-
Anonymous users2024-02-07stop 0x000000ed
unmountable_boot_volume
The normal recovery process in this case is to run the chkdsk r command from the failback console and then continue. On the OEM version of Windows XP, the Failback Console may not be accessible. If the OEM version of Windows XP does not already include this hotfix, you may not be able to go into the recovery console and run the chkdsk r command to recover.
0x000000ed:unmountable_boot_volume
Error analysis: It is generally caused by an error in the disk, sometimes it is also recommended to check whether the hard disk connection is not in good contact, or does not use a cable that meets the transmission specifications of the hard disk, for example, the ATA-100 still uses the ATA-33 cable, which does not matter to the low-speed hard disk, but tells the hard disk (supports ATA-66 or above) The requirements are stricter, and the connection with the wrong specification will sometimes cause this kind of failure to boot. If this error still occurs frequently after repair, it is likely to be a precursor to hard drive corruption.
Solution: In general, a reboot will resolve the issue, and it is recommended to do so anyway"chkdsk /r"command to check the repaired hard drive.
-
Anonymous users2024-02-06Double-check the hardware configuration on the motherboard, but also do a good job of cleaning it up, or updating the system.
If not, it is recommended to go to a professional repair point for consultation or maintenance.
-
Anonymous users2024-02-05You look at the CPU temperature, whether the fan is rotating properly, and whether the connection is tight.
Use a brush to clean the inside of the lower chassis.
-
Anonymous users2024-02-04What is it loaded on? If the memory requirements are the same generation of products, if the installation of hardware is caused, you can not install, or go to the repair computer to see if you are doing something wrong, and the hardware problem answerer can't get your computer to check it in person can't help you.
1) Reinstall the operating system first, don't install software, patches, drivers, etc., and see if there is still a problem with booting? If you don't install drivers, patches, and software step by step, and find something that isn't suitable, don't install it.
Please note: If you restore the system or reinstall it, when installing drivers, patches, software and other things, be sure not to install the things that affect your accident this time, otherwise it will be restored or reinstalled in vain.
2) If it is caused by hardware problems, it is recommended to overhaul it.
-
Anonymous users2024-02-03It is recommended to use 360's blue screen repair tool to give it a try.
The causes and solutions are as follows:
1. Feel whether the temperature of the CPU radiator is too high, the temperature is too high and the chip heat dissipation is not smooth, which will cause a blue screen, add heat dissipation silicone or replace the radiator; >>>More
Blue Screen" software causes and solutions: 1. Loading too many programs at startup Don't load too many applications at startup (especially if your memory is less than 64MB), so as not to exhaust system resources. Under normal circumstances, the system resources should not be less than 90% after win9x starts. >>>More
1.Always check the contact of computer accessories. Running in the case of poor board contact will cause the system to crash, so when replacing computer accessories, be sure to make the board fully contact with the motherboard. >>>More
0x00000024:ntfs_file_system
Error analysis: 0x00000023 usually occurs when reading and writing a system partition of a FAT16 or FAT32 file system, and 0x00000024 is due to a file error (the purpose of this driver file is to allow the system to read and write(NTFS file system disk). >>>More
Hello, the blue screen of computer boot is mainly: "there is an error on the disk" or "abnormal shutdown" is caused! >>>More