The car clutch doesn t work There is a bit of oil leaking under the car

Updated on Car 2024-04-20
22 answers
  1. Anonymous users2024-02-08

    Hello, to be able to see the oil leakage under the car, the first thing to consider is that the clutch cylinder leakage, the cylinder leakage has drained the brake oil, it is definitely useless, it is recommended to check the clutch cylinder first.

  2. Anonymous users2024-02-07

    If the clutch of the car does not work, it is likely that the pressure plate or cylinder of the clutch is faulty.

  3. Anonymous users2024-02-06

    Hello, according to your description, the clutch caused by the leakage of the clutch cylinder of the vehicle does not work, it is recommended that you go to the repair shop to check whether there is a problem with the clutch cylinder!

  4. Anonymous users2024-02-05

    Hello, according to your description, the general reason for this situation is that there is an oil leak in the clutch sub-pump pipeline and master cylinder, which needs to be checked and repaired, the damaged parts are replaced, the clutch oil is replenished, and the air is completely exhausted.

  5. Anonymous users2024-02-04

    In this case, there may be a problem with the clutch cylinder, and it should be checked and repaired at the 4S shop or auto parts store in time to avoid affecting the normal use of the vehicle.

  6. Anonymous users2024-02-03

    Oil leakage may be clutch leakage, it is recommended that the landlord check the clutch three-piece set, basically this problem, change the words, will be replaced, otherwise it will lead to wear.

  7. Anonymous users2024-02-02

    Hello, this first check whether the brake fluid is missing or whether the brake fluid is leaking, if it is confirmed that the brake fluid is missing, it is the clutch cylinder leakage.

  8. Anonymous users2024-02-01

    Hello, this situation may be a problem with the clutch cylinder, it is recommended to check the clutch cylinder to see if it is broken.

  9. Anonymous users2024-01-31

    Hello, this check to see if the clutch failure caused by oil leakage from the clutch pump, if so, it needs to be repaired.

  10. Anonymous users2024-01-30

    Hello, there is no clutch, it should be the clutch cylinder leakage, to replace the clutch cylinder,

  11. Anonymous users2024-01-29

    Hello, this first needs to check whether the clutch cylinder is leaking, which needs to be tested.

  12. Anonymous users2024-01-28

    Hello, your situation is caused by a possible problem with your clutch, it is recommended that you go to the 4S shop in time to check.

  13. Anonymous users2024-01-27

    Hello, this clutch does not work may be a problem with the clutch plate and pressure plate, the oil leak depends on the gearbox or the engine, go to the repair shop to take a look.

  14. Anonymous users2024-01-26

    ClutchThere are three possible causes of an oil leak when stepped on.

    1. If the oil seal at the rear of the engine crankshaft leaks oil and the viscosity is medium, the right to leak out is the engine oil.

    2. If the transmission.

    The front oil seal is leaking and the viscosity is very high, and what leaks out is gear oil.

    3. If the clutch cylinder leaks oil and the viscosity is low, the leakage is the brake oil.

    When the clutch pedal is released, the pressure plate in the flywheel uses the force of the spring to press the friction disc tightly so that the two do not slide, so that the engine power can be transmitted to the gearbox through this structure.

    Complete the work of the power transmission. When the pedal is pressed, the structure pressurizes the spring, causing the perimeter of the spring to be cocked and the press to detach from the friction plate. At this point, the friction plate and the flywheel are no longer linked, and even if the engine continues to run, the power is still transmitted to the gearbox and wheels, allowing the driver to shift gears and stop without causing the Pibi engine to stall.

  15. Anonymous users2024-01-25

    1. Change the clutch.

    Causes of oil leakage under the car: The most likely cause is a damaged fuel tank, or a leak when delivering oil to the engine, or a slight damage to the engine.

    2. Oil leakage may be leaking out of the clutch, it is recommended to check the three-piece set of the clutch, which is basically this problem.

  16. Anonymous users2024-01-24

    A lack of oil in the clutch may result in the clutch plate not being able to completely disengage after pressing the clutch pedal.

    The clutch is located in the flywheel housing between the engine and the gearbox, and the clutch assembly is fixed to the rear plane of the flywheel with screws, and the output shaft of the clutch is the input shaft of the gearbox.

    Open the engine compartment cover of the car to check the oil volume of the clutch oil storage tank, if there is a shortage of oil, focus on finding out whether there is a leak along the oil pipe, and find out the reason for the decrease in oil volume. If there is no obvious leakage, check whether the gap between the separation bearing and the separation lever is too large, resulting in a large displacement of the working cylinder piston and rubber bowl, and an increase in the required oil.

    If there is no shortage of oil, the main reason is that the piston backup of the hydraulically controlled master cylinder and the cylinder barrel are worn, so that the matching gap is too large, and the piston is out of shape when it moves; The rubber bowl of the main cylinder is damaged and deformed, which reduces the sealing performance, causing the compressed oil to flow back to the back of the rubber bowl and piston, resulting in insufficient actual oil supply.

