Preparation strategy for cross stitch, basic embroidery method of cross stitch

The basic embroidery method of cross-stitch is divided into: 1. Full needle embroidery method. 2. Half-needle embroidery. 3. Quarter embroidery. 4. Three-quarter embroidery method. 5. Back needle embroidery method. 6. French Junction.

1. Full needle embroidery.

First put on by mesh 1, then by mesh 2, then by mesh 3, then by mesh 4, then by mesh 5, then by mesh 2, then by mesh 3, then by mesh 6, and so on.

2. Half-needle embroidery.

Half needlework is made up of a diagonal line, which is half of the full needlework.

3. Quarter embroidery.

1 4 needle embroidery is made up of half of the diagonal, if you want the remaining part of the edge square to express different colors, you need to have 1 4 needle embroidery to express.

4. Three-quarter embroidery method (1 2x).

3 4 Embroidery is composed of a complete diagonal and half a diagonal line to form the shape of the "human" character.

5. Back needle embroidery method (edge line).

The first needle comes up from mesh 1, and then goes down from mesh 2; The second needle comes up from the mesh 3, then goes down from the mesh 2, and then goes up and back to the mesh 3 from the mesh 4, except for the first needle, each other stitch is returned to the mesh that was originally worn in the way of returning the needle. The return needle is generally used to embroider threads, contours and letters.

6. French Junction.

Hold the needle up to the 1 position and thread it, wrap the thread around the needle, and insert the needle into the 2 position. Hold the end of the thread with your non-embroidery fingers, tighten the knot, and then thread the needle through the fabric and hold the thread until it must be loosened. If you tie a large knot, you can increase the number of strands of the line appropriately, but only wrap it once.

1. The cloth should be flat, the line should be selected with uniform thickness and color, and the feel is soft, so when choosing to buy, you must buy a good brand, such as kec, dec, ks, etc., you can also check the brand ranking of cross-stitch on the Internet, and it is important to choose a good brand!

2. The wallet should be as small as possible, the big one is not good-looking, it is not convenient to hold, and the big one is easy to break the corner of the wallet when it is placed in the bag!

3. A large figure of A4 paper is about 20-100 yuan, depending on whether it is a brand, and the brand is a little more expensive. Two vertical, soft mounting** is about 50-200 yuan, depending on the quality of the model and the quality of the mounting card.

4. The top and bottom through the repair is the highest flatness, but it is very slow, in fact, it doesn't matter how you embroider, because it will be ironed when framing, so it will generally be very smooth!

1. CT refers to the specification of the cloth, that is, the size of the grid, the common ones are 14ct, 11ct, 9ct, and the smaller the number, the larger each is. The R line is a brand, as well as DMC, RS and the like.

2. If you embroider the wallet, you will use plastic mesh cloth, and there are also designed patterns, and there are thousands of patterns on the market, all of which are very good-looking, which depends on the preferences of lz.

3. The size of the A4 picture also depends on what the picture is, how many needles are needed, as for the time, it also depends on the speed of LZ's embroidery, as for the framing, it depends on what material to use, and the ** of various materials is also different, this can not be said.

4. The most basic thing about cross-stitch is to tie the cross cross, and only use some French knots and the like when needed.

As for the software, it is not difficult, as long as you get started, it is easy to use.

Judging from the problem of lz, the understanding of cross-stitch should not be deep, it is recommended to buy a kit to try it first, and then learn the software when you are familiar with it, because you must at least have a certain understanding of cross-stitch with software.

Cross-stitch cloth is divided into pure cotton and polyester cotton, as well as plastic and others, the general cotton thickened is superior, the thread is also like this, the thread is divided into Egyptian cotton and ordinary cotton and polyester cotton and silk thread, among which Egyptian long-staple cotton is superior, in addition to its color system is also critical, generally ANC and DMC is the international standard color, R line is a domestic long-staple thread, which is also superior. The 9ct, 11ct, and 14ct are the size of the lattice of the cloth, which are large, medium, and small.

When embroidering, press the thread on the front, the direction of the thread should be consistent, there are no wrong needles and missing needles, and the back is either horizontal or vertical.

That's all.

First of all, choose a darker thread to start embroidering, and choose another color after embroidery, so as to ensure that it is clean and does not need to change the thread back and forth. But don't make a mistake in embroidering the lattice!

Fold the four corners of the embroidery paper in half, and the four corners of the embroidery cloth are also folded in half, and find the center point to mark.

The first floor is too humorous, and it is true, and to put it simply, it is all crossed. Wrong is right, right is wrong!

What is the correct way to embroider cross-stitch? 1.Thread the thread through the lower left hole of the lattice to be embroidered. 2.Thread the needle into the diagonal hole and out from the horizontal left side. For complete steps, please **this article**.

Precautions: 1. Keep your hands clean when embroidering, and avoid ink and other items staining within the scope of embroidery. 2. Consistency of direction.

If the embroidery is top-down and left-to-right, the orientation consistency must always be followed. 3. Find the center point. When embroidering, first find out the position of the center point of the cloth before starting to embroider.

4. In the case of horizontal continuity, it is necessary to embroider 1 2 stitches to the right and then return. The direction of the line is consistent. 5. In the case of longitudinal continuity, each grid should be embroidered into the shape of a cross before it can be embroidered downward, and it is not lazy.

