09 Focus flameout? Who s the same as my car 5

Well, a lot of Fox owners resent.

When driving 2000 kilometers or less, the engine will be turned off, and the 4S shop will consult They will say that cleaning the throttle, Changan Ford is not kind.

Landlord: I posted a report on the consumer proposition Fox Flameout in the references.

There is time for you to take a look.

I'm ready to buy the manual version of Fox.

Two days ago, I went to the 4S shop and asked, saying that it is true that some cars have a serious problem of stalling in driving, and they have no good way at present, and the engineer is studying countermeasures.

Also, I heard from experts that if you use 97 gasoline, you will be fine.

My at has been bought for more than half a year.

There was a situation where the on-board computer showed engine failure and could not start normally, and I cleaned the throttle in 4s, upgraded the on-board computer, and then there was no more condition.

Since there is a problem with your car, go to the 4S shop, he should clean the throttle for free, if it is still off, then you may have to wait, see how the flameout door this time, Changan Ford manufacturers look at the solution.

Yesterday it was reported on TV that many Focuses have this problem, and it is a problem with the quality of the car. **The second consumer proposition is reported.

The throttle valve is prone to carbon deposit.

There is also a saying that the fuel pressure is too low.

Mine is the same as yours, I bought a car in November, and I can go to the 4S shop to clean the throttle for a few days, but after a few days, the throttle will start to stall unsteadily.

If the technology is not too hard, don't buy Focus. For high-rpm cars, the throttle should be opened frequently.

The car I just bought has to pass the run-in period. After the run-in period, there will naturally be no such phenomenon...

Summary. The reason is the oil circuit problem, if the oil pressure ** is insufficient or the oil pump is faulty, it will also lead to flameout; The fuel injector is blocked, and the fuel injection atomization effect is poor after the fuel injector is blocked, and the engine may cause stalling if it does not work properly; Ignition ablation, due to the ignition voltage can reach tens of thousands of volts, coupled with the accumulation of oil at the end of the ignition coil and ablation, the ignition is abnormal and easy to go out. If the engine stalls due to deceleration and braking while driving, you can take measures to increase the braking force, and at the same time pay attention to the surrounding situation, and there is a chance that you can change lanes to bypass the obstacles in front of you, because there is no steering assistance at this time, so it will be heavier when hitting the direction.

The reason is the oil circuit problem, if the oil pressure is insufficient or the oil pump is faulty, it will also lead to a good flameout; The fuel injector is blocked, and the fuel injection atomization effect is poor after the fuel injector is blocked, and the engine may cause stalling if it does not work properly; Igniter ablation, due to the ignition voltage can reach tens of thousands of volts, coupled with the ignition coil book Luna end of the oil accumulation and ablation, ignition is abnormal and easy to stall. If the state does not turn off due to deceleration and braking while driving, you can take measures to increase the braking force, and at the same time pay attention to the surrounding situation, there is a chance to change lanes to bypass the obstacles in front, because there is no steering assistance at this time, so it will be heavier when hitting the direction.

My Focus Changan Ford 08 car turned off as soon as it was in R gear.

The engine stalls when the R gear is engaged, which may be caused by a damaged locking solenoid valve or a card on the locking control valve.

It's as if it's not separated.

It should be a problem with the locking solenoid valve, and it is recommended that you can check it to make sure that it is damaged and replaced.

How much is that, a repairman showed me yesterday and said it was a gearbox problem.

The normal ** to repair this is between 500 and 800.

He said the gearbox got 3000

It's not a gearbox problem.

It's a gearbox problem, dear.

The solenoid valve is on the gearbox, right?

Yes, the lock gear solenoid is also part of the gearbox.

Summary. Hello, happy to answer your <>

08 Focus automatic flame-out solution: 1The fuel injector is blocked, and the fuel injection atomization effect is poor after the fuel injector is blocked, and the engine is not working properly, which may lead to flameout2

Ignition ablation, due to the ignition voltage can reach tens of thousands of volts, coupled with the accumulation of oil at the end of the ignition coil and ablation, the ignition is abnormal and easy to go out. 3.Check the ignition and starter switches, as well as the fuse.

The above is the solution to the 08 Focus automatic flame-off.

How to solve the problem of 08 Focus automatic flame-off.

The automatic transmission of the 08 model, Changan Ford Focus, turns off as soon as the R gear is applied, and it is the same as the non-separating one.

