The computer makes a tick sound 100, and the computer makes a tick sound

Explain the motherboard alarm sound in detail.

tag: computer.

Explain the motherboard alarm sound in detail.

There is an alarm sound when the motherboard is turned on, indicating that there is a problem with the self-test. The alarm sound is set by the BIOS on the motherboard.

There are two types of BIOS, which are AMI and Award. Most motherboards are AWARD BIOS.

1.The BIOS of the award is set to:

A long and constant sound: the memory module is not plugged in tightly.

Repeated, short ring: There is a problem with the power supply.

No sound and no display: There may be a problem with the power supply.

One short: the system starts normally.

Two shorts: The CMOS settings are incorrect and need to be set again.

One long and one short: Memory or motherboard error.

One long and two short: The monitor or graphics card is wrong.

One long and three short: The keyboard controller is wrong.

One long and nine short: Flash RAM or EPROM error of the motherboard BIOS.

2.The BIOS of the AMI is set to:

1. Short: Memory refresh failure.

Two shorts: The memory ECC verification error is incorrect.

3. Short: The basic memory check of the system fails.

Four short: The system clock is wrong.

Five short: There is an error in the CPU.

Six short: The keyboard controller is wrong.

Seven short: The real mode of the system is wrong.

Eight short: Displays a memory error.

Nine short: BIOS chip inspection error.

One long and three short: memory error.

One long and eight short: the monitor data cable or graphics card is not plugged in.

3.Phoenix's BIOS self-test ringing and its significance1 Short The system boots up normally.

1 Short 1 Short 1 Short System power-up initialization failed.

1 short, 1 short, 2 short, motherboard error.

1 short, 1 short, 3 short, CMOS or battery failure.

1 Short 1 Short 4 Short ROM BIOS verification error.

1 Short 2 Short 1 Short System clock error.

1 Short 2 Short 2 Short DMA initialization failed.

1 Short 2 Short 3 Short DMA page register error.

1 Short 3 Short 1 Short RAM refresh error.

1 Short 3 Short 2 Short Basic memory error.

1 Short 4 Short 1 Short Basic memory address line error.

1 short, 4 short, 2 short, basic memory verification error.

1 Short 4 Short 3 Short EISA sequencer error.

1 Short 4 Short 4 Short EISA NMI port error.

2 Short 1 Short 1 Short First 64k basic memory error.

3 Short 1 Short 1 Short DMA register error.

3 Short 1 Short 2 Short Main DMA register error.

3 Short 1 Short 3 Short The main interrupt handles register errors.

3 Short 1 Short 4 Short Handle register errors from interrupts.

3 Short 2 Short 4 Short Keyboard controller error.

3 Short 1 Short 3 Short The main interrupt handles register errors.

3 Short 4 Short 2 Short Error is displayed.

3 Short 4 Short 3 Short Clock error.

4 Short 2 Short 2 Short Shutdown error.

4 Short 2 Short 3 Short A20 Door Error.

4 Short 2 Short 4 Short Protected Mode Interrupt Error.

4 Short 3 Short 1 Short Memory error.

4 Short 3 Short 3 Short Clock 2 Error.

Hehe, it may be that there is a problem with the optimization master, and some of the functions of the optimization master are optimized too hard, and the system can't stand it. It's okay to use him to clean up the system garbage. It's best not to use systematic optimizations such as changing the speed of the internet and shutting down the service.

There's no way around it, because no one knows how the optimizer optimizes, so you have to reinstall the system.

In many cases, System Restore is not used, and it may not have anything to do with Optimizer.

It is recommended to use 360 security guards to take a look, patch the loopholes, and look at the Trojan.

Internet speed drops are generally caused by Trojans.

The optimization master doesn't need it, if there is still a dripping sound, then find a way.

It may be caused by a hardware error, and the optimizer sometimes messes up these things, so if it really doesn't work, you can try reinstalling the system.

Plug the memory module back in and out first, and then try it.

No, discharge the battery on the motherboard, (remove the battery, and put it back on later.) If it doesn't work, you can take a look at plugging and unplugging your network card, and then reinstall the network card driver. I don't know what you've optimized with Optimizer.

If the above steps don't work, you probably have to reinstall the system.

It's okay, don't use Optimizer to remake the system, I guess the project there is disabled by Optimizer

Computer Didi Sound:

1. Two short beeps: CMOS is set incorrectly.

2. One long and one short: the memory or motherboard is wrong.

3. One long and two short: the display or graphics card is wrong.

4. One long and three short: the keyboard controller is wrong.

5. One long and nine short: the motherboard flash memory is wrong.

6. Constant ringing: the memory is not plugged in or the chip is damaged.

7. Non-stop short ring: power failure.

8. Non-stopping: The monitor is not connected to the graphics card.

ami: 1. A short sound: The memory refresh failed.

2. Two short sounds: memory verification error.

3. Three short sounds: The system basic memory self-test fails.

4. Four short rings: The system clock is wrong.

5. Five short sounds: CPU error.

6. Six short sounds: keyboard error.

7. Seven short sounds: The real mode of the system is wrong and cannot enter the protection mode.

8. Eight short sounds: video memory error.

9. Nine short sounds: The motherboard flash memory is wrong.

10. One long and three short: memory error.

11. One long and eight short: poor contact between the display data cable or the graphics card.

It could be one of the following reasons:

1.The computer has a malfunction or error message, which needs to be operated or handled by the user.

2.The PC detects a new hardware device or external device connection and requires user confirmation or driver installation.

3.The computer receives a new message, message, or alert that the user needs to review or act on.

