How to start embroidering cross stitch and how to crochet it?

The hook must be done only after all the cross-stitches have been completed. The drawing will analyze how many strands of thread should be used to hook the edge, 1 usually uses 1 strand of thread when embroidering with 2 strands, and 2 strands of thread when embroidering with 3 strands. The vast majority utilize 1 strand.

The essentials of the thread that begins and ends the first step of hooking are like the essentials of normal embroidery, as shown below. The hook edge can be from left to right, from right to left, from top to bottom, from bottom to top, so that it can go diagonally and diagonally. The specific way to go depends on the planning of the pattern.

The essentials of hooking from left to right should be like this (odd numbers indicate putting the needle under the embroidery cloth, and even numbers indicate piercing the needle);

Huge hook edge:

Cross-stitching with the end of the outline of the edge, will make the embroidery more prominent and beautiful.

Approximate hook edge:

Hook the edge with 1 strand. Walk the stitches in the order of the position of the number marker.

In order not to leave a diagonal line on the reverse side, the following essentials should be followed (odd numbers reflect putting the needle up from under the embroidery cloth, and even numbers reflect piercing the needle);

Some people are fortunate to go on the hook side twice on the hook edge. The first time I walked through all my appearance, then walked back and turned my head to add stability;

In order to refrain from using the hook edge of this essential, it seems that it does not go in a straight line, and it takes more time to walk back than to carefully mediate. The hook must be done only after all the cross-stitches have been completed. The drawing will analyze how many strands of thread should be used to hook the edge, 1 usually uses 1 strand of thread when embroidering with 2 strands, and 2 strands of thread when embroidering with 3 strands.

The vast majority utilize 1 strand. The essentials of the thread that begins and ends the first step of hooking are like the essentials of normal embroidery, as shown below. The hook edge can be from left to right, from right to left, from top to bottom, from bottom to top, so that it can go diagonally and diagonally.

The specific way to go depends on the planning of the pattern. The essentials of hooking from left to right should be like this (odd numbers indicate putting the needle under the embroidery cloth, and even numbers indicate piercing the needle);

Huge hook edge: Cross stitch outlines the edge at the end, which will make the embroidery more prominent and good-looking.

Approximate hook edge: Hook edge with 1 strand. Walk the stitches in the order of the position of the number marker.

In order not to leave a diagonal line on the reverse side, the following essentials should be followed (odd numbers reflect putting the needle up from under the embroidery cloth, and even numbers reflect piercing the needle);

Some people are fortunate to go on the hook side twice on the hook edge. The first time I walked through all my appearance, then walked back and turned my head to add stability;

In order to refrain from using the hook edge of this essential, it seems that it does not go in a straight line, and it takes more time to walk back than to carefully mediate.

If it's a small cross-stitch (e.g. a mobile phone chain), start from the center, and if it's a larger one (e.g. a pillow), go to the place where you bought it. Let the boss help you draw the lattice, and also start embroidering in the center of the painted lattice, corresponding to the picture, but also count to the center of the position, according to the cross-stitch with the picture, the diagram is divided into the lattice, count the lattice and start embroidering, I don't know if it is the answer you want to know.

Determine the approximate grid of what you want to embroider, and then embroider it with the upper left, the lower right, the lower left, and the upper right. As for crocheting, after all the repairs are completed, you can choose to crochet like the normal embroidery method, or you can simply crochet.

Draw the grid first, determine the position you want to embroider (if you embroider a large picture then you had better in the store that sells them to help you draw), the hook is the last to complete, you first get the whole good and then hook, warm reminder: when you start embroidering, you should see how many strands of thread are used, the number of strands of the hooked line and the number of embroidered strands may be different, pay attention.

Start with the center,.

The hook edge starts from top to bottom.

Cross-stitch, of course, is a cross sewn with thread.

According to the distribution of the drawings, and then look at the hook edge of the embroidery needle method to hook, the focus is to embroider according to the position of the hook edge on the drawing, to a needle hook, can not be rushed... In this way, the hook edge will look good...

This hook does not need to be the same on the front and back, as long as the front is hooked. This will save a lot of threads, and I often embroider cross-stitch, so you can ask me if you don't know anything.

Cross-stitch edging method**: Other methods:1

Prepare two needles and thread them with the same color thread each. A needle walks on the front and puts on the line required for hooking; The B needle is on the back side, which is used for fixing, and a single strand can be used. 2. Use a thread, look at the front pattern, walk along the hook line, and after the needle goes down, find a little fix on the back.

Hook edge of cross-stitch pattern.

The general usage of the crochet line is -- two or three strands of thread embroidery body, with one strand of hook edge. Embroider the main body with four strands of thread, hooked with two strands. Six.

The main body is embroidered with strands, and the edge is hooked with three strands. The color of the crochet line is generally the darkest in the main body of embroidery (the area where the hook is to be hooked).

Line. If it is an embroidery card sleeve, the thread itself is thicker, so use a strand of thread embroidery and a strand of thread hook.

Cross-stitch edging must be done after all the cross-stitches have been completed. The cross-stitch drawings will indicate how many strands of thread should be used to hook the edge, and most of them use one strand.

Start and end a line of edging in the same way as a normal embroidery, see 10 and 14 for details.

Cross-stitch hooks can be left to right, right to left, top to bottom, bottom to top, and can even go diagonally. The specific way to go should be based on the design of the cross-stitch pattern. The left-to-right cross-stitch edging method should be like this (odd numbers indicate that the needle is threaded under the cross-stitch cloth, and even numbers indicate that the needle is pricked down).

