Newly installed computer, the next day began to crash frequently, why is this happening Do you get a

If the screen freezes suddenly, it may be that the memory and motherboard are not very compatible.

You can do the following adjustment to see if it can be solved.

If it is a dual-channel case, it is recommended to adjust the timing higher first. If it doesn't work, change the memory mode from 1T to 2T, if it still doesn't work, it is recommended to add a small amount of voltage (not very recommended), and finally if it doesn't work, change the dual channel to a single channel, if it doesn't work at this time, you can be sure that either there is a problem with the memory or it is incompatible.

I MSI and Kingmax do dual channel is DDR voltage to stabilize.

In short, dual-channel requires a lot of memory, and you can ask for the installed machine to change to other memory, such as kingstone

Kingmax Samsung original and other boxed memory.

It is not recommended to change to a single channel, which has a significant impact on performance.

The system is not good, install the system yourself and try it, most of them are go, very unstable.

Just buy it and change it.

Or call him whole.

The machine you just bought can be called by the merchant to provide door-to-door service, and generally go to the merchant to detect what is bad and replace it. The brands selected for such a typical high-end configuration are good, usually the merchant may ignore it in the power supply, and give you a 250W, which is not called a problem.

Change, tell him to change. It may be that the hardware is not compatible.

Why is the CPU so unstable? It's not going to be broken, is it?

The performance of the assembly machine is inherently unstable, like you, it may be that the CPU has a conflict with your motherboard, either the CPU is too low, or the motherboard requirements are a little high, before changing the CPU, you look at whether your heat dissipation is normal, if it is normal, then you have to consider changing the CPU, if not, you first solve the heat dissipation problem.

In fact, the important element that determines the host is the CPU, and if your CPU is too low, it is normal for it to crash.

I don't think you'll have to mess with it yourself!! Whoever gives him the machine, you will smash the machine in his face! ~

I don't even do the minimum test run of the machine!!

It must be an incompatibility problem, or there is something wrong with the parts, and it is better to replace them all.

I have a computer that's the same way. There's a problem with your motherboard, for sure, so is mine, just change to a motherboard. Or the format of the hardware is incorrect.

What configuration, what power supply?

If there is no problem with the installation, it is likely that the power supply is not enough, and you need to post your configuration before others can give advice.

No, there are usually no problems with new computers. You check it out in detail.