4.The computer is low or the battery is low and the user needs to charge or replace the battery.

5.After the computer system update or software update is completed, the user needs to restart the computer.

If the sound of dripping is persistent or frequent, it is recommended to check the computer for problems such as malfunctions or virus infections.

Hello, this is the alarm sound, if the computer can not start normally, the alarm sound of self-test can not be checked, it is recommended 1Turn off the power off, take down the memory and erase the gold finger part with an eraser. 2.

Press the power button 5-6 times quickly and wait for 2 minutes3Plug the memory back in, and then power on to try to turn it on. 4.

If it still doesn't work after that, get off the hard disk, turn it on again to see if it can enter the BIOS or if it can light up, if it can't be the motherboard or memory problem, you need to send it for repair.

Summary. If there is a problem with the computer hardware, it will give you an audible alarm to tell you the problem.

1 Short: The system starts normally. This is something we hear every day and it also shows that there is nothing wrong with the machine.

2 Short: General error, please go to CMOS setup and reset the incorrect option.

1 Long 1 Short: There is an error with the RAM or motherboard. Try to change the memory, if it still doesn't work, you have to change the motherboard.

1 Long 2 Short: Wrong monitor or graphics card.

1 Long 3 Short: Keyboard controller error. Check the motherboard.

1 Long 9 Short: Motherboard flash RAM or EPROM error, BIOS corruption. Try a different block of flash ram.

Constant ringing (long sound): The memory module is not plugged in tightly or damaged. If it still doesn't work, you can only replace a memory module.

Ringing: The power supply and monitor are not properly connected to the graphics card. Check all the plugs.

Repeated short rings: Power supply issues.

No sound, no display: Power issue.

When using the computer, the computer will make a ticking sound from time to time.

This question is up to me, it takes a little time to type, so please be patient.

If there is a problem with the computer hardware, it will send out an audible alarm to tell you that the problem 1 is short: the system starts normally. This is something we hear every day and it also shows that there is nothing wrong with the machine.

2 Short: General error, please go to CMOS setup and reset the incorrect option. 1 long and 1 short:

There was an error with the RAM or motherboard. Try to change the memory, if it still doesn't work, you have to change the motherboard. 1 long and 2 short:

Wrong monitor or display card. 1 Long 3 Short: Keyboard controller error.

Check the motherboard. 1 Long 9 Short: Motherboard flash RAM or EPROM error, BIOS corruption.

Try a different block of flash ram. Constant ringing (long sound): The memory module is not plugged in tightly or damaged.

If it still doesn't work, you can only replace a memory module. Ringing: The power supply and monitor are not properly connected to the graphics card.

Check all the plugs. Repeated short rings: Power supply issues.

No sound, no display: Power issue.

It's that the computer can't turn on before.,P key can't be used.,Take it to repair it and turn it on.,But the P key is still not repaired.,The store suggested that I change a keyboard.,But I didn't change it.,Later, the P key can be used by itself.,But since then, as long as you use the computer.,Occasionally, there will be a dripping sound.,The computer can be used properly.。

However, sometimes it will not refresh after booting, and you have to press the esc key to refresh.

Okay, wait a minute, pro.

Then sometimes the word or excel menu bar will pop up a deepened gray and black word, at that time it can't, but also press esc to use it normally, just like sometimes you can't refresh it when you click the mouse on boot, and you have to press the esc key to refresh.

Check whether the CPU fan is properly connected.

How to check it<>

I don't understand.

How to check it<>

I don't understand.

Can you send me a picture to see? Check it out from that place.

Wait a minute, pro.

This is because the memory module is dusty, and it is recommended that users wipe the memory module.

The computer tick is a computer self-test alarm, and it can generally be determined which part of the computer is faulty according to the length and interval of the sound.

To see if the user's host is connected to the power supply is grounded, if the host is not grounded, there is a power supply on the host, it is easy to generate static electricity, the solution is to change a grounded power supply, try, to see if it can be turned on. If it still can't solve the problem, then it may be that the power supply of the host is broken, and it must be replaced with a power supply.

The main unit refers to the main part of the computer other than the input and output equipment. It is also used to place the mainframe of the main board and other major components. This typically includes the CPU, memory, motherboard, hard drive, optical drive, power supply, chassis, cooling system, and other input/output controllers and interfaces.

In network technology, it is about the terminal equipment that sends and receives information.

1. The sound of the computer making a drop is the reason for the card slot. Solution: Turn off the power supply of the chassis or unplug the power cord of the chassis, and open the side cover of the chassis.

2. Before unplugging and unplugging the memory module, it is best to let go of the static electricity on the body, touch the floor or wall, if possible, you can wear anti-static gloves to press the buckles on both sides of the memory module, unplug the memory module, and wipe the "gold finger" of the memory module with an eraser, the gold finger is very sharp, be careful not to hurt your hand.

3. Reinstall the memory module back into the card slot, reboot the computer, and see if the problem is solved. When you plug the memory module back in, you will hear a "stuck" sound, which is normal. If there is still a ticking sound, switch to another card slot and turn it on again.

It could be one of the following reasons:

1.Hardware failure: The hardware inside the computer fails, such as hard drives, fans, power supplies, etc., causing the computer to emit a dripping sound.

3.Virus infection: The computer is infected by a virus, and the virus will make a dripping sound as a warning or prompt.

If your computer makes a beeping sound, it's a good idea to check if the hardware is working and then check for system prompts and software issues. If the problem persists, we recommend that you do something like antivirus or reinstall the system.