Help.,Win7 is out of trouble halfway through.

The installation interruption cannot continue.

First,C disk points20G to win7 is more than enough,win7After the original version is installed, it will only occupy about 7G space,It has been installed many times, it is definitely not a blind estimate,Even if you patch it, it doesn't take up much,Other applications unless they are relatively large, such as office and photoshop, need to be installed in other disks to save C disk space,Other small programs can be installed directly to C disk。 In addition, you need to set the virtual memory (page file) to other drive letters and cancel the automatic sleep function of win7, according to your memory configuration, this will save 2-4G space for the future C disk (note: it does not mean that the 7G will be subtracted from 4G), so that at least half of the space of your C disk will be available, which is enough for the normal operation of the system.

How to set up virtual memory can be checked on the Internet by yourself,Cancel win7 automatic hibernation, please see the second article,About the problem of formatting,It is recommended to use a disc or U disk to start the way to enter the formatted C disk and then perform the installation,This is the most direct and safe,You can also choose to upgrade the installation to install it on the C disk when installing,But depending on the remaining space of the C disk, you may have to uninstall the software or something to make space,And the system will put the original files of the XP into an old folder and need to be manually deleted, In short, it is very troublesome. There are other methods on the Internet, but they are too troublesome to operate, you can use a search engine to search for keywords such as "hard disk installation win7" to find. If you start with a disc or U disk, it is best to use a PE system, but it should be noted that it is a PE system with a kernel of Win2003 or above, otherwise it may not be possible to execute Win7 security.

The reasons and solutions for half of the system crash are as follows: 1. The computer system space is insufficient, for example, the C disk is a system disk but the space is only 15G, and the space required for Win7 installation is 25G space for the 32-bit system. A 64-bit win7 may require more space.

The solution is to increase the partition of the system disk, and it is recommended that the size of the system disk be more than 50 Gbit/s.

2. The computer is poisoned, and some stubborn viruses are not cleared, and the virus interferes with the reinstallation process when reinstalling the system. The solution is to use a memory virus killing tool to see if there are any viruses in the memory. When the system is reinstalled, use the diskgen partition tool to format or repartition the disk, which can remove viruses from the hard disk of the computer (don't forget to get the data out when you have important data).

3. There are problems with the installed medium itself, such as scratches on the CD, poor quality of the USB flash drive, etc. The solution is to replace the installation medium with a new one.

5. The hard disk boot mode of the BIOS is incorrect, and the AHCI is modified to IDE. Install it and change the IDE to ahci. For details, please refer to the BIOS settings of your computer.

6. The reinstallation interruption caused by hardware problems such as memory Qi Chong is generally concentrated in the memory. Remove the memory, wipe off the prongs with a paper towel and put it back in.

Force restart, if it still can't be opened, you can only reinstall.

Notebook? Is the original system win8?

Output the error file to the following location a:

Generally, there are several situations where A: Error occurs:

2.Disc quality: The recovery failed due to the purchase of the disc or the quality of the burning disc.

3.Optical drive quality: The recovery failure is due to the aging of the laser head in the optical area and the decrease in the ability to read the disk.

4.Recorder: The recovery fails due to the poor recording quality of the recorder or the quality of the burned disk due to aging.

5.Burning method: The disc is not easy to read due to the burning speed being too fast, it is recommended to choose 16x 24x speed to burn at a time.

6.Over-burning: Recovery failure caused by incomplete data due to exceeding the capacity of the burning disk, which is generally suitable within 680m.

7.The hard disk has bad sectors: The ghost cannot be written because of bad sectors.

8.Hard disk problem: Format the C drive completely, do not add Q (e.g. format c:).

9.Hard disk without drive letter: Recovery failure caused by virus or other loss of partition table.

10.Overclocking: Recovery failure due to unstable overclocking.

If you still have an error in reading the disk despite the above issues, it may be another hardware issue. A complete hardware system is made up of many parts, which are an organic whole. If the quality of a key component is unstable, the whole machine will run unstable.

Running ghost on such a system will naturally go wrong. As a rule of thumb, the memory should be suspected in the first place, and the memory should be replaced. Compatibility of two-strip memory.

Second, check the motherboard, hard drive (and its data cables), and then pay attention to whether the CPU is generating normal heat. Since everyone has their own experience and approach, here is the only point.

This problem exists on many brand machines, hiding a partition installed by the manufacturer before the main partition for the whole machine system detection, so you should pay attention to this problem when performing ghost on the brand machine.

Happy every day!!

It should be that there is a problem with your installation file, how did you install it? Genuine or pirated? Disc or USB flash drive installation?

An unexpected reboot indicates that the system installation has failed. Only enter the PE system (CD-ROM or U disk) for installation, after entering the PE, format the system disk first, and then start the system installer for a clean installation.

Stopped working workaround:

1. Close or uninstall the antivirus and optimization software, uninstall the latest updated system patches, and install back to the official driver.

2. If this problem always occurs in a single program or game, please change it to an English installation directory or install it once according to the program's default C drive, restart it and use it again.

3. Close UAC, right-click on my computer, enter management, local users and groups, users, administrator, remove the disabled hook, and log in This is the computer super administrator account, not restricted by UAC, the highest authority.

4. Right-click on Computer-Properties (if there is no computer option, you can let the user start -Computer-Properties in the lower left corner), and select Advanced System Settings in the upper left.

5. Select "Advanced", then select "Settings" in the performance bar, select "Data Execution Protection", select "Enable dep(u) for all programs and services except the selected programs listed below", and then click "Add" below to select the program from the hard disk.

1. Question 1: My computer shows up in the quick start bar.

Solution:

You can do what you want by changing the taskbar Explorer to open My Computer (Computer) by default instead of Library.

Function. Steps:

Hold down Shift and right-click the Explorer icon to open a blind window. Add ", a space, and a comma after the content of the target box). OK.

2. A large space on both sides of the clipboard content is displayed in full screen.

Solution: Start WordPad, in the WordPad toolbar, in the drop-down triangle option on the right side of the [Auto Wrap] button, change the default [Auto Wrap by Ruler] to [Auto Wrap by Window Size].

Hope the above helps.