I have to press F1 to enter when my computer starts, how to solve it.

It's time to change the motherboard battery, open the big button battery on the motherboard of the case, a few bucks.

In this case, you can enter the BIOS, check whether the floppy drive is enabled, if so, turn it off, press F10 to save, if it still prompts F1, it may be because of individual settings, such as CPU fan speed, CPU temperature, but it does not affect the use of Bu Shuhuai, so that you can connect to F1 when there is an error in the BIOS

Turn this setting off, and you're done.

The specific setting location, which royal because the motherboard is different in different positions, so you can only check the motherboard manual.

Is it the time of the system every time it is displayed, and the time is invalid after the first change and the next login. This is because the big button battery next to the Nanqiao chip on the motherboard is dead, as long as the battery is replaced with a new one, it can solve the problem, and the first time the computer is just replaced, the same situation may still occur, but the later startup will not be delayed.

To press f1 to start: There are several reasons:

1. The CMOS parameter settings are incorrect

Floppy drive: If the floppy drive is not detected, please check whether the data cable is connected, and then see if the settings in the BIOS are correct: check the settings of the boot sequence; In addition, if there is no floppy drive, it is directly shielded.

Keyboard: Some CMOS settings in the keyboard problem will also appear press F1 to boot the situation, the landlord to check it himself.

Memory: Disable Memory Verification.

2. Prompt for insufficient BIOS battery power - replace the battery 3. Jumper setting problem - refer to the manual to set.

address

areinvalid

inboth

apcand

dmipress

f1toresume

In addition, it may be a non-fatal hardware error that can be replaced with a check.

Judging from the on-screen prompt information, your hard disk is faulty, please check the hard disk data after entering the system to determine the cause of the problem, if the problem is not big, you can go to the BIOS to disable the detection, otherwise you need to replace the hard disk.

When the computer is turned on, it will prompt to press the F1 key, when the F1 key is manually pressed, the computer can start normally, but every time the computer is turned on, the F1 key must be pressed, the reason is that the floppy drive (Floopy) is damaged, 1. When the computer is booted up, press the "del, F2" key on the keyboard continuously, and the following screen appears:

2. Operate the up and down arrow keys and select "standard".

cmosfeatrues" directory and press the Enter key to enter, and the following screen appears:

3. Operate the up and down arrow keys and select "hold".

on" column, press the enter key, and the following screen appears:

4. Operate the up and down arrow keys and select "No."

error", press the enter key, and the following screen appears:

5. Operate the up, down, left, right, and arrow keys and select "Floopy."

drivea and floopy

driveb" are changed to none (off), 6, press "F10"key Save Modification, and the following screen appears:

7. Select "OK" and press the enter key, then the computer will automatically restart, 8. There will be no prompt to press the "F1" key after booting the computer, and the computer can start normally, 9. The motherboard button battery has no power, which will also cause data loss and thus cause the above faults, check and replace the motherboard battery, 10. Open the side panel of the chassis and remove the data cable and power cable connected to the floppy drive, which can also solve the above faults.