if you stain a large area with 502 glue, coat it with acetone, and wait about 5 10 minutes to remove it.

502 glue accidentally dripped on your hands? With a simple move, no matter how powerful the glue is, it can be easily removed.

How to remove 502 glue on your hands?