Is there a problem with the humidifier running on and running out of water, with a red light on, and

No. When humidifiers.

If there is no water, the machine will automatically cut off the power and there will be no dry boiling. However, some humidifiers only cut off the electricity of the atomization part to protect the life of the main components, and the fan of the humidifier will still run, but this does not have much impact on safety, but it only consumes electricity, and the power of the humidifier is not large.

The humidifier is on, but there is no water inside, and there is no problem if the red light is not turned off, because the humidifier has a setting that automatically monitors the water level. If the water in the humidifier is below the safe level, the humidifier will automatically stop working. A red light just indicates that you have run out of water and need to add water, but it will not cause a fire hazard, but for safety reasons, try to remember to unplug the humidifier in advance.

Hello: The humidifier itself has [No water protection functionWhen there is no water, the ultrasonic circuit will stop working, but other circuits are still running with power (such as indicator lights), existingAll sorts of accidentsIn the event of a situation, if the mains voltage fluctuates, there may be an accident, and when no one at home is not in use, you should disconnect the power supply and pull out the plug.

I often forget to add water, and the red light is on.

Then turn it off for up to 24 hours, or add water.

And then it's fine.

So it won't be long, it should have a protective device, it won't break, and it's okay to turn off the power immediately when you get home.

The humidifier will stop automatically when the water runs out.

The general household humidifier has a float sensor with a magnet, and a reed tube is matched with it, which automatically monitors whether there is a lack of water, prevents the ultrasonic humidifier from being damaged, and will automatically stop when the residual water reaches below the safety water line.

If there's no water, you should stop, it's useless to turn it on.

The clip of the humidifier sink is too tight, resulting in the water level float not reaching the height it should be, so the water level sensed is very low, and if the water level is low, it means that there is a lack of water, which will trigger the water shortage protection and the red light will turn on.

Solution: Take the card off and try to re-card it, being careful not to tighten it too tightly.

2. If the clip is loose, there will be a situation where the induction water level is too high, and there will also be a situation where the water is bright and red.

Solution: Make the card a little tighter.

3. If the tightness of the clip is appropriate, and the water level float normally, or the red light is on, it is likely that the float is reversed.

Solution: Turn the water level float over.

4. Bai is protected from normal water shortage, the red light is on, and there is still water in the water tank, but it is just a lack of water.

Solution: You only need to add water and switch it on and off again.

Extended Materials. 1 The first use should be placed at room temperature for half an hour before turning on the machine.

2. The ambient temperature is 10-40 degrees.

3 Use clean water at a temperature below 40 degrees.

4. Keep away from other household appliances when the machine is working.

5 Do not add additives to the water that are not manufactured by the production line or supervision.

6 Do not place the humidifier on a hollow object to avoid collusion.

It belongs to the normal water shortage protection, the red light is on, and there is still water in the water tank, but it is just a lack of water. It is recommended to only add water and switch it on and off again.

There is no single change in the duration of use of the humidifier, and it is best to decide the length of the boot time according to the temperature and dryness of the room. It is best not to use the humidifier continuously, and it is best to use it disconnected. If you stay indoors as a whole, it is recommended to stay indoors for 2-3 hours in the morning, 2-3 hours in the afternoon, and then open for another 2-3 hours before going to bed at night, and the indoor humidity is maintained between 40%-50% The human body feels the most comfortable.

The lack of water should be caused by the careless swing of the humidifier, and the water in the humidifier will fluctuate, so the sensitive automatic power-off sensing device will sense the rise and fall of the float. The humidifier will only humidify quietly when the test is performed at a standstill.

First, let's see if you're misplacing the water. Instead of pouring water directly from the water mist outlet, the humidifier needs to unscrew the lid on the bottom of the tank to add water.

Secondly, observe whether the water tank is well placed and whether water is injected into the atomization zone from the tank. Sometimes, if the tank is not placed properly, the ejector rod of the tank will not touch the spring mechanism and the water will not flow out of the tank into the atomization zone. Naturally, it will show a lack of water.

Check again that the lower float is flat and not floating. Sometimes, the float gets stuck inside the tank during transportation. Gently move it so that it returns to the positive position.

Precautions for the use of humidifiers.

It is important to note that tap water cannot be added directly to tap water, which usually contains a lot of minerals that can damage humidifiers and air pollution, so it is recommended to use pure water.

Clean regularly. If you use the humidifier for a long time, all kinds of bacteria can grow inside. If not cleaned regularly, bacteria will enter the air with water vapor and cause some harm to the human body. It is best to wash once a week and change the water every day to prevent the spread of microorganisms in the water into the air.

After the circuit board sucks the fog, it forms scale, and the scale conducts the circuit on, as long as the toilet cleaner is smeared on the circuit board for three or four minutes, it is cleaned and dried with a hair dryer.

The first reason is that the clip is too tight, resulting in the water level float not reaching the height it should be, so the water level sensed is very low, and the low water level means that there is a lack of water, so there is a red light for water shortage.

