What should I do My keyboard has a Coke in it, and now it s out of order.

After turning off the computer, I pried off the keycaps and carefully wiped the liquid in the keyboard, and found that the keyboard still could not be used normally, and it seemed that the circuit board of the keyboard had been flooded. I had no choice but to open the base of the keyboard. It is recommended to be careful with this step, because many keyboards are designed with "hidden buckles" and are easy to break.

If you accidentally break it, the keyboard will never be as tight as it used to be. The author accidentally broke the "hidden button" of his keyboard before, everyone must be careful! My friend used Logitech's easy-to-use version, but fortunately there was no hidden buckle, and when I opened the keyboard base carefully, I saw the circuit board of the keyboard.

The author found that there were indeed traces of "yogurt" on the circuit board of the keyboard, so I carefully wiped it with absorbent cotton with strong water absorption. Here is a reminder that the circuit board of the keyboard is a thin plastic sheet with two to three layers, which must be carefully wiped, and not touched with hard things, otherwise the circuit will be damaged. After wiping carefully, reinstall the keyboard and connect it to the computer, this time it should solve the problem!

But I didn't expect the problem to be the same! It seems that the circuit board is still wet, and the short circuit has caused the keyboard to not work properly, and there is no way to disassemble the keyboard again. This time, the author learned a lesson, wiped the three layers of circuit boards separately, and dried them in the sun for 3 hours after wiping!

This time the problem was finally solved!

Most keyboards can be disassembled and cleaned, you can open and clean it first, then dry it in the shade, and put it on, which reminds you to remember the position of the keyboard keys before disassembling it.

You wipe it to dry.

If it's a notebook, take it down.

If it's already dry, it still can't be used.

I had to change it. If it's a notebook, you can buy an external one.

But you have to make sure that you don't get affected by the water inside.

But it's the biggest killer of the keyboard, and the computer newspaper has introduced it.,This situation is dead.,The new one is not expensive.,100 for a good one.。

If it's a Coke, it will also fail, and that's because your keyboard is not good.

Mine also got into apple pie (two years ago) and I'm still fine

Pick out the keys one by one and wipe them with paper

If it's a notebook, you're in trouble and have to send it to customer service for repair.

If you're on a desktop, congratulations, you're ready for a newer and better-looking keyboard.

Open it and wipe it well.

Dry in a cool place.

The rest...

Leave it to fate.

I've been in a situation like this.

Outcome... Don't mention it.

It is recommended to buy a waterproof keyboard.

If so, you'll have to change the keyboard.

Buy a new one. Coke is not water, it is very sticky after drying, and the preliminary identification --- keyboard scrapped.

You take it apart, and there's nothing in it, it's just a circuit board.

Rub it with alcohol.

It should be fine.

1 6 step by step reading.

Use a paper towel to dry it. If you accidentally spill a drink on the keyboard in your daily work, you must dry it with a paper towel first, so that the functions in the keyboard will not deteriorate, which is better for the keyboard and can also make the computer work normally, which is a very important thing.

Turn your computer upside down. If it's a laptop.

If the drink is almost dry, then just turn the computer upside down, so that the computer keyboard will not be damaged, which is very important and a very good way, so you need to put the computer upside down.

ACER Notebook Keyboard Jingdong - Boutique Huiju, every day**, Hi GO non-stop! Ad.

Use a hair dryer. If you accidentally spill a drink on the keyboard at home, you can use a hair dryer directly.

Direct blow drying, which is a very fast and effective way to dry the keyboard in the shortest possible time, is very important and very good.

Help & Service - Taiyuan Customer Service After-sales address inquiry-**Inquiry. Ad.

Clean the keyboard. If you can, you can pick up the keycaps on the keyboard one by one and then clean them, which is very important, and it is very good to also clean the keyboard. At the same time, you can also check if there is a problem with the keyboard, if there is no problem, you can use it directly without worrying too much.

Wipe with a dry cloth. Of course, it is also possible to wipe the keyboard with a dry cloth to make the keyboard cleaner, so you can use a dry cloth to wipe the keyboard, which can make the keyboard cleaner and easier to use.

Use a fan. If it's summer, there will definitely be a fan at home, and blowing directly with a fan can also make the keyboard easier to dry, which is very good for the keyboard, so that the keyboard can dry out in a short time, which is very good.

1.After sprinkling the Coke, immediately turn off the power, a corner, and pour out the Coke.

2.Use the key puller to remove the keycaps.

3.Using a tissue, gently absorb any remaining moisture from the keyboard and lay flat to dry.

4.Using a damp cloth, wipe off the cola stain.

Immediately buckle the keyboard over, try to let the cola flow out, not into the circuit board, and after drying, remove the keys and wipe them one by one, because the cola is slimy.

Coke accidentally spilled on the keyboard, will not have fatal damage to the keyboard, the keyboard has a certain degree of waterproof, first turn off the computer, power off, and then wipe it, so that it will not damage the keyboard.

If the Coke accidentally spills on the keyboard, you can turn it off and unplug it, clean it up carefully, and wait for it to dry before using it.

I accidentally spilled the Coke on the keyboard, quickly unplug the power, then wipe the Coke clean and dry it with a hair dryer.

Hello, in this case, you can wipe it clean with wet wipes or dry towels, and it will not cause damage to the keyboard.

