Does the 9800GT 1G freeze or blue screen often with a 250W rated power supply?

9800GT, large power consumption, much larger than the same grade 4830 power consumption, with 9800GT at least recommended rated 350W power supply, about the power supply selection you refer to my details.

Many people often ignore the power supply when choosing a computer, and they are obviously equipped with high-end machines but finally save a fortune on the power supply. As everyone knows, it is very likely that the little money you save may be the culprit of your computer failure in the future. Personal years of installation experience, in the past, the power consumption of the machine was low, and the power quality problem was not very serious, but now the machine, especially the machine with a high-end graphics card, and whether the selection of overclocking power supply is suitable is very serious.

First of all, it should be clear that the rated and the maximum power consumption are two concepts, occasionally exceeding the rating as long as the maximum power is not exceeded, it is no problem, but the long-term over-rated working power supply will accelerate aging, which is not serious, and it is likely to cause physical damage to the motherboard or hard disk at the same time. Therefore, when buying a power supply, you don't need to consider the highest power consumption at all, only the rating. Try to make the rated power consumption of the selected power supply exceed the maximum power consumption of the whole machine.

In this way, you are not afraid that there will be problems when the game is turned on for a long time.

The freeze and blue screen you are talking about are a manifestation of a serious lack of power in the power supply, and it is very dangerous to use it reluctantly. Change the power supply immediately, and recommend a value-for-money power supply to you. Kangshu IP430, rated 380W, **290 yuan, with 9800GT overclocking is enough.

That's right, the standard configuration of the 9800GT should be about 350W, and the recommended power supply is Huntkey Panshi 400

Absolutely. A minimum rated power supply of 320W is sufficient.

Recommended - Conshu E2 Power 380 259

Huntkey Wide King II 325

Reinstall the driver and it doesn't work, it's a compatibility problem.

To buy or to sell... Tell the difference between the 、。。 b...90w？？If the computer is a complete machine, the 9800GT should be used at least to a power supply rated of 300W or more.

There are also 9 series graphics cards that need an external power supply from 9600 onwards, and there is an external power cord in the box... In your case, I guess it's not connected to an external power supply.,You must know that this kind of graphics card can't work properly without an external power supply.,Even the cooling fan is powered by an external power supply.。。

The landlord didn't say anything clearly.,Go back and see it clearly and ask again.,9800 graphics card with 90W power supply??? Then your computer won't boot up!!

I don't know if your JS brain let the donkey kick or your brain let the donkey kick, go back and see clearly!! A bunch of typos!

There are certain reasons, but the problem is not very big, in general, the blue screen is mostly the case, the memory module is loose, the contact is poor, the chassis is too dusty, the heat dissipation difference temperature is too high, and the graphics card is damaged. Solution: Clean up the dust of the machine, erase the memory module with an eraser or replace the memory and graphics card, and paste the heat dissipation sticker and heat dissipation silicone to the CPU.

Your power supply is rated at 300W, it stands to reason that it should be enough, the power consumption of this platform is about 140W when idle, and the full load will not exceed 230W, if the power is really too low, then your power supply is an out-and-out fake.

Looking at the symptoms you described, they are too similar to heat dissipation problems, not only the chassis, CPU, graphics card, video memory, hard disk, motherboard north and south bridge, but also power supply heat dissipation ......It's easy to do with a temperature measuring head, but if you don't have it, you can only try it by hand.

The factory inspection of the motherboard and other hardware is very strict, but it may not be that there will be no problems, even the CPU will flow out of the goods, you really can't find the reason, you should contact the hardware manufacturer as soon as possible - Weconex is a distributor, the hard disk is in bulk, the CPU is boxed, to be honest, your acquaintance is not very authentic.

If you have a friend who uses an AM2 motherboard, you should switch to the motherboard first and eliminate the suspicion of each hardware one by one. I've seen someone have a similar symptom when one of their CPUs fails.

There are two possibilities for this.

1. Take XP as an example, right-click on my computer to select Properties, find the Advanced tab, find the following startup and troubleshooting items, and click Settings. In the pop-up window, find three options in the middle'System Failure',The third item will automatically restart,Cancel the check of this item,The blue screen will stop if there is a problem in the future。

2. The above settings have been made, but it will still restart in a flash, which is caused by the overheating of the graphics card or CPU, open the case to check the status of the cooling fan and radiator.

In addition, the blue screen is invisible when the device is turned on** flashes by and then restarts by itself. At this time, it is impossible to set the first step in the system, so you have to press F8 when the machine starts, and disable the restart after selecting the startup failure, and the system will stop at the blue screen**, so that you can follow the blue screen** to view the problem.

If the temperature is too high, you will have these symptoms, 1. Check if the fan is still running.

2. If it is still turned, check whether the heat dissipation part (mainly the heat sink) is filled with dust.

goodluck

There is a virus, and the computer hardware is not compatible.

Is that a hard drive or something?

It is recommended that you use the CD with the system to repartition your hard drive.

You can check the specific method on the Internet, and there are a lot of them

Check CPU CPU Cooling Fan Check Power Supply Power Supply Cooling.

Clean the dust, plug and unplug the memory.

Change the computer! Have you ever recharged the system, or your computer configuration is too low, and there are too many things to run, causing such consequences. There is also a possibility that the CPU is not burned out.

It is very likely that it is caused by a hardware conflict, you remove a piece of hardware that was recently installed, and see if there is still a problem? For example, sound cards...

Hard disk graphics cards are possible, and besides, have you changed the hardware and reinstalled the driver?

And hard drives. Hard drives are also possible.

For hardware problems, open the chassis and plug the memory module and the graphics card back in, and then see if you can turn on the computer, if not, then check whether the motherboard capacitor is protruding. If there is, the motherboard capacitor is burned. If not, then reinstall the system.

The landlord is a hard disk is broken, hurry up and repair it, the current hard disk is not expensive.

Check the memory or hard disk to see if the memory or hard disk is broken.

The probability of memory module problems is more than 75%, and the 25% chance is that the hardware temperature is too high, resulting in a crash or protective reboot or blue screen. Rule out the case of high temperature and blue screen of death restart.

Open the chassis. Plug the memory module back in. Two memory sticks. Just plug in just one.

Check whether the air dissipation of the CPU is running normally, whether there is a gap between the CPU and the heat sink, and whether the silicone grease is dry or cracked.

Add silicone grease and debug the air dissipation. Unplug all the hardware and clean it up.

In addition, the chassis has now been opened. Use a hair dryer to clean up the dust. Don't forget to go to the door and deal with it.

Otherwise, the house will be filled with smoke.

If it's still a blue screen. Just find a normal memory module and try it. Probably just fine. That means your memory module is broken.

If you are Ben. It's sad ... It's better not to disassemble this book by yourself for novices.

If it's a book, take it out and find a repair point, disassemble it, and try to change the memory.。。。 It is risky for novices to split the book. Think again.

There is also a 15% chance that it is a disk error caused by a 00000000ed error.

and drivers and other programs. The workaround is to enter safe mode, disable all startup items, and then start again.

When you're done, please give me the answer. Thank you.

Your computer configuration is very average, admit it!