In the virtual machine, the apache server is set up with RH, and an error occurs during the installa

If you do not use Apache to access the directory by default, you need to disable Selinux to start the Apache service.

Enter http: localhostwindows browser in the address bar of the local firefox browser, and you can enter the IP address in the browser, without the following localhost

The startup and shutdown of Apache is managed through the Apache CTL in the bin directory of its "Installation Directory", which is started with the following command.

apachectl

start

The 80 port of the public Huyan network has to go to the telecom for the record, and it is inaccessible by default if it is not recorded.

If you confirm that port 80 is normal, then send out your apache web host configuration to take a look.

This is a problem of missing dependency packages, first use yum to install gcc autoconf automake make pcre pcre pcre-devel openssl openssl-devel and then configure, make, make install

Permission issues, use sudoconfigure will work.

Don't forget to match the environment variables.

Hope it solves your problem.

Run firewall-config in the rhel7 environment, select public, check httpd for the service, and if you want it to take effect permanently, you need to select permanent in the configuration bar at the top and then check public-->> httpd again.

I've solved it, and I hope I can give you a reference when I write it out.

Enter setup in the terminal, select high(space)=>customize=> for firmware configuration>=, and select eth0 for www(http)=>ok!

By the way, select httpd in the system service, and it's OK.

If it's a command line, you can.

You can use either Putty or Minicom. If you want graphics, use VNC. However, it can be cumbersome to configure.

SSH refers to your protocol, which goes through the command line, and telnet can actually do it. Only your connected machine has the telnet service enabled and allows the connection. Let's not talk about the network configuration.