The second reason is that the clip is too loose, and the water level sensed at this time is too high, which will also occur, and the solution is to make the clip slightly tighter.

The third reason, if the clamp is properly tightened, the water level float normally, or the red light is on, you can try to turn the water level float over, that is, the original upward side is now facing down, and the red light spray is very small.

If it is caused by water blockage, add a little vinegar and boil to remove the water block.

1. The water tank is short of water, and the water can be added to work normally.

2. The fog outlet is blocked, and it is necessary to use needles to dredge the fog outlet of the humidifier.

3. The fan in the humidifier does not rotate, so the mist cannot be sent. This situation requires access to the fan in the humidifier.

4. If the atomizer does not work normally, check whether the gold plating layer of the atomizer falls off, if it falls off, it needs to be replaced with a new atomizer; If it does not fall off, clean the scale on the nebulizer sheet.

As follows:

1. The water tank is short of water, and it can work normally with water.

2. The fog outlet is blocked, and it is necessary to use needles to dredge the fog outlet of the humidifier.

3. The fan in the humidifier does not rotate, so the mist cannot be sent. This kind of burial condition requires access to the fan in the humidifier.

4. If the atomizer does not work normally, check whether the gold plating layer of the atomizer sheet falls off, if it falls off, it needs to be replaced with a new Songzhuan atomizer; If it does not fall off, clean the scale on the nebulizer sheet.

Humidifier precautions:

1 The first use should be placed at room temperature for half an hour before turning on the machine.

2. The ambient temperature of the use is 10-40 degrees.

3 Use clean water at a temperature below 40 degrees.

4. Keep away from other household appliances when the machine is working.

5. Do not add additives that are not professional production lines or supervised production lines in the water.

6. Do not place the humidifier on a hollow object to avoid co-frequency resonance noise.

Summary. The reason why the humidifier lights up red and does not fog out is because 1, the reason why the red light becomes bright but does not fog is mainly due to the lack of water in the water tank, which is one of its intelligent designs, and it is also a function that many humidifiers have. 2. If it is not foggy after adding water, it may be caused by factors such as the first piece stuck, the atomizing sheet is broken, the fan is broken, etc., first clean the water alkali on the first piece, and then add some lubricating oil to the first piece and the fan to try to turn it on, but if it still doesn't work, you can only replace the atomizing sheet or fan, and let the after-sales treatment at this time.

3. When the humidifier does not fog up, in addition to adding water and cleaning, you should also pay attention to its correct usage, as well as the meaning of the different indicators on it, so that you can use it correctly, because each indicator light will prompt different functions, and it will be better to combine the prompts when using them.

The reason why the humidifier lights up the red light and does not fog out is because 1, the reason why the red light becomes bright but does not fog is mainly the lack of water in the water tank, which is one of its intelligent designs, and it is also a function that many humidifiers have. 2. If it is not foggy after adding water, it may be caused by factors such as the first piece stuck, the atomizing sheet is broken, the fan is broken, etc., first clean the water alkali on the first piece, and then add some lubricating oil to the first piece and the fan to try to turn it on, but if it still doesn't work, you can only replace the atomizing sheet or fan, and let the after-sales treatment at this time. 3. When the humidifier does not fog out, in addition to adding water and cleaning, it is necessary to pay attention to its correct use, as well as the meaning of the different indicators on it, so that it can be used correctly, because each indicator light will prompt different functions, and it will be better to combine the prompts when using them.

Extended InformationA humidifier is a household appliance that increases the humidity in a room. The humidifier can be used to humidify a designated room, or it can be connected to a boiler or air conditioning system to humidify the entire building. The development of the humidifier industry in China has a history of nearly 20 years, and after years of popularization of air quality concepts, product research and development, and market cultivation, the function and role of humidifiers, a relatively unfamiliar small household appliance, have gradually been accepted.

The red light of the humidifier is on: go back and try these methods, the first reason is that the clip is too tight, resulting in the water level float can not reach the height it should be, so the water level sensed is very low, and the low water level means that there is a lack of water, so there is a red light and water shortage protection, (the solution, take the card again, try it on the card, don't be too tight). The second reason, the card is too loose, the water level sensed at this time is too high, this situation will also occur, the solution, let the card card be slightly tighter The third reason, if the clamp is tight, the water level float is normal, or the red light is on, you can try to turn the water level float over, that is, the original upward side is now facing down, try, the red light spray is very small is generally these 3 reasons.

I consulted Yadu customer service, if there is no problem with the float, then drop a few drops of vinegar into it, and then press the float for a while, this is how I got it.

No. When the humidifier runs out of water, the machine will automatically turn off the power and there will be no dry boiling. However, some humidifiers only cut off the electricity of the atomization part to protect the life of the main components, and the fan of the humidifier will still run, but this does not have much impact on safety, but it only consumes electricity, and the power of the humidifier is not large.