How to tie the handle piece lanyard and how to tie the rope of the pendant

Updated on vogue 2024-04-21
17 answers
  1. Anonymous users2024-02-08

    Hand handle piece lanyard weaving tutorial:

    Materials: Perforated pendant pendant, red string, scissors, lighter.

    Editing Steps**:

    1.Roast the red rope over a fire and pinch it while it is hot so that it can pass through the holes of the pendant and beads.

    2. The end of the rope passes through the pendant pendant hole together.

    3. Leave the appropriate length of the lashing, such as 1cm.

    4. Open the end of the rope and tie a knot around the other side.

    5. Go around to the other side and tie a knot.

    6. Tie the knot in reverse again.

    7. So that the positive and negative knots are tied until the length of the rope head is left.

    8. The end of the red rope is treated with a lighter.

  2. Anonymous users2024-02-07

    Prepare all the necessary tools: piercing handles, ropes, scissors, and a lighter.

    Step 1: First burn one end of the two ropes with a lighter, then quickly twist it into a brushed shape with your hands, and then use scissors to subtract the excess part, and pay attention to safety when twisting it.

    Step 3: On the way, divide the above two ropes into Figure 1 rope and Figure 2 rope to facilitate everyone's identification. First, put the No. 1 rope on top of the two strands of rope, then the No. 2 rope bypasses the No. 1 rope from above, and then threads the No. 1 rope into the circle from below.

    Step 4: Then pull the two ropes tight, trying to keep the knot as close to the eyelet, but not too tight as well.

    Step 5-6: Place the No. 1 rope on top of the two strands of the front end rope, the No. 2 rope around the top of the No. 1 rope, and then go around the bottom of the two strands of the front end rope from the bottom, and pass through the No. 1 rope loop (Fig. 5, Fig. 6).

    Step 7: After completing the steps of Figure 6, tighten the two strands of rope of the handle piece, and obtain the playing method of the handle piece rope shown in Figure 7.

    Step 8: Repeat steps 3-7 3-4 times to get the beating method shown in Figure 8, and the knotting method here can also increase the number of repetitions according to your needs.

    Step 9: Cut off the excess rope with scissors, then use a lighter to ignite the rope port and press the flat rope port. At this point, the way to play the rope is completed.

  3. Anonymous users2024-02-06

    1.Start by burning the end of the rope with a torch to make it thinner. 2.

    Then pass the two lines through the hole together, leaving a certain distance after passing through. 3.Pick up two threads and tie a knot on them4

    Pick up a thread and go around in a circle5Another line presses over that line and goes around from behind. 6.

    Then it came out of the loop, and then it was tightened. 7.The first buckle is braided, the second buckle is braided in the opposite direction, and so on, until the distance reserved at the beginning is full8

    Finally, just bake it with a lighter.

  4. Anonymous users2024-02-05

    If it's a lanyard, it's really annoying to accumulate, but of course, a lanyard like this must be something specific on the phone. My dish he usually has not used such a lanyard is not very clear, you can go around the left and right around the kind of that kind of way when you were a child to weave things must have been braided, and then, to the comprehensive place over there can be used that method, but also with a circle and a circle, and then this will be more convenient, there are many ways to tie the rope, you can search for the relevant ** on the Internet, I will not repeat the operation, so it is a bit of a waste of network resources.

  5. Anonymous users2024-02-04

    You can go around the left and the right in a circle, and you must have made things up when you were a child, and then, you can use that method to go to the comprehensive place over there, and you can also use the group to circle and circle again, and then it will be more convenient

  6. Anonymous users2024-02-03

    High-grade jade pendant necklace hand-woven necklace rope**Jade jade pendant crystal pendant rope lanyard 2mm high-grade jade pendant neck. Copyright 2013 "Hand Handle Piece Lanyard Tie Method**" Hand Handle Piece Lanyard is cost-effectiveHandbar lanyard evaluation. See more answers

  7. Anonymous users2024-02-02

    The money lanyard should be written down from top to bottom, and there must be an order so that it is relatively firm.

