What should I do if the optical fiber is disconnected and the optical fiber network cable is broken?

Hello, I'm glad to answer for you, I'm sorting out the answer, please wait a moment if you want to consult about the fiber optic line is broken, right?

The steps are as follows: 1. First, insert the optical cable into the tail pipe, and then put the optical cable into the stripper to confirm whether the optical fiber is damaged. 2. Break one of the unused ones, and wipe the optical fiber with the test strip stained with alcohol.

3. Then cut the optical fiber, and remove the optical cable after cutting. 4. Finally, you only need to install the optical cable on the connector and fix the optical cable.

The above is the reply of how to connect after the optical fiber cable is broken, is there anything else I need to consult, I hope I can help you, please give a thumbs up if you are satisfied, I wish you a happy life!

This requires professional technicians to weld, so you can call ** to find professional personnel to use an optical fiber fusion splicer to connect it.

You can make a new connector, or use a special optical fiber fusion machine to connect the broken fiber cable back.

If you know this kind of technology and can operate it, there is no problem in taking it yourself.

Suggestions: 1. Due to the complexity of the production process of optical fiber splicing and cold connectors, corresponding tools are required, if it is not necessary, do not disassemble or fiddle with these things. After the installation is completed, the telecom will explain that these parts cannot be pressed or broken.

And they have all been protected accordingly.

2. Fiber to the home is the ultimate way to broadband, as long as you pay the corresponding fee, you can enjoy the corresponding bandwidth service, just like the highway to your home, whether you want 2 lanes or 4 lanes, it depends on you pay.

If the length of the optical fiber network cable is not enough, it can be lengthened.

There are two ways to connect the network cable. One is to use insulating tape to connect like a wire, and the other is to use a dedicated adapter for docking with a docking head.

Method 1, insulating tape docking method (generally used for connection without network pliers):

Inside the network cable is 8 thin wires of different colors, and after the wires of the same color are connected, they can be wound with insulating tape. However, due to the difference in docking techniques, this method may lead to the phenomenon that the network signal transmission is easily interrupted or the network is frequently disconnected.

Therefore, the following connection is recommended.

Method 2: Use a professional adapter for docking the crystal head (generally used for the connection method with network cable pliers):

1. Go to the computer consumables store to buy a network cable adapter, which is a rectangle, and both ends are crystal head sockets;

2. Use it to add it between the two network cables to make the network cable longer. It is fast, convenient, beautiful and reliable.

1. First of all, confirm whether the line is faulty, whether the optical modem indicator is normal, whether the light attenuation is too large, and whether the broadband is expired.

2. Check whether the optical modem has a routing function, whether the router dialing method is correct, and whether it is a PPPoE or a static IP.

3. Confirm whether the connection between the router and the modem is correct, generally the LAN of the modem is connected to the WAN port of the router.

4. Re-set the router, if the modem comes with the routing function, check whether the modem gateway conflicts with the router gateway, if it is 192 168 1 1, it will cause a conflict and drop the connection.

5. At this time, you need to change the IP address of the router, disconnect the network cable from the router to the optical modem, and log in to the management address of the router. Change the IP address of the router to DHCP and restart the router after saving.

Then connect the WAN port of the router to the LAN cable of the modem.

6. It may also be because the wireless router uses a 2 4G WiFi signal, and there are too many 2 4G wireless routers around, resulting in serious interference from the wireless router 2 4Gwifi, resulting in inability to access the Internet.