What should I do if the router is wired and can access the Internet and wireless

How does Wired access the Internet? If the cable is a broadband connection, the Internet is plugged in the wrong wire, and the router becomes a switch. If you can go to the Internet when you turn it on, wireless can't be used, there are two situations, one is the problem of router settings, reset the wireless SSID, fix a channel, and add the password to find the rescue version of the Baomo on it, and the other if you can't find this wireless signal, it may be that the router wireless function is not turned on, turn on the router wireless function, turn on the SSID broadcast, and then set the router wireless parameters above, save and restart the route.

Is it that you can't search infinity directly, or can't you find it?

If you can't find it, it may be that the password is wrong, the case is not switched, and the keypad is not open. Or if there is a signal but there is a yellow exclamation mark in the lower right corner, double-click the window that opens the link, right-click to select the status, select Diagnostic, and the computer system will automatically fix it for you.

In the process of using wireless in ordinary times, you may encounter the wired use of the router is normal, but the wireless cannot be connected to the network, and the next guide will teach you how to solve it.

01 First of all, we need to check whether we have changed the wifi password, which causes the wireless network to be unable to access the Internet, or reset the wifi password.

02 Another simple way is to unplug the router and then plug it back in after a minute, which is a better way for beginners.

03 If it still doesn't work, check whether the wireless function of the router is normal, which can generally be seen in the management interface of the router.

04 If none of the above methods work, you can only reset the router, aim the reset hole behind the router with a needle for more than 10 seconds, and reset the router to solve the problem.

It is likely that you have not set it up, the router needs to be turned on and the user is set up, and the computer must be set up with a wireless connection.

Considering the connection, the settings are incorrect. The router needs to plug the incoming network cable into the W port of the router and then set up the router to work normally.

Use the method of elimination.

First of all, don't use routing, directly connect to broadband, if successful, it means that there is a problem with routing, but the wireless module is not broken, it is a matter of time before it can not be used, if it still can't, you can find another network cable, cheaper, test it, if it doesn't work... I really don't know what's going on with this.

By the way, there is another possibility, what type of broadband? If it's fiber-optic, it does happen.

Did you find the answer, encountered the same problem, call for help.

Your port is restricted, and you need to change the IP settings of your non-wired router.

Check the cable that connects the router to the computer, plug it back in and try it out, oh there should be no major problem, good luck.

The other end of the network cable is plugged in incorrectly, right? Check if it's bad to the network TV jack.