  8. Anonymous users2024-02-01

    Here's how to do it easily and quickly.

  9. Anonymous users2024-01-31

    In fact, the rope is very easy to tie! You can go to Kuaishou, or Douyin, and you can find it by searching for it! It's simple! It's also a beautiful tie!

  10. Anonymous users2024-01-30

    There are no rules. How do you like it? , just look good.

  11. Anonymous users2024-01-29

    Well, how to tie a piece of rope, there are many ways, there are keychains, and there are live buckles that need to be learned by yourself.

  12. Anonymous users2024-01-28

    There are many ways to tie the Internet, you can find it on the Internet and can teach you about the system of the pendant piece.

  13. Anonymous users2024-01-27

    Personally, I think it's okay, it depends on personal preference.

  14. Anonymous users2024-01-26

    Prepare materials: pendant rope, beads, pendant, scissors, lighter.

    Steps:

    1.Usually the pendant rope on the market is generally tied in a knot, and we untie this knot first.

    2.Then make a single section at the middle end of the thick rope.

    3.Then combine the strings, take a lighter and quickly burn a thin thread, as shown in the picture, at the moment when the rope is baked, quickly use the index finger and thumb to make a sharp thread, which is convenient for threading beads.

    4.Then thread the beads and drag them to the very root.

    5.Then pass the rope through the hole of the bead to separate the combined rope.

    6.Wrapping, knotting, I usually wrap 2 turns, a knot on the front and a knot on the back.

    7.The scissors minus one end of the string and stick to the root of the scissors.

    8.Then use a lighter to quickly burn the root end of the rope, the rope melts for a moment and press it with your fingers or a lighter, and the rope is firmly attached to it after it solidifies, and it is completed.

    History of the pendant:

    A jade pendant with no gold, silver or other precious metal inlays, or only a buckle, is called a plain pendant. The plain pendant can be divided into two kinds: cutting flowers and bare bodies.

    Please click Enter a description.

    Pendants have appeared since the Warring States period and even earlier, when men made holes in the teeth of prey beasts such as tigers, bears, and wild boars when hunting, and wore leather ropes on their bodies to show their strength, and women wore red mountain fruits with grass when gathering.

  15. Anonymous users2024-01-25

    The rope of the piece is generally thick and funny, shorter, and the material is made of braided wire for the dismantling and sale of Chinese knots.

    1. Use a lighter to burn the rope first, and before solidifying, quickly twist it with your fingers, and then it is easy to pass through the hole.

    2. Tie it tightly after passing through the hole, cut the rope end with scissors after tying, pay attention to leave a few millimeters in length, and cut one first.

    3. Use a lighter to carefully burn the left rope end, and quickly use your fingers to stick the melted wire end to the rope before solidifying.

    4. Repeat this step to process another thread. Be careful to deal with one before the other to prevent the tied rope from opening.

  16. Anonymous users2024-01-24

    The tutorial on how to weave the rope is as follows:

    Material preparation: perforated pendant pendant, red string, scissors, lighter.

    1. Roast the red rope with fire, and pinch it while it is hot, so that it can pass through the holes of the pendant and beads, as shown in the figure below.

    2. The rope ends pass through the pendant pendant hole together, as shown in the figure below.

    3. Leave the appropriate length of the lashing length, such as 1cm, as shown in the figure below.

    4. Open the end of the rope and tie a knot around the other side, as shown in the figure below.

    5. Go around to the other side and tie a knot, as shown in the figure below.

    6. Tie the knot in reverse again, as shown in the figure below.

    7. In this way, the positive and negative knots are knotted until the length of the rope head is left, and the end of the red rope can be treated with a lighter, as shown in the figure below.

    Handle piece introduction:

    The handle is a common cultural toy shape, which belongs to a more typical plaything, the handle piece, the implication, the object of the hand. There is no fixed regulation on the material and shape of the handle, but the size should be about 8 cm long and 5 cm wide, so that it is easy to grasp with one hand. In terms of carving, it is required to be round and smooth, and the craftsmanship that is too fine is more prickly, and it is inevitable that it will be damaged by bumps and bumps.

