How to connect two computers to one router

You use the address bar of the web page to type in Settings!Steps: Connect the configured cable (C line) to computer A, set the IP and DNS of computer A to automatically surf the Internet, confirm that computer A can access the Internet, check the MAC of computer A, the method is the same as above, assume that computer A MAC (00-15-c5-66-0a-bf) In the second step, there are five interfaces on the router (five-port router), 1,2,3,4,WAN, five interfaces, 1 to 4 is the intranet interface, WAN is the external network interface, A computer is connected to the C line (wired network cable), dial it down, connect it to the computer with a network cable, and connect the other end to any interface of the router 1 to 4 (can not be connected to WAN) , and then set the IP of computer A to the same network segment as the router, the default IP of the router is, that is, the IP of computer A is set to, the gateway and DNS do not need to be set, if you set it in this way, enter it in the address bar on computer A, you can log in to the router settings page, note, these operations are on computer A, as for why, let's talk about it below.

Then take a closer look at the router settings page,There is a "network parameters" on the left,Open,MAC address copy will appear on the right,The upper line shows the MAC of the router,The next line is the MAC of our A computer,If not,Start again from scratch or replace it with B computer to do it (replace all the A on the top with B to do),It is to make sure that the MAC in the next row is the MAC of the current computer,Then click on the coin in the upper row to copy the MAC,Then click Save to restart the router。 Proceed to the third step;Now computer A and the router are connected by a network cable, dial it down, connect the C cable (that is, a wired line that can access the Internet) to the WAN interface of the router, and then find two network cables to connect to any two interfaces of the router 1 to 4, and then connect these two lines to computer A and computer B. There is a place to pay attention to here, that is, the MAC of the two computers can not be modified, and then set the IP, the router A computer IP party gateway, DNS preferred alternative, B computer settings are the same, The IP is the same as the A computer, and you can access the Internet.

The output port of the cat is connected to the input port of the router, and the output port of the router is connected to the network card interface of the two computers through the network cable. Then enter the routing settings interface, enter the account number and password, and select Auto Connect.

Connect the cable of the AD modem to the WAN port of the router!The computer is connected to the LAN port!!If it's adsl!

Enter the PPPoE link mode!Enter the account password given to you by the operator and you're good to go!! The local connection of the computer is well selected, and the IP address and DNS are obtained automatically.

Set the username and password in the router.

There is a manual on the router! You take a closer look!!