-
There are many cases of slow network speed, how long did the landlord use 2m before? Was it just as slow before?
If it suddenly slows down, you can check and kill computer viruses and do regular system maintenance.
If it still can't be solved, you can contact the local broadband operator to report the broadband fault, and let professional personnel check and repair the line.
-
Is it a computer virus again, clean up the computer with a super rabbit, it should be good.
-
Telecom ADSL broadband speed, 2M telecom ADSL can be increased to 6M, household fiber can be increased to 30M, permanent valid, pay once, can be increased first and pay later.
-
Unicom or China Telecom ? Unicom is like that, if it's telecommunications, find them to fix it.
-
Is radio and television not easy to use? Then it's time for me to think about whether or not to pretend.
-
Telecom is still mobile, mobile is better not to use, cheap network is rotten, playing games old packet loss.
-
Take the win10 system as an example, if the network is not good, you can solve it in the following ways:
1. First of all, check whether it is a problem with the network itself, whether the broadband bandwidth is too small, whether the network transmission is stable, and it is best to go to the regular business hall to handle the broadband that suits your needs.
2. It is best to apply for exclusive broadband or optical fiber, although shared broadband seems cheap and the bandwidth is large, but the network speed is unstable, and the network will be very poor during the peak period of using the network.
3. Try to place the router in an open place such as the living room, and use a router with dual band and multiple antennas, and the signal will be better.
4. Buy a signal amplifier, or cut off the bottom of the empty can, cut it vertically upward, cut off both ends but do not cut it, and put it on the router antenna to enhance the wireless network signal.
There are generally two main reasons for poor network: first, the bandwidth is not enough, too many electronic products are used at the same time, and the network speed will slow down when the upper limit is reached, so you can only change to a larger broadband or reduce the use of equipment; Second, routers and other equipment have affected the network speed due to poor quality, insufficient transmission rate, and many obstacles, so they need to adjust their location or replace routers with higher power.
-
There are a few common reasons for slow broadband internet speeds:
1. If the bandwidth of the ** server is narrow or the server is busy, you can try to change the time period to access or access other** to determine whether this problem is caused;
2. Computer reasons such as low computer configuration or weak system processing power;
4. The use of routers to share the Internet leads to slow network speed;
5. If the modem device is unstable, it is recommended that you replace the modem device for testing;
6. Line reasons (such as long line, noisy line, poor quality of the entrance line, change of the user-side line, etc.).
If this is not the case, you can contact the local customer service for feedback.
-
Either you are too remote and the overall speed is not speeded, or it is a problem with your broadband, or it may be that your computer is slow, the network speed is high, or you have been driving for a long time, or the broadband is too hot, let it rest for a while, or the broadband is broken (I have also encountered it).
-
The question is whether there is a virus in the computer you have built in your home, what kind of cable you have installed, and the computer has been for a few years, and it is naturally slow.
-
It may be that the line is aging. It is recommended to call 10000 and ask them to check the route.
-
Carriers may have speed limits, and there are not as many resources as before.
Hold on, the telecommunications bureau has a problem
Enter this command on the run. Speed 10-20ms. Represents normal. >>>More
ADSL is exclusive bandwidth (with ** online Internet so to use modem) dial-up and then go to the Internet, FTTB is the use of fiber broadband mode is shared (no need to dial), ADSL 2M maximum ** rate is 1024KB * 2 8 = 256KB, FTTB because it is a shared bandwidth If you are using ADSL Internet access in this building, then your ** rate must be higher than 2M (I have a classmate who uses FTT B 2M ** rate 800K S), But if there are more people in your community, or everyone is using FTTB to surf the Internet at a point in time, then the **speed will definitely be**, so if you want to be stable, choose ADSL, and if you want **something, choose FTTB, in the final analysis, it depends on how many people in your community are using FTTB.
First connect the access cable to the cat, and then connect one end of the network cable to the interface on the cat, and the other end is connected to a blue on the wireless router (generally blue, anyway, the hole that is different from the color of other holes), if it is a desktop, then use a network cable to connect the computer to the wireless router, the desktop will show that the local connection is connected, and now you need to change the IP address of the computer to the same network segment as the IP address of your router to start setting, general TP— link is to enter in the browser and press enter will jump to the settings interface,Run the setup wizard,Follow the prompts and it's OK,When there is a step, you have to choose pppoe,The password should be set, otherwise people will steal your network。 After setting, it's OK, your laptop or mobile phone can be received, and you can surf the Internet, of course, you can also use your mobile phone, but others can also get it.
I don't understand what you mean But the bandwidth of your network is constant, no matter how many of your machines have a bandwidth of 2M, then the 2M bandwidth will be shared by the 2 machines, and it will not exceed this, nor will it be less than this bandwidth