How to open the routing settings software interface

Enter the web page** Hit This is the router address.

The steps to enter the router settings interface are as follows:

1. Enter the wireless router login address in the browser, log in to the router background management login page, and the default login address of the tp-link router is.

2. After entering the management page, select "Route Settings".

3. Then select "Internet Settings".

4. Select "broadband dial-up Internet access" for Internet access.

5. Then enter the broadband password, which is the password used by the computer to dial up.

6. After Chong Yunxian and the password are entered correctly, click Connect.

It needs to be explained here that the network set up by the router is the local LAN, if you want to set up the router, then you must connect the setting device (computer or mobile phone) with the LAN set up by the router, the desktop computer is generally connected through the LAN interface using the network cable, the laptop and the mobile phone have the function of wireless network sliding, and the wifi network connection can be done through the wifi network, the wifi network of the new router has no password, and the router that has been set up needs to be connected through the password, At this point, don't think about whether you can access the Internet or not, just connect the device to the router first.

Maintenance of the router:

1. Place the router in a relatively ventilated place, and if there is an air conditioner in the room, you can get closer to the air conditioner, and appropriately lower the temperature of the shots.

2. Clean the wireless router, wipe the surface of the router with a damp cloth, and add a heat sink to the surface if necessary (the heat sink is a metal sheet that is easy to conduct heat, but do not block the heat dissipation port). <

The steps to set up the router login portal are as follows:

1: Check the input box.

Enter in the address bar of the browser to enter the router login settings page, and select the first input box.

2: Enter the administrator password.

Enter the administrator password of the router you want in this input box.

3: Confirm the administrator password.

Confirm your administrator password again in the next input box.

4: Click OK.

5: Enter the broadband band.

Enter your home's broadband in the Broadband input box.

6: Enter the broadband password.

Then enter your home's broadband password in the broadband password input box below.

7: Click the Next button.

After entering, click the next button below to enter the wireless setup interface.

8: Enter the name of the wireless network.

In the middle of the wireless settings box, enter your wireless network name and password.

9: Click the OK button.

Click the OK button after the input is completed, so that the login entrance of your router is set up, and you can use the password you set to surf the Internet.

There are two ways to do this:

The first type: 1. You can look at the bottom of the router you bought. The IP address and password will be displayed on it. <>2. Then enter the IP address you see into the address bar of the browser, and then enter the password, and you can enter the settings. <>

Method 21: Right-click the network icon in the lower right corner of the notebook and select "Open Network and Sharing Center". <2. Go to the Network and Sharing Center and select Change Adapter Settings. <3. Find the wireless network, and then double-click the wireless network icon. <>

4. Open "Wi-Fi Status" and select "Details".

5. In the "Details", you can see "IPv4"and IPv4 Default Gateway. Generally, the "IPv4 Default Gateway" is the IP address of the router settings page.

6. Then enter the "IPv4 Default Gateway" address of Xingyuqiao directly into the browser, and it will pop up a router setting interface, enter and set the router administrator password.

7. Enter the password, and then you can enter the settings page of the router. <>