    In addition to the traditional jade culture, the material of jade itself is also very suitable as a handle, which is comfortable and looks beautiful.

    The carving style of the handle piece often reflects the auspicious meaning, such as a monkey on the horse, called the Marquis of the horse, and so on. The handle is generally equipped with a lanyard, which can protect the safety of the utensils and avoid falling to the ground; You can also hang the handle piece on your waist as a jade pendant for easy carrying.

    Playing with the handles is not only pleasing to the eye, but also in the process of playing, the movement of the hands and the massage of objects can promote the health of the body. The history of Hetian jade pieces has been very long, before the Ming Dynasty, Hetian jade carving has appeared some small round carving works, but the shape is not round enough, the skills are not simple enough, not suitable for stroking in the palm, rubbing on the face, can only say that the prototype of the piece has begun to take shape.

  17. Anonymous users2024-01-23

    How to weave the pendant rope is as follows:

    1. Cut a jade rope, about 25 cm, and the thickness depends on the size of the pendant hole. Burn one end of the jade rope and thin it with your fingers.

    2. Wear the jade rope on the hole in the pendant, and the length of the front and back ropes should be consistent.

    3. The jade rope is wound around the rope.

    4. Leave about 3mm knotted between the lanyard and the pendant. Pinch the frenulum with your fingers and insert the jade frenulum as follows. The right jade rope is below, the left jade rope is on the top, and the cross is crossed.

    5. Pull the rope tight, the effect is as follows. This knot is a bit loose and you have to pinch it with your fingers.

    6. Tie the second knot in the same way, this knot is the opposite of the first knot, put the jade rope on the right under the jade rope on the left, and cross it.

    7. Tighten the jade rope, the effect is as follows, the rope is relatively tight.

    8. Tie another knot in the direction of the first knot.

    9. Tighten the jade rope.

    10. Look at the overall effect.

    11. Cut the excess jade rope and burn the thread with a lighter.

    12. The silk thread melts and flattens at the fingertips.

    13. A knot is braided.

    14. The effect of compilation.

    Rope means a strip made of two or more strands of cotton, linen, brown and other fibers or wires. The earliest appearance of rope can be traced back tens of thousands of years. When humans began to have the simplest tools, they twisted and twisted grass or tiny twigs into ropes.

    People used it to tie wild beasts, tie thatched huts, make belts to tie straw skirts, ......Later, there was the "knotted rope note", in which knots of knots of the size of a rope were used to record events. That was how people kept things before the birth of writing.

Related questions
13 answers2024-04-21

The left strap is worn from the back to the top, and the right strap is folded up to the left and then down to the right. Lower the left strap and make a circle around the right strap to pass the left strap through the middle gap. Lower the left strap and make a circle around the right strap to pass the left strap through the middle gap.

7 answers2024-04-21

The rod structure is composed of several rods, which is widely used in civil engineering, construction, machinery, ships, water conservancy and other projects. Multi-span statically fixed beams, continuous beams, trusses, rigid frames, arches, suspension structures, grid structures and curved beams are all rod structures. >>>More

6 answers2024-04-21

I fainted. So many questions. How.

The second year of high school. It's early. Take your time. >>>More

5 answers2024-04-21

At present, the Nebula theory is the dominant view. For more information, please refer to the encyclopedia.

6 answers2024-04-21

You look at the safe mode can be in, is to boot and then press F5 to enter the safe mode, but generally COMS will not be infected by the virus, he is written in the motherboard BIOS, and the system has nothing to do with (hehe, exclude CIH) but now they are immune to the virus hardware vendors, you boot up, see the light on your book is on, you press del is the delete key, different manufacturers' BIOS to BIOS setting keys are different, may be F1, F2, del, etc., Go in and set the bootstting boot order, and check the relevant BIOS settings article for specific settings, but they are generally the same.