How much should such a configuration cost 160G hard disk 30

How good the 915 motherboard can be matched, this is a single-core to dual-core transition main analysis, this motherboard can only use the D series of CPUs, the Pentium D is gone, at most it will use Celeron D, giving you the highest configuration suitable for this motherboard.

CPU: Celeron Dual-Core).

Memory: Kingston 1G*2 (533) (this board supports dual pass, giving you two 1G memory dual pass, and it doesn't make sense to add more).

Motherboard: 915 (use the one you chose).

Hard disk: WD160G

Graphics: 7300gt

Display: AOC916SW (19 inch LCD).

Xingu chassis power supply.

Photoelectric sleeve. 2900 must have been taken.

If you want to have such a computer now, you might as well add another 500 and buy a good one. Such a configuration is outdated. If you're going to sell, the display is flat, that's up to 1500.

I guess you don't know anything about computers Copied this From the information you gave, it's a 915 motherboard DDR2-533 512MB memory ATI X550 graphics card But I don't know what a CPU is, according to my estimates, the CPU is not much better 2000 or less than 1000 points if you have 2 hands, the new one is 2000, but the new one is basically gone.

It's funny.,Why does the landlord give a detailed parameter of the motherboard? Then I asked the ** of the whole computer?

The model is older and can't keep up with the times, so it is recommended to change the configuration!

2 lots are worth up to 800! I.

The hard disk of the notebook is inches, and the special models also use inches, and the desktops are inches.

The ** of a laptop hard drive depends on the brand (Hitachi, Toshiba, Fujitsu, Samsung, Seagate, etc.), capacity), single disk capacity), RPM (4200 5400 7200).

The hard disk used as a notebook must be built-in,Put it outside the computer can only be called a mobile hard disk,It's just that some of the notebook hard disks are better to replace without dismantling,Now most of the notebook hard disks have to be disassembled。

The 160G notebook hard disk you said, at present, it is more mainstream and cost-effective, and the 5400 rpm hard disk with a single disk capacity of 80G, the optional brands are Hitachi (recommended to use), Samsung (**cheap), etc., the new ** should be about 500-800, 7200 rpm is more expensive, in addition, we should pay attention to the difference between the hard disk interface, the interface has the difference between IDE and SATA.

For example, if you buy a 40GB hard drive, but the actual usability may only be 38GB, why is this? The reasons can be explained in the following aspects:

Manufacturers generally calculate capacity at 1000K bytes per megabyte, while most motherboards use 1048K as one megabyte for BIOS and test software. This results in a difference of about 5 per cent.

The capacity of the hard disk is divided into the physical disk capacity calculated purely by the number of heads, the number of cylinders and other physical parameters, and the actual available space after partitioning, formatting, etc., and the capacity of the hard disk is not the same under different operating systems.

Selecting different working modes (normal, lba, large) in CMOS may also cause capacity inconsistencies.

Due to the influence of these factors, generally speaking, it should be normal for there to be a gap of about 5%-10% between the test capacity of the hard disk and the nominal capacity.

Manufacturer calculation method: 80g 80 * 1000m 80 * 1000 * 1000k 80 * 1000 * 1000 * 1000b

Computer conversion to: (80*1000*1000*1000)b (80*1000*1000*1000) g