How to adjust the signal strength of the Household Pass is 52 , what is the situation? New

If the signal strength of the household is always 52 percent, there are several possible scenarios:

1.Line fault: Check whether the feeder is in good condition, whether the connector is properly connected, and whether the receiver input interface is well connected. This could be a fault on the line that is affecting the signal strength.

2.High Frequency Head Problem: Check whether the high frequency head is in good condition. If the high-frequency head is damaged, it will lead to poor signal reception, and even if the signal strength reaches 52 percent, the signal may not be received properly.

3.Receiver Problem: Check whether the receiver input interface and connected cables are normal. If there is a problem with the receiver, it may cause the signal to not receive properly even if the signal strength reaches 52 percent.

If the above conditions are found to be normal after inspection, but the signal strength still cannot be improved, it is recommended to replace the high-frequency head. If the problem persists, it is recommended to contact Huhutong customer service or relevant technicians for further inspection and repair.

Place the pot in a different place.

You can ** star finder wizard to calculate the local reception angle. There should be no shelter in front of the pot. Connect the wire, press the information button, the signal strength and signal quality bar appear, (the signal strength is about 50 70 after the line is connected) first adjust the elevation angle.

Turn the signal strength to the highest and then adjust the azimuth.

Zhongjiu in our country is generally about 30 degrees south-west, slowly turn the pot from due south to west, the signal quality appears and adjust to the highest, and finally you can turn the high-frequency head a little more, adjust the signal to the highest, see if all the stations are closed, fixed on it.

Is it that the satellite does not accept well and re-rotates the position.

There are two reasons for this:

1. The plug of the signal cable connecting the set-top box is loose or falls off.

Solution: Reconnect the signal cable. to restore the signal.

2. The lid of the pot moves in the direction of the satellite, or the high-frequency head is broken.

Solution: The direction of the lid must be accurately adjusted or the high-frequency head must be replaced, Zhongjiu in our country is generally about 30 degrees south-west, slowly turn the pot from due south to west, the signal quality appears and adjust to the highest, and finally you can turn the high-frequency head a little more, adjust the signal to the highest, see if all the stations are closed, fixed can.

Installation conditions for the Household Pass:

1. The direct broadcast satellite receiving facilities are only used in the designated service area. Before purchasing, please confirm with the seller whether the installation address meets the requirements.

2. Sales of complete sets of live broadcast satellite receiving facilities, including set-top boxes, antennas, high-frequency heads, encryption cards, positioning cards, feeder cables, installation auxiliary materials and installation costs.

3. If you open an external ** service, you need to purchase an external ** module separately and go through the relevant ** opening procedures with the telecom operator.

4. The live broadcast satellite receiving facilities will be delivered to the door by professional installers, and installation and opening services will be provided.

5. The user should ensure that the installation address is consistent with the installation address, otherwise it will lead to the failure of normal installation, and the resulting losses shall be borne by the user.

6. The location of the live broadcast satellite receiving facility will be locked after installation, and leaving the installation address cannot guarantee normal viewing.

7. Provide the encrypted card, receiving facilities, user sales installation order, corresponding ** card and ** terminal to the service team, and settle the installation fee with the service team according to the returned user sales installation order.

8. Collect and record business data information such as the sales of receiving facilities and the sales and installation orders of users, and regularly return the third copy of the sales and installation orders of users to local service agencies.

The signal quality is 0%, which means that the pot is not aligned with the satellite, and then there is a tree in front of the pot, if the tree is tall and dense, just extend the line and put it on the south side of the tree. Toto-tong is to receive the signal of the nine satellites, it is slightly east of the south, that is, due south slightly east, because it uses a bias feed to receive the signal, so the high-frequency head of the small pot lid is facing the southwest direction, so you should not have obstacles in the south of the pot lid slightly east and southwest directions. At the same time, the speed should be slow when adjusting the lid.

Because the set-top box is very slow to respond.

I was like that before, and then ...

It is the height and elevation angle behind the pot that is not adjusted correctly;

Loosen the rear adjustment screw to adjust the height, and the signal strength suddenly turns green Ecstasy.

Possible reasons for the lack of signal strength and signal quality in every household:

First of all, there is the signal strength, which means that the line is connected correctly. Then check if there is any obstacle blocking the small pot lid and aiming at the direction of the satellite; Whether the signal cable connecting the set-top box has fallen or is loose; Whether the signal demodulator of the set-top box and the high-frequency head of the pot lid antenna are broken.

If the above confirmation is correct, it means that there is no signal quality, and it is because the pot is not aligned with the Zhongxing-9 satellite.

Solution: You only need to adjust the position of the lid of the small pot accurately. Adjust the pot and high-frequency head up and down, left and right, fine-tune the signal quality, and fine-tune the elevation or azimuth angle of the pot to make the signal quality to the best state. Adjust the angle according to the figure below

The reason why the set-top box only has signal strength and no signal quality and its solution:

1. There are tall buildings or trees in front of the pot blocking the signal source.

must be avoided or removed;

2. The elevation angle and deflection angle of the pot are not adjusted to the best position.

There is signal strength, indicating that the feeder connection from the high-frequency head to the set-top box is normal, but it is necessary to watch the change of signal quality, and the elevation angle and deflection angle of the pot are finely adjusted towards the direction where it gradually increases, until the signal quality reaches more than 85% and is fixed;

3. The high-frequency head is damaged.

Confirm that the high-frequency head has been damaged, replace it with a new high-frequency head, and then fine-tune the two directions of the pot to make the signal quality reach 85%.