6. When closing the needle, do not knot the thread from beginning to end of the cross-stitch, empty the thread on the back and press each other, pay attention to the thread not to mess up. 7. Hook edge. The purpose of outlining the outline is to make the work more distinct and prominent, generally with 2 strands of thread when embroidering, with 1 strand of thread, with 3 strands of thread when embroidering with 2 strands of thread to hook the edge.

8. When the cross-stitch work is dirty, you can use neutral detergent and cold or warm water to wash the work by hand alone, soak it for a few minutes, do not rub or squeeze, and then take out the work and put it on a clean, white thick towel, roll it up and press off the excess water and air dry it for a few hours, and then add a white cushion cloth up and down to clamp the cross-stitch cloth and iron it flat. Pay attention to adjust the temperature to prevent ironing. If it is not framed, it can be clipped to a book or other flat place to prevent the work from crumpling or staining again!

Tips to increase the speed of cross-stitching:1First draw a 10*10 grid on the embroidery cloth with a water-dissolved pen, and the most obvious grids on the embroidery drawing are one to, and use this as a reference when embroidering, so as to avoid counting the wrong grid or looking at the serial.

2.with an embroidery stand. If you don't have an embroidery frame, you don't have to sell it at any cost.

You can use large cardboard to hollow out the middle. The embroidered cloth is fixed around the cardboard with clips, and the cardboard is held by hand when embroidering, or it can be placed on the lap, one hand on the top and the other on the bottom, two hands embroider much faster than one hand. 3.

It is better not to tie knots when embroidering cross-stitch.

I embroider it by the method of thread embedding.

It is repeated on the back of the embroidered cloth.

In this way, the effect of framing is relatively flat.

When embroidering, be sure to do this in the same direction, so that there is no difference in the color of the thread.

Embroidery Tips:

Prepare the embroidery thread: first cut the embroidery thread into 1 meter segments, which is the most convenient length for embroidery, and this length is not easy to make the cotton thread fluffy.

Then, pull out two of the six strands of the embroidery thread, taking care to hold one strand on each of the fingers of both hands, and gently pull the embroidery thread apart from the opposite direction.

If in embroidery, the thread is tightly entangled, you can let go of the needle in your hand and let it hang in the air, and the thread will untie automatically. Tightly wound embroidery threads can become thinner, making it difficult to properly cover the fabric.

When you start working with the first embroidery thread, leave a 1cm long thread tail behind the fabric. Press and hold the end of the thread with your finger and start embroidering. When embroidering, the end of the thread is fixed with a needle step.

Once you have finished an embroidery thread, simply thread a few stitches behind the fabric and cut off the remaining segments. When using a new embroidery thread, thread the needle and thread through the bottom of a few stitch steps near the place where the embroidery is restarted.

Note: The color shown in the picture does not necessarily represent the real embroidery thread color, please use the thread according to the thread number shown in the pattern in the table.

The embroidery thread is usually six strands, embroidery is generally used with two strands, hook edge with one strand, if there is a special amount, please follow the description of the thread in the figure.

In an embroidery, the direction of the embroidery should always be consistent.

Never tie the embroidery thread in a knot!

When starting the needle, determine the center position of the cloth.

After all the patterns are embroidered, wash them gently with warm water, do not rub them, and after drying, they are ironed with an iron from the back.

1. About needle starting and receiving.

1. Take a 1-meter-long embroidery thread and fold it in half, and use the folded end to thread the needle, so that a ring is left, and you don't need to collect the needle when embroidering this thread, and then take a thread to pass through the ring left out, and then fold the needle in half to continue embroidering. Although the speed is not much improved, it can save the needle starting and retracting once, which is convenient and thread-saving, so it is recommended.

2. You can also put the threaded needle through the embroidery thread on the back of the needle when starting the needle, and hide the thread head under other embroidery lines, generally five or six needles, when embroidering this thread, also use the same method to hide the thread, so that the back of the embroidery surface is clean and flat, and the thread head is also very stable.

2. Tips.

1. First less and then more: embroider less first, and then fill more.

2. Embroider the outline first: To deal with the large color, embroider the outline first, and then fill it in.

3. Multi-needle simultaneous operation: This method can be used to deal with patterns that only have two or three colors but need to change needles frequently. It is to wear these colors with needles respectively, which color should be embroidered when not changing the thread but directly changing the needle of this color, it should be noted that the needle should be pulled and placed on the top of the embroidery cloth to avoid mixing threads.

How to calculate the amount of cross-stitch thread.

Generally, 14ct 2 strands of 1 meter can be embroidered about 280-300 grids, 11ct 3 strands of 1 meter can be embroidered 140-150 grids, each person's tightness of the thread is not the same, and the amount of each person's thread is not the same, and if there is a jump in the amount of the grid, it will be more.

14ct about 250-300 squares with a one-meter line.

Two strands embroidered 11ct

3 strands 9ct 120-1604 drums.

You also have to learn to use flexibly, this is just a reference, for example, the hook is more expensive to line up, to match more appropriately, to give half more jumpers, to change color frequently with more lines, and so on.

In short, it is necessary to consider it together with reality, or divide the above standard by 2 to definitely pull enough.

Some ways and tricks to increase the speed of cross-stitch.

I don't know if the sisters like me like some methods and tips for increasing the speed of cross-stitch, but can't stand the speed of cross-stitch. I studied cross-stitch carefully and found some ways to increase the speed of cross-stitch, and now I will share it with my sisters.

1. Needle down. 2. Go down. 3. Pull the line.

4. The needle comes up. 5. Get your hands on it. 6. Pull the line.

Sisters, don't bother me, it's useful to talk so long-winded.