-
The sound of the main computer is because the memory is not plugged in properly or has been oxidized.
Solution: 1. Wipe the memory module with an eraser and check whether the gold finger of the memory module has any burnt marks. Replace the memory in the slot.
2. Check the capacitors and resistors on the motherboard to see if the capacitors are bulging, whether there is a burning smell on the motherboard, and clean up the dust on the motherboard.
3. Remove the CPU fan, power on and turn on, test whether the CPU has a temperature change by hand, if not, the CPU is not working, either the motherboard is broken, or the CPU is not plugged in properly, and the CPU is re-plugged.
4. Power supply problem, although the power supply is powered on, but the motherboard can not work normally, replace the power supply and try it.
5. If the display card is loose or oxidized, the keyboard light will be on, the screen will not be displayed, wipe the gold finger of the graphics card with an eraser, and check whether the capacitance on the graphics card is bulging.
6. Minimize the test method, only leave the power supply, motherboard, CPU, memory, graphics card, keyboard, monitor, unplug all the wires on the rest of the motherboard, use a screw knife to short the switch pins, if normal, add the rest of the hardware, piece by piece, until the cause of the problem is found.
-
There is a beeping sound when the boot is turned on, which means that there is a hardware abnormality or BIOS setting error at this time, you can try:
1) Restore the BIOS default, clear the CMOS battery.
2) Plug in and out the memory and graphics card again after shutting down.
3) According to the length, interval and frequency of the alarm sound, check the fault source according to the motherboard manual.
-
After powering on 1 short: the system starts normally. This shows that there is nothing wrong with the machine.
2 Short: Regular error. Please go to the CMOS installation and reset the incorrect options.
1 long and 1 short: There is an error in the memory or motherboard.
1 long and 2 short: The display or graphics card is wrong.
One long and three short: The keyboard controller is wrong. Check the motherboard.
1 long and 9 short: The motherboard BIOS chip is wrong, and the BIOS is damaged. BIOS chip.
Long ringing: The memory module is not checked and damaged. Reinsert the memory module. or replace the memory module.
Look at what type of machine you have to find faults.
-
Summary. Hello dear, happy to answer your <>
The sound of a computer is usually due to a hardware problem or an error in the operating system. Here are some possible causes and workarounds: Memory Failure:
A long, continuous beep from your computer's main computer may be a memory problem. You can try reinserting or replacing the memory module. Graphics card failure:
A long and two short beeps or one long and three short beeps from the main computer may indicate a problem with the graphics card. You can try to reseat the graphics card or replace it. CPU Failure:
A long and four short beep sound from the computer's main computer may be a problem with the CPU. You can try plugging the CPU back in or replacing it. Hard drive failure:
When your computer starts, it may be a problem with your hard drive. You can try to use a hard drive detection tool to detect the hard drive and replace the bad hard drive.
What's going on with the dripping sound coming from the computer host.
How to fix this.
Hello dear, happy to answer your <>
The sound of a computer is usually due to a hardware problem or an error in the operating system. Here are some possible causes and workarounds: Memory Failure:
A long, continuous beep from your computer's main computer may be a memory problem. You can try reinserting or replacing the memory module. Graphics card failure:
A long and two short beeps or one long and three short beeps from the main computer may indicate a problem with the graphics card. You can try to reseat the graphics card or replace it. CPU Failure:
A long and four short beep sound from the computer's main computer may be a problem with the CPU. You can try plugging the CPU back in or replacing it. Hard drive failure:
When your computer starts, it may be a problem with your hard drive. You can try to use a hard drive detection tool to detect the hard drive and replace the bad hard drive.
This may be the sound of the computer's main computer's speaker, or the computer's system may be issuing a warning. It could be due to a malfunctioning system, or a dripping sound due to a software warning. If a specific message will be displayed on the computer screen when the beep sound is emitted, please follow the information prompts.
If not, there may be a hardware or system failure, and the PC should be restarted or serviced immediately. Or an attempt to plug or unplug a memory module.
