PLEASE EVERYONE, I USE THE VERILOG OF QUARTERS II, I DON T KNOW WHERE THE ERROR IS, ASK FOR A HIGH F

You have too many bugs in this program to fix. What function do you want to implement, maybe I can help you, I suggest you read Xia Yuwen's "Verilog Digital System Design Tutorial (Second Edition)", a very good Verilog grammar book.

I just looked at a few lines, and you didn't put the c in the first line.

Look at your error, there's nothing missing'; 'There is no missing @,It is estimated that your ** is either missing an end or a missing "}" or you need to carefully hold the manuscript and check the Duan Annihilation program!

All of the above are correct.

It should be split into two ifs, not elseif

Analyze these sentences of yours.

If maxmax=yelseif max executes the flow is: If max so it should be judged twice.

Remove the elseif, split it into two ifs, and judge it twice.

Try to plug in a single one, it is also possible that the memory is incompatible. There is also a blue screen when the hard disk has bad sectors.

In addition, there are many products on the group IDC network**, which are cheap and have a good reputation.

Check the hardware problem, now the weather is starting to get hot, there is more water vapor in the air, and some hardware in the host may be damp, but it burns out. Take your memory module out and erase it with an eraser, then clean it up with dust.

The landlord's computer is equipped with a pirated version of the deep system XP bar, and it is installed with 360. Bar 360 uninstall.

It could be a virus, let's kill it.

This is either a problem with the hard disk or a problem with the motherboard.

It should be a virus in the computer, try it with some antivirus software.

It is a hardware problem, and it is estimated that it is a poor board contact problem.

Because you don't even have a "drop" sound after turning on the machine, then this is a manifestation of the failure of the machine's boot self-test, which is a "hard injury". According to what you described, it is recommended that you follow the CPU, graphics card (if it is integrated...) Memory, network card (also if it is integrated, it is not necessary) in the order of one by one re-insertion, note that some parts are built-in cooling fans, poor installation of cooling fans or poor contact between the heat sink and the chip will also lead to failure.

If it can't be ruled out, it's a problem with the motherboard, so send it for repair.

Open the cover of the main chassis, unplug the memory module first, wipe the gold finger with your fingers, and then install it, then go to the motherboard coms battery, reinstall it, and boot it OK

Ask the person who repairs the computer and tell you everything!!

Back to the main building, my configuration is similar to yours, the graphics card is HD6850 more than yours Sohuai stove ten watts, my whole machine power is about 340W, the choice is rated 400W power supply, your whole machine power is about 310W, Huntkey Calm King rated power 300W, the maximum peak value of 400W can just meet your needs, but it is better to leave some surplus to choose a power supply with a rated power of 350W, so that it is more stable when the machine is fully loaded for a long time. For example, like the overclocking three x5 colorful version rated at 350W, Antek VP350P, overclocked 3 Q5, and Xianma Chaoying 450 are all rated 350W power supply, **between 220-260. You Mingxian's configuration is medium, special effects run smoothly, and large games are no problem, HD6770 is an upgraded version of HD5770, with stronger performance and lower power consumption.