Hurry, hurry, I plugged the CPU upside down

Don't repair the motherboard, generally go to repair people, and tell you that the new film of the North and South Bridge is broken, and you can get 100 at least 80 Admit bad luck and buy one for others The two add up to more than 300 yuan and a maximum of 400!

I just hope your memory graphics card doesn't burn out...

Actually, you're really stupid, the CPU can't be plugged in, and you still use so much effort... Let's go and practice sports haha.

No, no one can say fix the CPU pins yet.

There are several kinds of them, and there are more than 1,000 of them, and it should be down a lot now.

That's it! The pins of the CPU are all oriented, and you can see it if you look closely! As long as the orientation is correct, it will be plugged in by its own gravity!

Breaking two pins is a problem, unless you solder those two pins up, provided your CPU doesn't burn out! It is estimated that no one wants to fix the CPU now, and no one can fix it! Your 2800+ should also be changed, just don't go, don't come new! Hehe!

It's not saved.,It's still useful to connect the needle.,It depends on the situation.,If the needle is stuck in it and can't be pulled out.,Then even the console version will be still.。

Let's see if it's burned!? It is estimated that it is difficult to repair! Go to the computer city and ask if there is any need to repair it.

It's not so easy to break, as long as the pin is not broken, get it down, you install it on it and see if it can start normally, it's no problem.

You see if there is a reaction on it, if it's good, then congratulations, if it doesn't light up, it's a bad CPU, hehe.

CPUs are quite fragile, don't worry, you plug it in, it won't burn anything.

With silicone? Then you're basically finished, even if it's not deformed, there will be heat dissipation problems.

It may burn or it may be short-circuited.

Is the silicone in the stitch place??? Generally speaking, there is nothing important in the corners and corners. As long as you can put it in, there's no problem. The range of deformation is small.

There are several reasons for this. Caused by incorrect BIOS settings. Or the hardware is incompatible with each other or the workmanship quality is defective... You can restore the BIOS to factory settings first. If not, take it to the computer city to do a hardware test.

It's probably the problem with that. You can ask more about this. It is best to find your motherboard manufacturer's after-sales service. The average small shop is easy to hack you.

CPU fans generally rotate between 3000 and 8000 rpm. Your fan speed is too low! Still, you can test whether the temperature of the CPU is really high, and your CPU fan is estimated to be aging!

See you replace it, it's best to change it to a high-speed fan, at 4000-7000 rpm!

My fan is good, in the BIOS, the temperature rises straight up until it shuts down, and the radiator has been changed several times, which is probably a problem with the CPU, There is a picture to prove it.

This is the radiator, the contact surface between the cube CPU and the radiator. It's okay to touch it.

This is where the heatsink and CPU come into contact. It is mainly used for CPU heat dissipation, it doesn't matter if you touch it a little, as long as you don't have a large area that touches and touches the thermal grease on the surface (or the thermal grease on it is rubbed off, and then you want to apply it a little bit).

updata is an upgrade program.,It's hard to say what the specific program is upgrading.,If you think the computer is okay, you can stop it.。

Listen to you mean it's like this every time you turn it on, right? That is the program that cannot be upgraded, and you should end the process, open the task manager - process - select, and then click to end the process. However, if it is used by system users, it is best not to end the process directly, find the upgraded program, and choose not to upgrade or manually upgrade in the settings, otherwise it may damage important files and make the system unstable.

It's update. That's the upgrade procedure.

If you have installed 360, go to the process management to see if there are any abnormal processes.

Actually, I think your CPU temperature is quite normal.

CPU 70 degrees It's time for you to consider changing the CPU fan.

The ,,, of the upgrade program should be the automatic update of the system, as long as the automatic update is turned off

Viruses can't reinstall the system.

update is an upgrade program, and your machine seems to be poisoned, so let's kill the poison first. After eliminating the software problem, if the CPU temperature still can't go down, you can see if there is any problem with the fan.

It's update.

Look at the process name as an upgrader.

It is recommended that you use sreng to see what automatic programs are available at startup, and then check their security one by one.

Pay special attention to your UDATE program.

The CPU heatsink has broken for you, so buy a new one. The Ice Wind Flagship I bought before also had the side cover blocked, and then I hammered the side cover out of it. The one you cut is called a heat pipe, and if you cut it, it will break.

Have you tried to change the motherboard? Before you clean up, how much temperature.

The Core 2 5750 is good.

But it depends on the value for money.

Because it generally doesn't give full play to the performance of the CPU, you don't need to buy a CPU that is too good

The two performance T5750 are about 10% stronger than the latter, but the former is much more expensive, with four or five hundred.

In fact, the difference between general use is almost invisible.

It is recommended to buy 3200 which is cost-effective.

This is Intel's power-saving function, reduce the frequency to save power when the CPU is under low load, it won't have any effect, rest assured to use, I really don't want to be able to turn it off in the BIOS.

Huh, does your CPU support automatic frequency downscaling?

This feature is a feature that laptop CPUs have.

For example, my CPU can work in 1G and other modes to save battery, and the front of my computer shows the basic frequency, that is, the back shows the actual current frequency, such as whatever, lower than low, but not higher.

I wonder if the desktop CPU also supports this native CPU feature?

You don't have to worry about it.

It's automatic, like if you're playing a game, and it's working at full speed.

You put something down and leave it alone, and it comes down on its own.

CPU automatic frequency reduction, not to reduce the external frequency, but to reduce the frequency multiplier. If you don't want this feature, you can turn it off in the CPU advanced features. However, there is no need, as long as the CPU can't keep up with the speed slightly, it will work at full frequency immediately.

Oh, this is an automatic downclock, and the power options have been changed to home, office, or all the time.

Actually, to be honest, you must be stuck playing games with this configuration. Because the game is constantly being updated, the configuration requirements are gradually getting higher. The CPU temperature is a bit high.

I've used it before. With only 10 or so pieces, the cool temperature is about 40 degrees. See if there's something wrong with the silicone on the CPU.

Don't look at anything else, it's definitely a problem with the CPU.

The CPU is too rubbish and the estimated life expectancy is coming too.

Hurry up and sell 2 lots for a new machine.

The landlord also knows about the temperature problem! The temperature of the intel Pentium U is generally very high, and the landlord has not changed the fan for a long time! After getting a new fan and cleaning the case, you should be fine.

When you are playing a game, close other programs, otherwise you will definitely consume resources for other programs, and the running of programs will consume CPU and memory resources. Is your broadband installed? It is not excluded that the network itself is stuck.

There's no good way, the single-core Celeron CPU is too weak. The only thing you can do is close all the programs you can close while you're starting the game.

I have 1g RAM.

The other configurations are the same as mine, Magic Dawn 1 and 2 are available, and Titan Journey is also playing, and sometimes it gets stuck, and I guess the graphics card is too old.

Changing drivers doesn't have any effect.

The graphics card doesn't work.

Journey to the Titans, Dawn of Magic.

Don't open antivirus software while playing! Nowadays, the requirements for the machine are higher than before, and your problem is likely to be caused by the ...... caused by the operation of antivirus software

Dude, first of all, your processor is Celeron D331 graphics card FX 5200 This graphics card itself was a long time ago There is nothing wrong with the memory It's very big Secondly, the CPU wave you send ** is meaningless Like this old model of Celeron D331 running point big program is like this It's normal You say that your temperature is very high It is recommended that you open the case case It is best to tell the fan speed I hope it can help you!

Take a look at your CPU fan... The CPU is also not good.