-
If the meter indicator light is not on, first check the power supply fuse of the dashboard.
If the circuit breaker. will need to be replaced. Disassemble the dashboard, the lights are generally at the back of the dashboard, replace the lights that are not lit, and generally the individual lights are not lit to indicate that there is no problem with the fuse and wire, the main reasons are as follows
1. The lamp of the dashboard is damaged and needs to be replaced in time;
2. If the power supply line of the dashboard is broken, there will be an open circuit or a short circuit, which will also lead to the car dashboard.
There is no light up;
3. If the power supply fuse of the car dashboard is broken, there will naturally be no power supply, and the dashboard will not light up.
Precautions in the use of the car dashboard:
1. When the indicator light is on, the odometer should be observed immediately, if the cumulative mileage reaches or exceeds l00,000km, the timing toothed belt must be replaced, otherwise the timing toothed belt may break, so that the engine can not work normally.
2. After replacing the new timing toothed belt, it is necessary to open the rubber plug outside the reset switch on the mileage dial, and press the reset switch inside with a small round bar to extinguish the indicator light of the timing toothed belt.
3. After replacing the new timing toothed belt, remove the odometer and adjust all the readings on the odometer to the 0 position.
-
Hello, if you put the headlight switch in the auto gear, it will definitely not be lit, only at night he will, he is automatically turned on the meaning, it will naturally light up when it gets dark, and you need to turn on the small light if you want the instrument to be bright!
-
It is recommended to go to the 4S shop for maintenance, and clear the maintenance mileage after maintenance! Next time the lights come on, I'll do the maintenance! Professionalism makes dreams come true, and technology helps you succeed! Hope to adopt, thank you!
-
To maintain the lamp, it needs to be serviced and zeroed.
-
Honda CRV dashboard shows not working 4S shop repair.
1. Red light hazard warning light:
Different red lights correspond to different situations, which can have a huge impact on driving safety.
2. Pressure warning light of engine oil:
If the pressure warning light of the engine oil is lit, if you continue to drive, it will cause significant damage to the engine, and the direct consequence is that you cannot drive at that time, and it will lead to a lot of maintenance costs.
Note: Although there are many types of vehicles, the structure is similar. This should be said to be the credit of standardization, but also the need for large-scale production lines.
With the development of society, the progress of science and technology and the change of demand, the shape of railway vehicles has begun to change, especially the passenger car is no longer the same old face. However, their basic structure has not changed significantly, but the specific parts have a more scientific and advanced structural design.
Generally speaking, the basic structure of the vehicle is composed of five parts: the car body, the undercarriage, the running part, the coupler buffer device and the braking device.
The body is the part of the vehicle that is used to load goods or passengers, and is the basis for the installation and connection of other components of the vehicle. The body of the early vehicles was mainly made of wood, supplemented by steel plates, bow rods, etc. In modern times, the car body is mainly steel structure or light metal structure.
-
It's good to open, and it's raining heavily, but it's raining, and nothing exists.
-
My problem is the same as yours, I'll go find a master in a while.
-
My CRV is exactly the same as you were last year, and the meter doesn't show up completely after the rain. How did you solve it in the end?
-
If it's flooded, just change it.
-
The reason why the Honda CRV car system information light is on is that the seat belt in the driver's seat or passenger seat of the car is not fastened.
The solution is: fasten the seat belts in the main driver's seat and the passenger seat of the Honda CRV car to eliminate the car system information prompt sleepy rough lights, even if there are no passengers in the passenger seat, you need to wear the seat belt.
The reason why the Honda CRV system information light is on is also that the fuel tank of the car may have reached the lowest state, or the door of the Honda CRV car is not closed tightly when you get into the car. Check the possible causes above to rule out the problem with your car's information light.
Expansion of the capital Wang Sui Zhen material:
The power configuration of the Honda CRV car is as follows:
The all-new CR-V is still powered by the i-VTEC engine, but the maximum engine power has been increased from 110kW to 114kW and from 125kW to 140kW under the retuning, mated to a modified 5-speed automatic gearbox.
Effectively control the excess fuel consumption caused by the driver slamming on the accelerator, and at the same time can also adjust the refrigeration condition, so that the air conditioning is in the best energy-saving state, so as to reduce engine energy consumption and achieve power efficiency, the data shows that the new two-wheel drive version and four-wheel drive version of the comprehensive working condition fuel consumption is only per 100 kilometers.