Here are some <> related extensions that we hope you will find helpful
The sound of the computer host is the sound of self-test and fault reporting; Start the computer normally and make a sound of dripping to indicate that the self-test has passed, and the sound of rhythmic dripping, dripping, and dripping indicates that there is a problem with memory, and a long and short drop is issued, and the sound of dripping and dripping says that there is an obvious problem with the card; If it is a long and short "Di Di", it means that there is a problem with the graphics card.
Dear, you can try to operate the above answers.
-
When the computer makes a dripping sound, check whether the hardware temperature (mainly the graphics card and CPU) is too high, and when the hardware temperature is about to reach a critical point, the computer will send out an alarm sound, prompting the computer to cool down.
Different drips reflect different problems.
1 Short: The system starts normally.
2 Short: General error, please go to CMOS Setup and reset the incorrect options.
1 long and 1 short: There is an error with the RAM or motherboard. Try to change the memory, if it still doesn't work, you have to change the motherboard. 1 long and 2 short: The display or graphics card is wrong.
1 long and 3 short: The keyboard controller is wrong. Check the motherboard.
1 Long 9 Short: Motherboard Flash RAM or EPROM error, BIOS corruption. Try a different block of flash ram.
Constant ringing (long sound): The memory module is not plugged in tightly or is damaged. If it still doesn't work, you can only replace a memory module.
Repeated, short ring: There is a problem with the power supply.
No sound and no display: There is a problem with the power supply.
-
Summary. Hello, the sound of the main computer is usually due to a hardware or system problem. Here are the possible causes and how to fix them:
Memory failure: Unplug and reinsert the memory module to make sure that the memory module is plugged in tightly. Graphics card failure:
Unplug the graphics card, then plug it back in, and make sure the graphics card is plugged in tightly. BIOS Settings Error: Check the BIOS settings and if there are errors, restore the default settings.
Hard drive failure: Check whether the hard drive is installed correctly and whether the hard drive needs to be replaced. CPU Failure:
Check whether the CPU is plugged in tightly and whether the CPU needs to be replaced. Power failure: Check whether the power supply is working properly and whether the power supply needs to be replaced.
How to fix this.
Hello, the sound of bridge fiber and Didi from the computer host is usually due to a hardware or system problem. Here are the possible causes and workarounds: Memory Failure:
Unplug and reinsert the memory module, making sure the memory module is plugged in tightly. Graphics card failure: Unplug the graphics card, keep an eye on it, and then reinsert it to make sure the graphics card is plugged in tightly.
BIOS settings are incorrect: Check the BIOS settings, if there are any errors, restore the default settings. Hard drive failure:
Check that the hard drive is installed correctly and if the hard drive needs to be replaced. CPU fault: Check whether the CPU is plugged in tightly and whether the CPU needs to be replaced.
Power failure: Check whether the power supply is working properly and whether the power supply needs to be replaced.
-
Hello dear, when the computer console makes a ticking sound, it is usually some kind of problem or error. Here are a few common DiDi problems and how to fix them:1
Memory issues: A dripping sound can be an indication of a memory error. Try reinstalling the memory sticks to make sure they are properly inserted and securely connected to the slot.
World pants 2Hard drive issues: Didi sound can also be a sign of a hard drive failure.
You can try reconnecting the hard drive cable, or replacing the hard drive. 3.Display issues:
Tick sound is sometimes an indication of a monitor connection issue. Make sure the monitor is properly connected and plugged in. 4.
Keyboard issues: Sometimes a tick sound can be a warning of a keyboard connection problem. Make sure the keyboard is properly connected.
5.BIOS Issues: Tick sound is sometimes an indication of a BIOS error.
You can try restarting your computer, and if the problem persists, you may need to update or restore your BIOS settings. If the problem persists, it is recommended that you contact a professional technician or computer repair specialist for further diagnosis and resolution of the problem.
That's your BIOS alarm tone.
First of all, you should be clear about what your motherboard's BIOS type is, you can check it by reading the manual or through the POST. >>>More
Explain the motherboard alarm sound in detail.
tag: computer. >>>More
First of all, check each socket, it is best to pull it off and plug it in again, and listen to how many times it is announced. For your reference! >>>More
1. Software conflicts in the process of use, such as the sound of dripping when the typing operation is wrong. >>>More
The legendary motherboard is loose??? The estimation is this