What should I do if the W10 system boots on the blue screen, reboots or blue screen?

1.Always check the contact of computer accessories. Running in the case of poor board contact will cause the system to crash, so when replacing computer accessories, be sure to make the board fully contact with the motherboard.

2.When uninstalling the software, use the built-in anti-installer or the installation and uninstallation method in Windows, do not delete the program folder directly, because some files may be shared by other programs, once these shared files are deleted, the application software will be unusable and crash.

3.Clean the chassis regularly. Too much dust will cause poor contact between the boards and cards, causing the system to crash during operation, so the chassis should be cleaned at all times and not let too much dust accumulate in the chassis.

4.Guarantee the correct BIOS settings. The settings in the BIOS must be appropriate, the wrong BIOS settings will cause you to freeze when running Windows.

5.Persist in carefully checking and killing viruses. Do not use CD-ROMs or floppy disks from unknown sources, and check attachments in emails with anti-virus software before opening them.

6.Shut down in the correct order of operation. Do not turn off the power before the application software finishes running normally, otherwise it will cause system file damage or loss, and cause a crash during startup or operation.

7.Avoid multitasking at the same time. Do not run other software during defragmentation or checking your hard drive with anti-virus software, as this will cause a crash.

8.Don't overdo it. The drivers of various hardware do not have to be updated at any time, because the drivers that have just been developed often have bugs in them, which will cause damage to the system and cause the system to crash, and the latest is not necessarily the best.

9.When setting up a hardware device, it is best to check for Reserved Interrupt (IRQ) and do not let other devices use the interrupt number, so as not to cause interrupt conflicts and cause system crashes.

Enter the RE advanced mode to fix it.

1. When the screen appears at boot, press and hold the boot button to turn off the computer, three times in a row, until the repair interface appears at boot, click Advanced Repair Options, Troubleshooting, and Advanced Options in turn.

2. In the advanced selection, click to revert to the previous version.

3. Open the command prompt and type chkdsk

c:fr: fix the hard disk error.

4. Set a restore point to perform a system restore.

5. There are other computers and USB flash drives that can access the Internet. Make a boot disk and perform system image repairs. This method can completely solve the problem. **Windows10, to Microsoft's official **win10 tool, make a boot disk. Perform a system image repair.

6. In the troubleshooting, click Reset this computer to reset the operating system.

Computer BSOD causes may be:

1. Insufficient virtual memory causes system multi-task operation errors or CPU overclocking causes operation errors.

2. The incompatibility or damage of the memory module causes an operation error or the optical drive is opened abnormally when reading the disk.

4. There is an error or corruption in the registry.

5. There are conflicting versions or bugs in the application.

Win10 boot blue screen bad system config info is caused by a setting error, the solution is:

1. Win key + R key to open the running window, enter msconfig, and click confirm.

2. In the general bar interface, click to uncheck and load startup items.

3. Switch to the service bar and check Hide all Microsoft services.

4. Win key + R key to open the running window, enter cmd, and click to confirm.

5. Enter wsreset, click confirm, and wait for the cleanup.