-
Summary. The reasons for the instrument failure light to be fully lit: 1. The CAN bus of the ECU is faulty, and the CAN interface of the ECU is not in good contact; 2. Excessive dirt and carbon deposits, abnormal air circulation, unable to accurately control the normal air intake, resulting in unstable gas content and unstable engine.
Works well; 3. The low fuel pressure and poor constant pressure performance lead to a low level of system atomization, which makes it difficult for the car to start. The car dashboard is a device that reflects the working conditions of each system of the vehicle, and the instruments of different cars are different. The indicators or warning lights in the instrument panel include coolant level warning light, fuel level indicator, washer liquid level indicator, charging indicator, high and low beam dimming indicator, transmission gear indicator, brake anti-lock braking system indicator, drive force control indicator, airbag warning light, etc.
What's going on with the Honda CRV meter failure light all on?
The reasons for the instrument failure light to be fully lit: 1. The CAN bus of the ECU is faulty, and the CAN interface of the ECU is not in good contact; 2. Excessive dirt and carbon deposits, abnormal air circulation, unable to accurately control the normal air intake, resulting in unstable gas content and unstable engine. Works well; 3. The low fuel pressure and poor constant pressure performance lead to a low level of system atomization, which makes it difficult for the car to start.
The car dashboard is a device that reflects the working conditions of each system of the vehicle, and the instruments of different cars are different. The indicators or warning lights in the instrument panel include coolant level warning light, fuel level indicator, washer liquid level indicator, charging indicator, high and low beam dimming indicator, transmission gear indicator, brake anti-lock braking system indicator, drive force control indicator, airbag warning light, etc.
What happened to my car, except for the fault lights that were all on, turned off in the middle of the game, and then started again?
In this case, it means that your car really has a certain fault, it is recommended to go to the 4S shop to decode with a decoder to see the specific fault in **.
-
Reasons why the Honda CRV dashboard lights up yellow: 1. Sensor problems, when the sensor is in poor contact or the signal is interrupted, the ECU of the car cannot accurately obtain the engine data, which will cause the engine fault light to light up; 2. Maintenance problems, the yellow light on the dashboard is due to the long-term use of the maintenance has not been carried out; 3. If the throttle is dirty and a cylinder is not working well, it is necessary to check and replace the spark plug and the chain ruler cylinder line, oxygen sensor, and check the three-way catalytic fault.
Honda CRV Fault Lamp** Daquan Instruction Manual Basically the indicator lights are divided into four categories: 1 The red indicator light means a warning, and at this time, the driving should be stopped immediately and repaired.
2 The yellow indicator light represents an early warning, but it is also necessary to deal with the corresponding problem in a timely manner.
3. The blue indicator light makes the owner vigilant and pays attention to whether the corresponding function is caused to other vehicles.
4. The green indicator light is a functional light, such as low beam, width indicator light and turn signal.
The following is a description of the Honda CRV indicator**.
4. The indicator light of the cleaning liquid level is on, which means that it is time to fill the cleaning liquid to the window glass or headlight cleaning device.
5. The thickness of the brake friction plate becomes thinner, which no longer meets the brake requirements and must be replaced in time. Generally, the left and right wheel friction plates of the same axle are replaced at the same time. The steering wheel of the steering lock system is locked, indicating that there is something wrong with the steering system.
Special care should be taken not to tow the vehicle forward at this time, otherwise the road section such as turning will cause danger. There are two reasons for this air pressure monitoring system in the tire filler: one is that the air pressure drops or expands due to the tire nail, and the other is that the new information is forgotten after the tire is replaced, and the system has not yet recognized it.
The electromechanical parking brake lights up when the handbrake is tightened and turns off when it is lowered. The indicator light flashes continuously, indicating that the braking force is not enough to prevent the vehicle from moving due to trapping.
Photo by Q&A) @2019
Didn't unlock the anti-theft look.,One-click start?。
Check whether the battery clip is loose and check whether the battery has electricity.
One: Is the steering wheel in a deadbolt state? The solution is simple, as long as you hit the steering wheel hard and twist the key at the same time, you can generally unlock the steering wheel lock quickly, and the ignition is an instantaneous thing. >>>More
Generally speaking, there are two possibilities for the EPC light to be on. First, the throttle is dirty and should be cleaned. Another situation is that the brake light is not on, and you need to check the brake switch as well as the wiring. >>>More
Hello, according to your description, this is a normal phenomenon, because the engine failure lights of the burning car have to be lit. Usually, there will be a failure of the oxygen sensor, which is normal, don't worry, just use it with confidence.