How to use a router to connect two computers with a base top fit

If you are a set-top box given by Telecom, then you should use the wireless cat that Telecom gave you!

There are 4 jacks behind the wireless cat, and the set-top box must be plugged into the general second port ITV port (it used to be plugged in casually, but it won't work after the telecom upgrade) If you handled it before, you may also need telecom staff to call ** to the computer room to bind the set-top box port 8 35 ports, you can.

Hope it helps!!

I'm broadband for telecommunications. If you're also a telecom broadband, you can be remote, Netcom won't work. Connect the router to your network.

a First, connect the AC power adapter that comes with the router to the rear panel of the router; Then plug the adapter into your power outlet. The power LED on the front panel of the router lights up, indicating that the operation is correct.

b Plug one end of an Ethernet cable into the WAN port on the rear panel of the router and the other end into the Ethernet port on your DSL cable modem. The LED indicator of the WAN port on the front panel of the router is lit to indicate that the operation is correct.

c Plug one end of the other Ethernet cable into the LAN port on the rear panel of the router and the other end into the computer network card you used to configure the router. The LED indicator on the LAN port on the front panel of the router is on, indicating that the operation is correct. How to set up your router:

1: Look at the gateway of the route (there is a write on the back of the route). Then, set the gateway of the local IP address to be the same as the routing gateway. At this point, the route is connected, and the local connection is connected.

3: The user name of the route is generally admin (a few routes can be changed to other in the settings), and the new route password is generally admin or empty.

4: After entering, you can generally fill in the setup wizard, mainly set the broadband account and password, select the PPPoe dialing method, automatically connect, and turn on the DHCP server

Or if you don't go to the guide, you can directly set DHCP (the route of Dlink) on the WAN port, and remember to save the network parameters (WAN settings) and DHCP settings (the route of TPLINK) after setting.

In general, the router connects to the cat, the router dials, and the computer connects to the router. There should be in the manual, I hope LZ can learn it well, it's not difficult.

You can set the next route. QQ remote is accepted.

The router manual is very detailed, I don't know if you are a new router.