How can tap water be easily disposed of before fish can be raised?

Due to the chlorine content in tap water, it cannot be used directly to raise fish, so it should be aerated first.

Treatment: Use an open container with water and let stand for 2 to 3 days. It is best to leave it in a sunny place for 2 days.

It should be noted that if you leave it for too long, the water quality will deteriorate, and it is best to use up the water within 2 days. After use, pour out the residual water in the bucket, clean it, and then raise the water again.

Extended information: Precautions for over-temperature and over-water fish farming.

1. The temperature difference should not be too large.

You can first mix out the water of 15 or 6 degrees to soak the fish for about ten minutes, then open the bag, add oxygen, and then enter the 28 degrees fish tank to continue to overheat, so that the fish will be able to fully adapt, that is to say, if the temperature difference is too large, we must do it step by step, beware of the lack of oxygen in the fish.

Second, the temperature difference is not large, and the overtemperature time does not need to be too long.

In the middle of summer, sometimes the temperature difference is not large, there is no need to overheat, the main purpose of overheating the fish, one is to prevent the temperature of the fish tank at home from being too low, causing the fish to catch a cold, and the other is that the temperature is too low during transportation, the temperature at home is too high, and the fish may lack oxygen if they breathe in the short term.

If the difference between indoor and outdoor temperature is not too big, especially when the temperature of the fish tank is two or three degrees higher than the outside, we can appropriately shorten the overheating time, or even there is no need to overheat, not that the longer the temperature time, the better, because most of the ornamental fish are overheated, or sealed in the bag, the longer the time, the higher the risk factor.

3. Ornamental fish purchased in the same city can not be watered.

Now they are all using tap water to raise fish, the tap water in the same city is almost the same in terms of water quality, we can completely omit the step of water, including the fish shop in the same city or the stall, aquarists to buy ornamental fish, there is no need for this, or the water is a result.

Put 2-3 grains of baking soda in a basin of tap water, and you can raise fish after the baking soda is melted. Wherever you sell fish, you can buy it for 2 yuan a pack.

Or put the tap water in the sun for two days and you're ready to go.

The treatment methods of fish farming in tap water are: drying water, trapping water, filtration, and using baking soda. It is best to use up the treated tap water within two days, and after using it, pour out the residual water in the bucket, clean it, and then raise the water again.

1. Basking in water: The easiest way is to expose the water to the sun for a day, which is energy-saving and environmentally friendly, and can also increase the temperature of the water body.

2. Trapped water: In the absence of light, the water can be left naturally for 7-8 days. When the water is trapped, the lid of the container must be open, otherwise the time needs to be appropriately extended.

3. Filtration: You can filter the tap water with activated carbon, which can absorb the dirt in the water, and use it to treat the tap water safely, effectively, and non-toxic.

4. Use baking soda: A small amount of baking soda can be added to tap water to neutralize it with free chlorine in the water.

Fish farming techniques. 1. To choose a suitable fish container, the larger the surface area of the water, the higher the amount of dissolved oxygen in the water, the fish need oxygen, so try to choose a larger container according to the type of fish you choose, do not choose a narrower container that is too small will not be conducive to the oxygen of the fish.

2. Fish grow underwater but also need to adapt to the environment to live longer, such as oxygen, water temperature, water hardness are indispensable, the fish tank should be placed in a well-ventilated, constant temperature room, not in direct sunlight.

3. Change the water frequently, the fish will excrete products, so the water should be changed frequently while raising fish, so as to keep the water clean, and the oxygen level of the fish can be guaranteed at the same time.

Fish farming in the city is basically on tap water, but the following treatments can be done:

1. Dry tap water in the sun for 2-3 days (if possible); You can also put fish in a fish tank directly, but you need to put in a few alum to eliminate chlorine (sold in the fish market).

2. Add quenching and tempering rings and activated carbon in the circulating filtration system (which can remove odor and filter impurities), and then add nitrifying bacteria (you need to put more for the first time); If possible, add coral sand (to adjust the acidity and alkalinity of the water).

Generally, when water is added to the new post, the water will appear muddy for a while, and it will become translucent after a period of time. In addition, the new tank is not good for fish, it is recommended to put some cheap small fish first, and then add good fish after bringing water and tank raising.

Except for swallow fish and pineapple fish, which are trapped in the water for seven days, other species of fish can be trapped in the water for three days. The purpose of trapped water is to soften the water quality and kill bacteria, parasites, and viruses in the water. It is not advisable to treat water by chemical methods.

If you need to use water for fish farming, you can use the method of boiling water to cool.

No, because the water in the tap water pipes is disinfected with chlorine-containing disinfectant, which is harmful to the fish, and the water in the tap pipes is very cold, it is recommended to leave the tap water for a period of time to volatilize the chlorine-containing substances in it.

Can you raise fish directly from tap water? Why? If you want to use tap water to raise fish, how to deal with tap water can not be directly raised fish, because there is chlorine in it will cause harm, if you want to use tap water to raise fish, you must first raise water for more than 2 3 days.

Can you raise fish directly from the tap water at home? The correct way to change the water for fish farming at home is actually very simple.

Fish farming starts with water.

We commonly use household water, all are.

tap water, this water is will.

Natural water is stored, purified and disinfected with chlorine before it becomes the tap water we live in. Although tap water in Japan is much purer than in other countries and can be drunk raw, it is not used to raise fish. Because of the small size of the fish, it is harmful to put it in tap water mixed with chlorine.

Whereas the chlorine contained in tap water is available

Sodium thiosulfate.

It is also called baking soda to neutralize, so the neutralized tap water can be used to raise fish, so sodium thiosulfate (also known as "sea wave") is a treasure for fish farmers. The dosage is 1 to 2 capsules per 10 liters of tap water, as excessive use can be harmful.

