Ask for pointers, computer problems, a partition of the hard disk can t be displayed, how to solve i

You shouldn't have a hard disk space, it's actually displayed now, you divide it, that is, format it and give it a name, just do it.

The solution to the hard disk partition not being displayed on the computer: 1. Right-click "My Computer" and select Open Management; 2. Click "Disk Management" in the left menu, you can see the newly added hard disk (disk 0 in the picture); 3. Click on this new hard disk, it will automatically open the initialization disk window, if the disk capacity is greater than 2T, select GPT, return it, select MBR; 4. After the initialization is completed, start the disk partition, right-click on the blank space on the right side of the disk, and select "New Simple Volume". 5. Click Next; 6. Set the size, drive letter, and format of the partition, such as setting the NTFS format partition of 50G; 7. Click Done, so that there will be a 50G K disk;

The computer hard disk partition cannot be displayed because some disks are artificially set to hide, and the method of displaying these hard disks is as follows:

1. Right-click "My Computer--Management--Storage--Disk Management" to enter the "Computer Management" interface.

2. Display the hidden disk, right-click "Disk Name" - Change Drive Letter and Path (C)".

3. In the "Change the drive letter and path of the disk name" interface, click "Add (d)".

4. On the "Add Drive Letter or Path" interface, select the appropriate "Drive Letter", and finally "OK".

5. Check the "Computer Management" and "My Computer" interfaces.

There are several possibilities for partitions not showing the hard disk.

1.The hard drive is broken and the hard drive is not detected.

If the version problem cannot detect the hard disk, it is recommended to try another version of PE.

3.The hard drive mode is incorrect.

When opening the partition, it prompts formatting, and the hard disk is required to be formatted due to hardware problems, which is usually caused by MBR damage. First of all, it is recommended to remove the hard disk, find another computer, connect the hard disk to the slave disk, and then detect the bad sector condition of the hard disk through MHDD. If the bad sector is detected, it is necessary to immediately cut off the power and stop the operation, power-on may lead to the aggravation of the bad sector fault, if the data is important, it is recommended to find 51recovery to help recover; If there is no bad sector, you can judge that it is caused by MBR corruption, if the data is not important, you can directly format and repartition, if you need the first choice of data or through 51Recovery for the formal recovery process.

If you want to operate by yourself, you must connect the slave disk, remember to save the data scanned by easyrecovery to the main disk, in short, do not do any writing operations on this hard disk, once there is a write, it will involve overwriting, which is likely to cause the data to be unrecoverable.

Unformatted means that the partition has been logically deleted, but no physical operation has been performed;

If you need to rescue the above data, please do not format it, just take it to the place where the computer was repaired for data recovery.

Prompt: Formatting is a typical dbr problem, it can be fully recovered, as long as the dbr is repaired, you can click my name hi me below, it can help you recover successfully remotely, looking forward to your question.

unallocated space] again.

partition , after which it is formatted.

After the check, use Diskgen or Easy Me Partition Table Doctor to get back the partition table of the E disk to ensure that your E disk is of the Disk E.

None of the files are small, even if they are divided, they will be fine.