Swagger can be watched there in addition to iQiyi

iQiyi doesn't need money.,It's just that VIP can be the first to watch.,Non-members can also watch updated episodes the next day.,If you want to cache it.,You can watch the *** version.。

Guan Zhu VX Da Ying Entertainment or Promise Promise Reply to the name ** Hope.

Do a good job of thermal insulation protection to prevent secondary damage.

If there are components on the back of the tail plug, if you can clamp it with a clamp, if you can't clamp it, you can use a high-temperature resistant thing to support both ends, and there must be something to touch it near the position of the rear element of the tail plug, otherwise the temperature is high, and the solder melted element will be touched. If there are many components, it is best to attach a layer of copper or aluminum foil to the heat insulation tape. Like SamsungS6The tail plug cable can't be removed,You can warp the tail plug line,Then pad a layer of hard and high-temperature resistant things underneath,For example, a shield,After putting it on, paste a layer of high-temperature tape on it,Then paste a layer of high-temperature copper foil。

This way, other parts will not be damaged by the high temperature. In short, the principle is to control the high temperature as much as possible at the tail plug solder joint, do not expand, and use heat insulation tape or copper foil to isolate everything that may cause damage.

2.After doing a good job of heat insulation, remove the damaged tail plug.

The whirlwind gun is 380 degrees (adjust a suitable temperature by yourself, and the solder can be melted), 1 cm away from the tail plug, and remove the tail plug with tweezers after the solder melts.

3.The tail insert solder joint drags the tin, and the original high-temperature tin is replaced with low-temperature solder.

Soldering iron 380 degrees, end plug solder joint put spot welding oil, pay attention to the soldering oil is very important, be sure to put it, otherwise sometimes it will be very difficult to drag tin. At the same time, the welding oil must not be too much, the most important thing is that the welding oil can not enter the microphone, if the microphone is next to the tail plug, the welding oil must not get in, otherwise the microphone will be broken. After putting the solder oil on, use a soldering iron to add low-temperature solder to the solder joint, and then drag to replace all the high-temperature solder with low-temperature solder.

The purpose of this is to weld the tail plug without using high temperature when the tail plug is welded, so as to prevent the internal melting of the tail plug caused by high temperature, resulting in damage to the tail plug.

4.The tail is plugged into the tin.

Prepare a tail plug, and then put tin on the tail pin, so that the pins that are connected to the motherboard to play a fixed role are not needed.

5.The air gun lowers the temperature, about 300 degrees or 330 degrees (you can adjust a temperature to melt the solder joint), then heat the solder joint part, wait until the solder melts and clamp the tail plug with tweezers, put it at the solder point, after putting it down, the air gun heats up for a few seconds, then press and hold the tail plug to remove the air gun, wait for the solder to solidify, and then use a magnifying glass to observe whether the foot is welded. Note that if there is a hole in the tail plug, it is best to cut a little heat insulation tape on it to cover the hole, and then heat it at the solder joint to prevent the plastic inside the tail plug from melting, so that the welded tail plug is better and more durable.