How do you break your computer without dismantling it? And I can t find out what I think.

Is it that boring that you want that part of your computer to break?

I want the system to be broken, and I try to delete the things in the windows file of the C drive.

If you want the hardware to be broken, you will create a short circuit.

Paralyze the system, frequently turn on and off the hard disk and CPU

Increase the voltage with a transformer.

Very simple. Method 1: After booting up, press del to enter the BIOS settings, then adjust the parameters of the items that can be adjusted to the highest, save, restart, and burn the CPU or make the motherboard capacitor burst within minutes after booting.

If you can't run BT, emule, and other resource-intensive files, you should be able to "kill" the computer in a few seconds.

Adjust the CPU voltage and frequency to the highest at one time, and the motherboard does the same, ensuring that the life of the main computer accessories is quietly ended in a few seconds (and basically does not harm the hard disk platter data, which can prevent the loss of important data).

As for the hard drive, it is much easier to damage it than to get rid of the CPU, and to suddenly move the computer out while the hard drive is reading.

The size of the ** can be.

Or some computer viruses can directly burn the hard disk when they run, or you can go down and play around.

Hehe, just burn the motherboard. It's such an old book.,It's not easy to match the motherboard when it's burned.,It's not cost-effective to repair.。

Isn't it possible to tear down the memory warehouse?

1. Remove the memory.

2. Then connect the power supply to power on.

3. Take tweezers, screwdrivers and other metals and slide them back and forth on the pins of the memory slot, the purpose is to short-circuit the voltage point and location in them, and burn the motherboard north bridge! Until it can't be turned on.

4. Put the memory back and you're done.

It is best to slip a few feet on the edge, so that people who repair it will think that the memory is not in contact with the memory and causes a short circuit. The memory and hard disk are not a set of voltages, nor are they controlled by a bridge, so they will not burn the hard disk.

Hey, how's that going to work?

I draw the high voltage in the electric mosquito swatter into the socket of the memory and discharge it. The laptop is broken, and the computer repairer can't find out that it's done by man. The hard drive can be taken down in advance, but the 7-year-old hard drive is almost worn out, and it's time to replace it.

Pour some water into the keyboard.,It's OK to turn on the machine.,Don't have too much.,It's not good to pour it into the hard disk.。

If you connect the 380V electricity, it will break down all at once. If you can't see it, if you see it, you will say that the voltage is unstable

Work the memory warehouse...

In fact, put a little water in the position of the processor or memory module graphics card slot and turn it on, which will cause a short circuit.

Rough square bai style, smashed with an iron cone, if du guo is like this, it is estimated that your old zhi mother should take an iron cone to smash you, dao hehe. Edition.

Gives you several ways to use the right at the same time.

Don't be too ruthless. 1. At the same time of the computer network game, unplug the power cord behind the computer host by hand, repeat about 10 times, the hard disk must hang, the fault phenomenon is the blue screen of boot or can not enter the system, the system reinstallation is useless, the serious thing is that the hard disk can not be recognized when booted, if you buy a new one, you need about 400 pieces.

2. Open the panel on the side of the case, find the memory, plug it in the other way, turn it on, smoke, the memory gold finger part will be burned out, and the memory slot will also be burned out, boot, alarm, and it is useless to change the memory.

3. With a glass of water, in the case of the computer shutdown, pour down the power supply and the motherboard part, turn on immediately, the computer can not start, the circuit board has been damaged, after 20, the traces of splashing water are difficult to see.

4. The smart approach is to glue the restart button next to the host switch with 502 to prevent it from popping up, that is, press it without response, at this time, turn on, the computer will display it and automatically restart, repeatedly.

The above methods are the next policy, it is strongly recommended that friends, and my mother communicate well, since I let me play, I will get some good computers, otherwise I go to the Internet café every day, this said, 80% of parents will worry about the environment and safety hazards of the Internet café, do not worry about the child to go, obediently according to your requirements to change a good computer. I wish you success!

Eh, I'm speechless, this configuration sucks, right?

I teach you that when starting, press the del key and then quickly press the power button.

Take advantage of this weather to open the computer and dry it out.