Hello, happy to answer your <>

08 Focus automatic flame-out solution: 1The fuel injector is blocked, and the fuel injection atomization effect is poor after the fuel injector is blocked, and the engine is not working properly, which may lead to flameout2

The ignition letter head is ablated, and the ignition voltage can reach tens of thousands of envy and ablation, and the ignition coil end oil accumulation and ablation, and the ignition is abnormal and easy to go out. 3.Check the ignition and starter switches, as well as the fuse.

The above is the solution to the 08 Focus automatic flame-off.

Dear, caused by a malfunction inside the gearbox.

Only by hanging the R gear and turning it off can you move forward with the D gear.

Dear, it's the gearbox that is faulty.

Dear, you can overhaul it.

How much does it cost to repair, he and I want 3000

Dear, it takes 3,000 yuan to repair. Different repair shops, the maintenance of ** is not the same.

Good. Kiss, okay.

Kiss <>

Expansion: Definition of transmission box: Gearbox refers to the change of driving resistance, changing the torque and speed of the driving wheel, so that the car moves forward and backward.

Change the transmission ratio to expand the range of drive wheel torque and chain hall speed. Under the condition that the direction of rotation of the engine does not change, the car can be driven backwards.

Summary. Dear Hello, I am very happy to answer for you, the solution of 08 Focus automatic flameout is as follows: 1. Vibration method When vibration may be the cause of failure, it can be solved by vibration method.

The basic methods are mainly as follows: 1) Gently shake the connector in the vertical and horizontal directions 2) Gently shake the wiring in the vertical and horizontal directions 3) Gently pat the parts equipped with the sensor with your fingers to check whether the flame is out, but do not pat the relay too hard, otherwise the parts of the sensor will be damaged. 2. Heating method If some faults only occur when the car is warmed, it may be caused by the heating of the relevant parts or sensors, and the parts or sensors that may cause faults can be heated with a hair dryer or similar heating tools to check whether there is a failure.

However, it must be noted that the heating temperature should not be higher than 60; Do not heat parts in the computer directly. 3. Water shower method When some faults occur in rainy days or high humidity environments, water can be sprayed on the vehicle to check whether the fault occurs. However, it should be noted that the water should not be sprayed directly on the engine electronic control parts, but should be sprayed in front of the radiator to indirectly change the humidity and temperature; Do not spray water directly on electronic components, especially to prevent water from entering the computer.

Dear Hello, I am very happy to answer for you, the solution of 08 Focus automatic flameout is as follows: 1. Vibration method When vibration may be the cause of failure, it can be solved by vibration method. The basic methods are mainly as follows:

1) Gently shake the connector in the vertical and horizontal directions 2) Gently shake the wiring in the vertical and horizontal directions 3) Gently pat the part equipped with the sensor with your finger to check whether it is out of flame, but do not pat the relay too hard, otherwise the part of the sensor will be damaged. 2. Heating method If some faults only occur when the argument is hot, it may be caused by the heating of the relevant parts or the sensor flush infiltrator, and the parts or sensors that may cause the failure can be heated with an electric hair dryer or similar heating tools to check whether there is a fault. However, it must be noted that the heating temperature should not be higher than 60; Do not heat parts in the computer directly.

3. Water spray method When some ridge barriers are generated in rainy days or high humidity environments, water can be sprayed on the vehicle to check whether there is a failure. However, it should be noted that the water should not be sprayed directly on the engine electronic control parts, but should be sprayed in front of the radiator to indirectly change the humidity and temperature; Do not spray water directly on electronic components, especially to prevent water from entering the computer.

The main thing is that the R gear is not separated, and the forward gear is fine.

First of all, check whether the oil volume of the transmission is too small, whether the main oil pressure and gear oil pressure are normal, and then check whether the gear switch signal is shooting badly, whether the gearbox computer to the shift solenoid valve line is good, whether the gear solenoid valve is working normally, if there is no problem, it is said that there is a problem with the internal control system of the gearbox, and the gearbox should be disassembled to check the internal actuators.

Variable speed oil. How much does it cost to repair.

This repair** is around 580 yuan.

That repair shop asked me for 3000

This depends on the maintenance**.

Dear, this repair place is not the same** is also different.

Summary. Dear, hello, for the phenomenon of automatic car stalling, it is mainly caused by the use of inferior fuel. One is to go to a regular larger gas station to add high-grade oil, such as using 97 gasoline, although it is a lot more expensive, but it can ensure a longer life of the car and good power in operation.