  17. Anonymous users2024-01-23

    Reason: If the clutch pedal of the manual transmission model is leaking oil, then it is very likely that the clutch master cylinder has leaked oil, because there is no oil above the clutch pedal, only a part of the clutch master cylinder with oil. The clutch pedal is most likely due to a clutch master cylinder leakage.

    Solution: It is better to repair it as soon as possible to avoid the problem of clutch failure due to lack of oil.

    It is used to transmit the torque stored on the engine flywheel to the gearbox to ensure that the vehicle transmits the appropriate amount of driving force and torque to the drive wheel under different driving conditions, which belongs to the category of powertrain. In the case of semi-linkage, the power input end of the clutch and the power output end are allowed to have a speed difference, that is, the appropriate amount of power is transmitted through its speed difference.

  18. Anonymous users2024-01-22

    1. There are three reasons for clutch oil leakage:

    1. The oil seal behind the engine crankshaft leaks, and what leaks out is the engine oil. The viscosity is medium;

    2. The oil seal in front of the transmission leaks, and what leaks out is gear oil, which has a high viscosity;

    3. The clutch cylinder leaks oil, and the leakage is the brake oil, which has a low viscosity. Second, the repair method:

    It is recommended to replace the assembly, the clutch cylinder oil leakage is caused by the wear of the piston in the clutch cylinder, the leather ring and the leather bowl, and the clutch oil can not be sealed, because now the clutch cylinder does not produce accessories, and the repair of the leather ring is not very easy to match, only the replacement assembly.

  19. Anonymous users2024-01-21

    What is the reason for the oil leakage of the clutch here The answer is as follows:

    Hello: If you're talking about an oil leak from the adjustment lever on the clutch pedal, it's a broken clutch master cylinder! If you're talking about between the gearbox and the engine, then lift the gearbox down and check it.

  20. Anonymous users2024-01-20

    The clutch master cylinder leaks oil, mainly because the piston seal inside is not tight, there is no problem to replace the clutch master cylinder, and then add hydraulic oil to drain the air, and it's good!

  21. Anonymous users2024-01-19

    There are three possibilities:

    1. The oil seal behind the engine crankshaft leaks, and what leaks out is the engine oil. The viscosity is medium;

    2. The oil seal in front of the transmission leaks, and what leaks out is gear oil, which has a high viscosity;

    3. The clutch cylinder leaks oil, and the leakage is the brake oil, which has a low viscosity. ‍

  22. Anonymous users2024-01-18

    Hello dear, the lack of power of the vehicle, or the inability to run up the clutch plate is directly related. First, if the clutch plate is worn and slippery, this will lead to serious vehicle failure behavior. Second, there is a very direct relationship between this correlation.

    Clutch plate wear and clump slip will cause the vehicle engine to rev at a high speed, but there is no associated speed output. Third, if this situation is not serious, it will be completely solved and the clutch three-piece set needs to be replaced to solve the problem. Hello, I hope I can help you, I wish you a happy life, good luck, eternal youth, if you have any questions, you can consult at any time, I will reply to you as soon as possible.

Related questions
7 answers2024-04-20

1.Find the right fulcrum of the left foot: It is not correct for some people to fix the fulcrum of their heel as soon as they get in the car and then move their toes or forefoot to find the control point. >>>More

8 answers2024-04-20

For manual transmission models, the clutch is an important part of the automotive power system, which is responsible for cutting off and connecting the power and the engine. When driving on urban roads or complex road sections, the clutch has become one of the most frequently used components, and the quality of the clutch directly reflects the level of driving and also plays a role in protecting the vehicle. How to use the clutch correctly and master the principle of the clutch to use the clutch to solve problems in special situations is what every driver of a manual transmission model should master. >>>More

9 answers2024-04-20

The clutch should be in linkage or semi-linkage.

First of all, it is necessary to judge whether it is really necessary to wade and drive according to the situation at the scene, and if you can make a detour, it is recommended to take a detour; If things are not urgent, it is recommended to go back and wait for the water to be small. You have to know that once you fail to wade through the water, the trouble and loss caused to you is huge. Once you fail to wade through the water, you have to organize a tow truck, contact a repair shop, find a friend for help, and a series of troubles, plus the cost of repairing the car is more expensive than if you were on a plane. >>>More

21 answers2024-04-20

Purpose: The pedal free stroke is to preventBrake padsand the brake disc is too tight and overheats, causing the brake to fail while setting the function. >>>More

13 answers2024-04-20

Adjust the push rod (long or short) on the clutch cylinder, the clutch of large vehicles generally has a release lever, and there is an adjustment screw on the top, generally a clutch has six screws, you can adjust the height of the six screws, and you can also adjust the pull rod on the rocker arm of the clutch release bearing.