In the unreleased fish. Available if you still have time.

washbasin or. Fill a bucket with tap water and let the sun shine for more than 10 hours or about a day to make the chlorine in the tap water disappear, and then put the fish in. This is called the solar irradiation method. But it is also available

Natural water purification. Method: Connect the bucket to the tap water, leave it for 24 hours, and wait for the chlorine of the tap water to disappear before using it.

Most of the tap water can not be used to raise fish, because the amount of chlorine in the tap water is different according to the region, the equivalent of a relatively high situation of fish farming must cause fish death, tap water fish farming treatment method is relatively simple is to get a bucket of oxygen aeration for 24 hours on the line, if you want a block, you can consider using baking soda or fish Lebao fish store to buy.

Fish farming in tap water requires the treatment of chlorine in the water.

Treating chlorine in water, drying water is the most commonly used method and the least costly. It is environmentally friendly, energy-efficient, and almost does not incur costs. By exposing the sun to the sun for one day, the chlorine in the tap water will evaporate, so as to meet the standard of use and reduce the harm to the fish.

Precautions for fish farming in tap water1. Generally, it is enough to change the water once a week, and if the water is dirty quickly, it can be shortened to three or four days. When changing the water, you can't pour out all the water at once, you should keep some of the old water and inject some new water, so that the fish can adapt to the new water more quickly.

2. Properly let the fish see the sun, although they like the sun, but don't bask for too long, after a long time, it is easy to grow excess green algae in the fish tank, which is difficult to remove.

1. Drying trapped water:The simplest way to dispose of tap water is to trap it by drying it. The method of drying is very simple, after connecting the water, you can put it in a sunny place.

Normally, it only takes one day to dry in the summer when the temperature is high, two days in spring and autumn, and more than three days in winter.

2. Oxygenated aeration:It doesn't cost much to dry the trapped water, but it takes a little longer. If water is to be used in a short period of time, it must be done in a faster way, i.e. by oxygenation and aeration.

Put the air head of the oxygen pump in the water and continuously fill it with oxygen for about two hours.

3. Drug dechlorinationDrug dechlorination is usually a method used in aquariums, because they require more water, and it is basically too late to rely on drying, and the amount of aeration cannot be satisfied, so it is necessary to use drugs such as chlorinators to accelerate the volatilization of chlorine, so that tap water can be used to raise fish.

Washing machine trapped water:If you need water urgently or use a large amount of water, you can fill the washing machine with clean water, press the strong wash button to rotate the water at high speed, and it only takes about 5 minutes to remove most of the chlorine.

5. Baking soda:Add a small amount of baking soda to tap water to neutralize it with the free chlorine in the water, generally 5 kg of water should add 2 baking soda crystals the size of rice grains.

Instructions for fish farming water

Cool white boil cannot be used to raise fish. This kind of water is formed after the tap water is heated and cooled, and in the process of heating, the tap water will not only accelerate the volatilization of chlorine, but also accelerate the volatilization of oxygen, so the dissolved oxygen content in the water is very low, and if it is used to raise fish, the fish cannot breathe.

The water for raising fish is not suitable for mineral water, but if you don't want to dry the tap water, you can directly drink the pure water for water exchange, after using the pure water, try to use the same pure water in the future, to prevent the water quality or water temperature of the fish tank from fluctuating too much, affecting the activity of the fish.

The trouble-free way is to install a water filter on the tap water pipe, and connect the fish tank directly to the filtered water pipe, which is not only convenient for adding water, but also does not need to be dried in advance every time the water is changed. This hassle-free approach requires an increase in the budget for tap water filters.

Raw water cannot be used, and raw water is tap water that has not been dried. The temperature of the water in the fish tank is too different. You can choose to change the water once a week, and you don't need to change the water too often.

When changing the water, you should first put the water in the sun for a few days, and the water temperature should be about the same as that in the fish tank.

The tap water is dried for a few days and is at the same temperature as the water in the fish tank. It is best to use old water to raise it, because there are more green algae in old water, which is also a very good auxiliary feed for goldfish. If you find that the color of the old green water has become clear, and there is a lot of green algae at the bottom of the tank, this water should be replaced in time.

In this way, the water is very easy to make the fish sick. The water used to change the fish must be stored for several days, and attention should be paid to how many fish are raised.

You can put it in the sun for a few days, put some salt in it, or buy some water-soaked medicine at the fish market.

Answer 1: Tap water cannot be used directly to raise fish, mainly because tap water contains a certain amount of chlorine, which is harmful to fish. If you want to raise fish in tap water, it is best to dry the tap water in the sun for a few days in advance to remove the chlorine in it, or put sodium thiosulfate in the tap water to neutralize it.

I hope it can help you, and please give me a thumbs up, thank you!

Fish farming to change water to trap water, this concept, basically every novice will receive. The meaning of trapped water is actually to remove residual chlorine, and there are many ways to remove it, and the following four are the most commonly used. 1. Activated carbon and other substances can be used to filter to achieve the purpose of removing residual chlorine.

2. Adding an appropriate amount of sodium thiosulfate (baking soda, commonly known as hypo) can quickly remove residual chlorine. 3. Since residual chlorine is a volatile substance, it will slowly volatilize by itself, so it can be dried and used every other day. If you want to use tap water to raise fish, you can also use a simple method of natural volatilization to remove chlorine, that is, tap water precipitation or leave for 24 hours, or put the fish in the water after exposure to the sun, and try to place the tap water for 2 to 3 days in winter before use.

4. Continuously add air or oxygen to the water, and at the same time add oxygen (that is, what we usually call aeration, aeration removes residual chlorine) and sun exposure will accelerate the evaporation of residual chlorine.