Turn on the computer and make 5 dripping sounds, and the computer can t turn on the machine and beep

The legendary motherboard is loose??? The estimation is this

The memory module is oxidized by the contact chip, resulting in bad contact, or the memory module is bad, you can change it to a new one and try it out.

The system has failed. Then you just go and get the system disk, and just install or repair it.

One long and two short is the graphics card, five rings? You can reinstall the memory or CPU, you can press it.

Hello dear, the situation of 5 consecutive beeps usually indicates that there is a problem with the hardware. Specifically, it is loose memory modules, graphics card failures, CPU failures, etc. To fix this issue, here are a few things you can try:

1.Check whether the memory module is plugged in tightly: If the memory module is not plugged in tightly or is loosened when the computer is turned on, the computer will not start properly.

Therefore, you will need to open your computer's motherboard to check and reseat the memory modules. 2.Check if the graphics card is healthy:

The power and brother brain can't display the picture, it's a graphics card failure. You can remove the graphics card, wipe the dust off the gold finger with a clean cloth, and reinstall it on the motherboard. 3.

Check if there is a problem with the CPU cooler: If you use the computer for a long time, the CPU cooler may malfunction, causing the computer to not boot properly. You can open the motherboard of your computer to check for damage to the radiator and replace it if it is damaged.

4.Replace the power supply: The above methods are ineffective, and the computer cannot be turned on normally due to the failure of the power supply.

You'll need to replace it with a new power supply**. In conclusion, the situation of 5 consecutive beeps requires you to carefully check and rule out the problem before you can solve the problem. If you are not sure how to do it or cannot solve the problem, please contact a professional for repair in time.

If it is said that it is a continuous sound of "Didi", it is a common problem with the power supply of the main unit.

However, sometimes when the output voltage of the power supply is low, the host does not alarm, but the hard disk is lost, the reading performance of the optical drive is poor, and it often crashes.

When these situations occur, it is best to check whether the output of each voltage is low, when +5V and +12V are less than 10%, the above problems will occur from time to time. Because the power supply has a voltage output, it is often mistaken for a problem with the motherboard or the hard disk, and a lot of time is wasted.

When the DC component is reduced, the high-frequency AC component in the power supply increases, which will interfere with the normal operation of the motherboard, resulting in system instability, and it is easy to crash or blue screen.

If it is said to be "Tick." Backbite. 's continuous, spaced long tones.

It is the sound of memory alarm, generally due to loose memory, poor contact between the gold finger of the memory and the memory slot, oxidation of the gold finger of the memory, and a fault of a chip in the memory.

Summary. Hello dear, the computer beeps 5 times in a row, which usually indicates that there is a hardware failure or a hardware connection problem. This situation is generally related to the motherboard or memory, and the possible reasons are as follows:

1.Memory failure: When the computer starts, if the memory fails, the computer emits a series of beeping sounds.

In this case, you can try to reseat the memory module or replace it with a new one. 2.Motherboard failure:

If the computer's motherboard fails, it will also cause the computer to emit a continuous dripping sound. In this case, you will need to replace the motherboard with a new one. 3.

Hardware connection issues: Sometimes a poor internal hardware connection can cause the computer to not boot, so try plugging the hardware devices back in and out to make sure they are connected well. It is recommended that you first try to reseat the memory module or replace it with a new one, and if the problem persists, it is recommended to contact a professional or computer repair shop for repair.

Hello dear, the computer beeps 5 times in a row, which usually indicates that there is a hardware failure or a hardware connection problem. This situation is generally related to the motherboard or memory, and the possible reasons are as follows:1

Memory failure: When the computer starts, if the memory fails, the computer emits a series of beeping sounds. In this case, you can try to reseat the memory module or replace it with a new one.

2.Motherboard failure: If the computer's motherboard fails, it will also cause the computer to emit a continuous dripping sound.

In this case, you will need to replace the motherboard with a new one. 3.Hardware connection issues:

Sometimes a poor hardware connection inside the computer can also cause the computer to not boot, you can try to plug the hardware devices back in to make sure they are connected well. It is recommended that you try to re-insert the memory module or replace it with a new one, and if the problem persists, it is recommended to contact a professional or computer repair shop for repair.

There is no problem with the memory, and the five consecutive drops are made every two or three seconds.

Dear, hello, if there is no problem with the memory, it may be that the motherboard is faulty if the branch slag continues to drip 5 times. It is recommended to try the following search steps:1

Disconnect your computer from power and unplug all external devices from your computer. 2.Open the computer case and inspect the computer motherboard for visible physical damage or burn marks.

3.Check that the power supply** plug on your computer's motherboard is plugged in tightly. 4.

Unplug and plug all the plugs from your computer's motherboard. If the above steps do not solve the problem, it is recommended to contact a professional computer maintenance personnel to check whether the computer socks need to be replaced.

Take Lenovo G40-70, Win10 system as an example, the solution of the computer startup alarm five beeps Dididi:

1. Turn off the computer first, open the computer case, find the memory module and clean it.

2. You can use the eraser to wipe the gold finger of the memory module, and after wiping, insert the memory module back into the memory card slot of the motherboard.

3. Finally, turn on the power supply, restart the computer, if you can enter the operating system normally, it means that the fault has been removed.

This method works with most models of computers under the Lenovo brand.

If the computer beeps for a short sound, it may be that the memory refresh has failed, and the memory is seriously damaged and the memory needs to be replaced.

If the computer beeps twice, it may be a memory parity error, you can go to the CMOS settings, turn off the memory parity parity option, and set it to disabled.

If the computer beeps three short sounds, the basic memory check of the system fails, and the memory needs to be replaced.

The computer rings four short sounds, the system clock is wrong, and the motherboard needs to be repaired or replaced.

The reason for the five beeps of the computer start-up alarm may be that there is a problem with the processor (CPU).