The reason why there is a signal but can't find the station:

The signal strength is the receiver to the satellite pot.

When the signal strength reaches about 95, it can be. Looking at the signal quality is a data indicator of whether the satellite pot is accurate to the star. In the case of good signal strength, if the signal quality does not reach 80 and there is still no station, in this case, we can try to adjust the position of the pot lid against the signal source until the signal quality reaches about 80.

Carefully adjust the angle of the satellite pot to the star. There are three major angles to the star, that is, Fang Qingchai's position.

Elevation and polarization angles. The main azimuth, Yangon.

The angle and polarization angle are set at the factory of the satellite pot, be patient, adjust it slowly, and it will definitely be successful.

One for all.

set-top box, after the set-top box is turned on, the TV screen prompts "The base station information cannot be searched, please contact the installation and maintenance personnel or customer service center" (as shown in the figure below); Under normal circumstances, this kind of machine is generally installed and positioned, and it should be a normal positioning machine.

How to tune the TV satellite signal receiver:

2. Open the receiver and press the menu button (or directly press the chain star button or press F3), then tune to the system settings, press the confirm button and then enter the password or press the confirm button to confirm.

3. Look at the submenu and select [Signal Detection], there are two lines in the lower right corner of the screen to display the signal strength and signal quality, and then place the pot in the southwest direction to adjust the elevation angle and square up and down, left and right, and fix the pot and high-frequency head when the signal quality is adjusted to the maximum value, and press the exit button to see the program.

Summary. The strength of the household communication number is 60 and the quality is 0, what's going on?

Hello dear, the first time to install the Household Pass, the signal strength is 60, but the signal quality is 0 possible reasons:

1. The plug of the signal cable connecting the set-top box is loose or has fallen off.

Solution: Reconnect the signal cable to restore the signal.

2. The lid of the pot is shifted in the direction of the satellite.

Solution: You need to adjust the position of the lid of the small pot accurately.

3. There is an obstacle in the direction of the satellite where the lid of the pot is aligned.

Solution: Remove the obstacle so that the direction of the lid is kept open, and there should be no obstruction.

4. The signal demodulator of the set-top box is broken.

Solution: Ask a professional to replace the signal demodulator.

5. The high-frequency head connected to the antenna is broken.

Solution: Replace the normal high-frequency head.

The strength of the household communication number is 60 and the quality is 0, what's going on?

The strength of the household communication number is 60 and the quality is 0, what's going on? Hello dear, the first time you install Huhutong, the signal strength is 60, but the signal quality is 0 possible reasons: 1. The signal cable plug connecting the set-top box is loose or has fallen off.

Solution: Reconnect the signal cable to restore the signal. 2. The lid of the pot is shifted in the direction of the satellite.

Solution: You need to adjust the position of the lid of the small pot accurately. 3. There is an obstacle in the direction of the satellite where the lid of the pot is aligned.

Solution: Remove the obstacle so that the direction of the lid is kept open, and there should be no obstruction. 4. The signal demodulator of the set-top box is broken.

Solution: Ask a professional to replace the signal demodulator. 5. The high-frequency head connected to the antenna is broken.

What should I do if the quality of the household communication number is 0?

What to do if the quality of the household communication number is 0, as long as the line of the high-frequency head is correctly connected, the signal quality will not be 0, the genuine three-generation household through the set-top box, in the signal installation and detection, to press the confirmation key twice in a row, in order to see the signal quality and strength. Press the menu button of the remote control, and the remote control F1 confirms twice before the strength comes out, and then adjusts the signal quality to the southwest direction. When purchasing satellite pots and corresponding supporting equipment, we must look for the State Administration of Radio, Film and Television"Everyone"Labeling, the use of genuine products, in order to ensure the quality of TV program ratings.

Because copycat products generally have the following problems: 1. There are few programs, only about 40; 2. There are often inconsistencies in the program images and language; 3. Can't watch the program preview; 4. It is easy to be disturbed by the external environment, such as strong winds and large trees. I hope it can help you and wish you a happy life

Summary. There is a signal strength display, which means that the high-frequency head is not broken, and there are these two possible reasons that your receiver only has signal strength, no signal quality 1, maybe your data is adjusted out of order 2, and your antenna direction is deviated.

The strength of the household communication number is only 10, how can it be bad.

There are two possible reasons why your receiver only has signal strength, not signal quality 1, your data may be adjusted by nuclear stimulation 2, your antenna direction is deviated.

What should I do if the strength of the household communication number is 10%.

Try to adjust the direction of your antenna.

Debugged, and no.

The thread was also checked, and it was not broken.

The method of debugging the signal quality of Huhutong is as follows:

According to the instructions, earn money to install the parts of each part, and don't install the wrong parts.

Correctly connect the high-frequency head to the set-top box, and the set-top box to the TV. At the same time, turn on the power and select the signal source of the TV as the signal input of the set-top box, and display the set-top box installation screen and signal strength.

Fine-tune the elevation and deflection angles of the pot to adjust the signal quality from 0 to 80% 90%, and fix the pot seat.

And then the signal quality is generally very good.

Everyone"Satellite direct television service is a new live satellite radio and television service implemented by the State Administration of New Leasing Yuanwen Publication, Radio, Film and Television with the approval of the Central Propaganda Department in order to implement the spirit of the leader's instructions and solve the problem of the masses in rural areas being unable to listen to and watch radio and telecommunications for a long time as soon as possible.