-
There are two types of lawn punching, one is solid punching. Two: hollow punching.
Solid perforation is mainly for the soil compaction, poor water permeability, and the rot phenomenon caused by poor breathing of grass roots, at this time should be punched with a solid punching rod, and the punching rod of different sizes should be selected according to the growth of the grass and the characteristics of the soil.
Two: hollow punching. It is mainly for the turf density is too large, the density needs to be reduced to hardness, and at the same time to improve soil compaction, improve the effect of soil quality, and timely sand and watering after punching hollow holes (brief introduction).
-
The specific steps to replace the punch head may vary for different models of lawn punches, and the following is the general operation process:
Disconnect the punch from the power supply first to ensure safety.
Locate the punch head connection, which is usually a threaded connection.
Use a wrench or other tool to loosen the threads at the joint.
Remove the original punch head from the connection, taking care not to break the threads at the connection.
Choose the right model and specification of the new punch head. Drain width.
Install the new punch head to the connection, taking care not to be too tight or too loose.
Use a wrench or other tool to secure the new punch head, making sure the threaded connection is tight.
Connect the punch to the power supply and perform a test run to confirm that the new punch head is installed correctly and working properly.
It is important to note that when replacing the punch head, the appropriate model and specification should be selected to ensure compatibility with the lawn punch. In addition, safety should be paid attention to during operation to avoid the occurrence of accidental injury. If necessary, it is recommended to refer to the specific product manual or consult the manufacturer for more detailed operation guidance.
-
1. First of all, disassemble the straw potato vertical floor punch, and be careful when disassembling to avoid damaging the punching machine.
2. Then, take out the punching head in the punching machine and replace it with a new punching head.
3. Finally, put several large punching heads back into the punching machine, install and fix them, check whether they are installed firmly, and confirm that there is no problem.
-
The vents are for turf aeration, i.e. to make some deep holes in the lawn to allow air to enter to reduce the adverse effects caused by soil compaction. If you have a large lawn, it is recommended to buy a rotary aerator, which can be used to extract soil clods to promote drainage using a hollow tooth aerator, and use the extracted soil clods to make compost, and then use these made gravel-containing compost to fertilize the lawn to improve soil quality. If you have a small lawn, you can use a fork to poke into the soil every 15 cm throughout the grass for aeration, which is the easiest and most convenient way, after aeration, the soil surface needs to be filled to maintain the permeability of the turf, fertilize it, and promote the growth of the lawn. Fill in the holes to flatten the surface, but they should be sieved before use to avoid trouble for mowing. The filler can be 1 part humus or moss, 3 parts sieved soil and 6 parts medium grain sand.
For large areas of lawn, the surface filling can be spread with a manure spreader, about three kilograms per square meter, in dry weather. Small areas of lawn can be done by hand. Use a shovel or shovel to spread the filling evenly, and use a stiff brush to remove excess filler.
And submerge them in the grass.
-
Dizzy, I don't know this. In fact, the punch machine is drained, but generally as long as the stadium is well drained, it will not be used, unless it is raining heavily and the water cannot be drained.
-
Is it for water leakage?
-
Lawn punching machine is divided into golf lawn punch and landscaping lawn punch. Golf lawn punches are divided into fairway punches and green punches.
Lawns are divided into two types: cool-season type and warm-season type, and the sowing season is different. >>>More
As a second-year junior high school student, you are still a child in the eyes of your parents, and although you are very important to both of them, neither of them will receive your consolation in person. Maybe your mom is better. But your father, in general, is not allowed to judge his behavior and point out his faults. >>>More
Summary. Planting Bisporus mushroom: Bisporus mushroom is a grass saprophytic fungus, which requires a large amount of nitrogen source when planting, mainly from crop straw, manure, etc., in the ingredients, you can add farm fertilizer to crop straw, as well as nitrogen, phosphorus, potassium, calcium, sulfur and other inorganic nutrients, in order to achieve the high yield effect of Bisporus mushroom. >>>More
As a small transparent, the action should be fast, the posture should be handsome, and it is deeply hidden in the fame.