Hello, dear, for the phenomenon of stalling the car that has been in the gear, it is mainly caused by the use of inferior fuel. One is to go to a regular larger gas station to add high-grade oil, such as using 97 gasoline, although it is a lot more expensive, but it can ensure a longer life of the car and good power in operation. However, some car owners are greedy for cheap and 90 oil, although it is lower, but there may be problems in the future.

Kiss, manual gear troubleshooting: Bichaichun 1, for Xinzhao Weishou, halfway shutdown is not a new topic, the main elimination method is to improve their driving skills after rapid running-in. 2. Use high-standard, high-quality and qualified fuel.

3. Clean the oil circuit thoroughly, including fuel injectors, throttle valves, fuel tanks, etc. It may be that the quality of the oil you regret is not up to par, and there is too much grease, which blocks the oil path and does not attack the oil.

The main reason for the failure of the car to stall in the idle state is due to too much dust in the air, and there is a lot of dirt deposited at the idle motor valve core and throttle seat when the engine is running. The solution to this problem is simple: just clean the idle motor.

5. Whether the oil circuit is smooth or not, which is also easy to cause the engine to stall halfway. 6. Due to the price of oil, coupled with the return of many people's hobbies - cycling, walking and walking to work has increased, so new cars have been parked for a long time and are not used. In fact, it is important not to park it for a long time.

In case of a long parking time, a thorough maintenance should be done before reuse, changing the oil, filter, etc., and checking the fuel, circuit, etc. as appropriate. It is possible that your vehicle is due to lubrication or electrical problems due to prolonged parking.

Summary. Hello, the 2011 Ford Focus stalls during driving is generally caused by the following reasons:

The first is the oil circuit failure, such as the damage of the high and low pressure fuel pump, the dirty and clogged fuel filter element, etc. After the oil pump is damaged, the oil pressure will be unstable and the oil pump will not work properly, and the vehicle will occasionally stall. When solving, you can first see whether there is a fault code in the fuel system, if not, measure the fuel pressure first, and replace the oil pump directly if it is abnormal.

If there is a fault code, follow the fault prompt.

What happened to the 2011 Ford Focus stalling during driving.

Hello, I am a car repairer, with rich experience in the maintenance of mid-to-high-end models, and has served more than 2,000 customers. I've seen your question, I'm sorting out the answer, it takes some time to type, please wait a while and I'll reply to your question within five minutes

Hello, the 2011 Ford Focus is generally caused by the following reasons: First, the oil circuit failure, such as high and low pressure fuel pump damage, fuel filter dirt and blockage, etc. After the oil pump is damaged, the oil pressure will be unstable and the oil pump will not work properly, and the vehicle will occasionally stall.

When solving, you can first see whether there is a fault code in the fuel system, if not, measure the fuel pressure first, and replace the oil pump directly if it is abnormal. If there is a fault code, follow the fault prompt.

The second is all kinds of sensor failures, the more common is the crankshaft position sensor and camshaft position sensor damage caused by the occasional flameout, because these two sensors are to detect the crankshaft and camshaft angle position, if the signal they send is inaccurate, the engine will stop injecting and air intake, and the vehicle will also have the symptoms of stalling, the solution is to replace the damaged sensor, I hope mine can help you!

Summary. There are several reasons: the first is that the fuel pressure is not enough, it is likely that the one-way valve of the fuel pump is damaged, or it is possible that the sealing ring in the fuel filter element is not installed in place.

Second, you need to check whether there is water in the fuel tank! It could also be a gasoline quality issue. Third, you also need to check whether the feedback signal of the water temperature sensor is normal.

Fourth, it may also be caused by too much carbon deposits in the throttle or air intake, and the above points should be able to solve the problem of turning off the car one by one.

Did you use an oil that didn't suit you? Refueling must go to a regular gas station to refuel, it is possible that you have added a small gas station with bad quality oil, which will affect the engine, or it may be that your engine has too much charcoal, and you need to clean it up.

There are several reasons: the first is that the fuel pressure is not enough, it is likely that the one-way valve of the fuel pump is damaged, or it is possible that the sealing ring in the fuel filter element is not installed in place. Second, you need to check whether there is water in the fuel tank!

It could also be a gasoline quality issue. Third, you also need to check whether the feedback signal of the water temperature sensor is normal. Fourth, it may also be caused by too much carbon deposits in the throttle or air intake, and the above points should be able to solve the problem of turning off the car one by one.

If my answer is helpful to you, please give a thumbs up (in the lower left corner), I look forward to your like, your efforts are very important to me, and your support is also the motivation for my progress. If you still feel that my answer is more satisfied, you can follow me, and when you have questions, click on my avatar for one-on-one consultation.