Why do you have 2 hard disks when using DM

Brand machine, right? There's a hidden partition. You use the hidden partition deletion tool in the DOS toolset in the ghost disk to delete the hidden partition.

You're going to have to use a tool to latch the hard drive thoroughly.

Isn't it Chinese? , go to the DOS house for the next first aid plate, all Chinese, dm pm available.

It's pretty simple.

Low-level formatting does not fix physical bad sectors, only shields logical bad sectors.

The working principle of low-level formatting is to make a mark where there are logical bad sectors, and then the head will not read to the places where there are bad sectors. However, the hard disk capacity will also be reduced.

In fact, when installing the system, the system files will start from the 0 magnetic column of the hard disk, which is the first place where the hard disk is read. It can be understood as the very beginning of a tape. Regardless of whether you install it directly or use ghost to install it, if you can't install it, this hard drive is basically of little repair value.

Even if it is repaired, it will still break sooner or later.

It is recommended to change the hard drive, and now the hard drive is not particularly expensive.

DM does not need to be connected to the system, it is used under DOS. Just look elsewhere online. In fact, there is no practical solution to the bad sectors of the hard disk in the low-level format. It's just slowing down the hard drive's time to die.

DM** After that, you have to engrave it into a disk to use,In fact, you don't need to go under the ghost version of the XP disc to replace DM,DM can't be used under XP,To be used under DOS,And it's an all-English interface。 If you can't understand it, use the instant to divide the hard drive into four areas.

What do you call out two plates? Do you refer to C and D? Or do you see two hard drives inside the BIOS?

If you refer to C disk and D disk, this situation is very normal, DM partition is whatever you want to divide yourself, you get 10 disks are all meters problem. )

It seems that there is a hidden partition causing the dn detection error.

Is there a USB flash drive, and see how big that disk displays.

This is because DM uses 2 ways to identify your hard drive. CHS pattern recognition is the normal capacity information that is eliminated to pattern recognition. This is designed to be compatible with older motherboards that use large hard drive stool pins.

Just select the normal 160 capacity jujube bridge tour model for processing.

Take a closer look, it's your disc drive letter.

You can try using other partitioning tools to see if you get the same symptoms.