Some people like to go through the cross-stitch hook twice on the hook route. The first time you walk through all the outlines, the effect is as follows:

Then walk back and fill the gap:

In order to avoid the hook edge using this method not looking straight, pay more attention to adjustment when walking back. As shown in the figure below, 7 means that the needle is threaded under the embroidery cloth, and 8 means that the needle is pricked down. Note that at point 7, the needle should be threaded through the top of the existing line segment 56, and at point 8, the needle should be pierced under the line of line segment 34.

In order to outline the contours and make the work more distinct, embroider the cords along the edges as shown in the picture, or embroider diagonal lines through the four corners. Generally, 1 strand of thread is used when embroidering with 2 strands, and 2 strands of thread are used for embroidery with 3 strands.

Complex hook edges.

Cross-stitch outlines the edge line at the end, which will make the embroidery more prominent and beautiful.

Simple hook edge.

Hook the edge with a strand of wire. Walk the stitches in the order of the position of the number marker.

1 2 stitches: half of the method of embroidering the X pattern. Use it when you want to achieve the same effect as a shadow.

The needle is in the middle of the cloth and in one of the holes, and this stitching method will make the transition in the embroidery more natural. For example, if the edge of the face of the figure or the pattern has a different mark on both sides of the hook that passes through a square, or only one side has a mark, this embroidery method is used in this case.

3 4 pins. After embroidering 1 2 stitches, pierce the needle from the center of the lattice, and 3 or 4 stitches are completed. I use it mainly when I embroider a round shape.

Hook point: A method used when wrapping thread in a knot, embroidering seeds, small dots, etc.

Wrap the needle twice with the thread, then hold the thread tightly (don't let the thread loose) and thread the needle from where it was threaded. Also called the French knot, it is often used in place of beads.

I also have a ** method on my side.

1. Attention should be paid to the consistency of the direction when embroidering. When embroidering the cross, you must pay attention to the direction of the embroidery must be consistent, if the beginning of the embroidery is from top to bottom and from left to right, the whole work must follow the same direction, otherwise the whole work will be destroyed.

Depending on the individual's habits, the direction of the embroidery will also be different, but it is still necessary to follow the consistency. 2. When embroidering, it is necessary to find the position of the center point. Be sure to find the center point of the cloth before starting to embroider, otherwise it may cause the dilemma that the picture cannot be mounted smoothly after the embroidery is completed.

3. Several stitches of cross-stitch. Full needle embroidery, 1 2 needle embroidery, 1 4 needle embroidery, 3 4 needle embroidery, back needle embroidery, long needle embroidery, double grid full needle embroidery, double needle back needle embroidery, double grid long needle embroidery, and several special shapes of stitches. 4. Needles used in cross-stitch.

The needle used in cross-stitch is not the same as the one used in sewing, and the needle used in cross-stitch is a blunt needle with a rounded needle and a large pinhole; For different sizes of cross-stitch ginge, the size of the needle used is also different. 5. The basic --- cross-stitch cloth for cross-stitch. According to different patterns, you can choose different specifications of cross-stitch cloth, including large checkered cloth, medium checkered cloth and small checkered cloth.

After selecting the cloth, select the thread and needle according to the specifications of the cloth.

1. When preparing to hook the edge, use the pen to draw the part that needs to be hooked, and the embroidery process is generally not more than 5 grids. 2. Method 1: The most provincial-saving hook method.

Use the needle and thread to pass from the reverse side to the front, starting from 1, threading from 2 to the back, embroidering a stitch on the reverse side of the 2 position, embroidering a stitch in the nearest horizontal or vertical axis, then threading it from the reverse side of 2 to the front, continuing to start towards the 3 position, and so on. 3. Method 2: positive and negative hook method.

Wear it from the reverse side of 1, then the reverse side of 2, put on the front of 3, pass down the back side of 4, and put on the front of 5. At the end of this round, start with 5 and go to the back of 4, then go to the front of 3, go to the back of 2, and then wear the front of 1 to complete, and the front and back are exactly the same. 4. Method 3:

One side embroidered hook method. Wear from 1 (reverse) to the front, from 1 to the back of 2, from the back of 2 to the front of 3, then from the front of 3 to the back of 2, from the back of 2 to the front of 3, and then from the front of 3 to the back of 4. This method of hooking the edge is completely regular on the front, but the back side will be more messy.

5. Generally, the method of pressing the line is adopted, that is, the remaining lines cross through several horizontal and longitudinal axes. 6. After all the hooks are completed, the embroidery surface should be smoothed, and no wrinkles should appear to ensure the integrity of the embroidery.

If you are satisfied with my service, please give a thumbs up, I wish you a happy life Thank you.

After embroidering other stitches, use 1 strand for the small grid and 2 strands for the medium grid! Follow the drawings and outline the lines on the canvas!

1.When you are ready to hook the edge, first use a pen to draw the line of the part that needs to be hooked. The embroidery process is generally no more than 5 grids.

2.There are three methods of cross-stitch hooking, one is the most thread-saving method, one is the two-sided embroidery method, and the other is the one-sided embroidery method.

3.After the hooking is completed, the remaining lines are knotted, and the method of pressing the line is generally adopted, that is, the remaining lines cross the width and cross through several horizontal and longitudinal axes; After all the hooks are completed, the embroidery surface should be smoothed out without wrinkles, so as to ensure the integrity of the embroidery.