Then you can unplug the keyboard first and clean it up, when it is cleaned and there is no moisture on the keyboard, then you can plug it back in, so that it will not affect the use of the keyboard.

If the Coke accidentally spills on the keyboard. We urgently shut down the power at this time. Then flip the keyboard upside down. I'm face down, just let the water control come out.

Wipe the surface first, buckle the keyboard over, let the excess Coke flow out, turn off the power of the keyboard, and you can remove the keys.

Wipe it with a paper towel so that it doesn't seep into the keyboard. What affects the longevity of the keyboard.

I suggest that you can suck Coke with paper.

Hurry up and dry it, oh, I'm anxious for you, and I still have the heart to ask here.

You can do the following:

Start by using a screwdriver to unscrew the screws on the back of the keyboard. Place the keyboard face up on the table and gently lift the panel, and we will see a bunch of small rubber pads, and when you see it, you will understand why each key is bouncy.

Take out the small rubber pads and wipe them one by one, then put the keyboard panel into the warm water that has been washed and cleaned for a while, then scrub it clean, and finally brush it with a soft brush, and the panel will be clean.

The circuit board is generally not too dirty, just wipe it with a clean, soft cloth. Once the cleaning is complete, let the cleaned keyboard dry for a few hours or use a hair dryer to dry it, and then install the keyboard as it is. When installing, you should first put the panel down on the table, put the two sides with book pads, and then put the small rubber pads into the buttons one by one, then put the circuit board and bottom panel, and finally put the screws.

ps: Lazy solution: use transparent tape as a cleaning tool to clean the keyboard, stick the long tape between the small gaps between the keyboard keys, and then press it with your fingers to make the dirt and dust stick to the tape as much as possible, and finally remove the tape and uproot all the dirty things.

Here's how to solve it.

1. Unplug the power supply and battery immediately, and the speed of power failure directly determines the most critical factor in the severity of the damage to the notebook. Don't start shutting down slowly, and then shut down when the system shuts down normally. If it's slow, it's quite dangerous.

2. Pour out the water immediately according to the direction of the water intake, and quickly dry the water with a dry towel or paper towel. If there is water on the top of the keyboard, immediately turn the keyboard down (be careful not to let the water flow into the LCD screen), and try to pour out the water to avoid more water entering the motherboard.

3. If the keyboard gets water, remove the keyboard and observe whether the water has entered the motherboard. Carefully dry the front and back of the keyboard with a paper towel. If possible, you can use a hair dryer to dry it with cold air, and be careful not to use hot air, because the keyboard keys and other keys are plastic, which is not resistant to high temperatures, do not use hot air, and avoid blowing damage.

If the liquid is cola, vegetable soup, etc., you need to remove some of the buttons and carefully scrub them with pure alcohol. Because cola and other substances contain sugar, if it is not clear, it will corrode the wiring over time and cause damage to the keyboard.

4. Completely disassemble the motherboard, if you don't know how to disassemble the motherboard, it's best to ask a friend who knows more to help disassemble it. Observe whether there are water stains on the motherboard, and if so, carefully wipe it clean with pure alcohol. I use high-quality plate washing water to scrub the motherboard in notebook repair, but this kind of plate washing water is not available to ordinary people, and it is difficult to buy it in the electronics market in Beijing, not the kind of ordinary plate washing water.

This can be replaced by pure alcohol, Note 1 must use pure alcohol, not aqueous alcohol. Then dry the motherboard, or the hair dryer should not be too high, and pay attention to protect the plastic connectors on the motherboard.

5. Carefully dispose of the moisture inside and outside the laptop shell, put the treated motherboard and keyboard in a dry place for one to two days, and then confirm that all the moisture has dried thoroughly before assembling it. It must not be powered on and turned on before processing. Because the general user has no professional drying equipment, it is necessary to let many accessories be thoroughly dried as often as possible.

Like Coke, Sprite and other drinks contain sugar sprinkled in the keyboard, which will cause a change in the feel, you can remove the shaft and press it wildly in pure water, it may have some effect, if it is a green switch, or change the keyboard.

Mechanical keyboards are now basically the standard configuration of gamers, and mechanical keyboards have a long lifespan, but when time is permanent, the keyboard will accumulate a lot of dust. How dirty is your mechanical keyboard? Let's clean up the dust together

I suggest you switch to a different keyboard.

It's not very expensive either.

It is difficult to restore the keyboard to its original state after it is broken.

I even dripping syrup into the calculator when I ate sugar gourds. Later, remove the calculator and wipe it with toilet paper dipped in some water. Your keys are sticky, uninstall and wipe them, if you can't send them to the repair place and let someone else unload them for you.

Your question, it's absolutely no problem to soak in water after the power is off.

Generally speaking, when a mechanical keyboard enters water or a drink, the power is cut off first.

1.Directly return to the factory for repair.

2.Do it yourself to dry.

If it's water, take it apart and dry it (it's best to dry it for two more days to be on the safe side) or take a hair dryer to dry it on the stove.

If it is a drink, it is best to soak it in alcohol for a period of time, and press the shaft with your hand when soaking, that is, wash off the residue of the drink on the shaft and let it dry for about a week (you think it will be dry).

After drying, plug in with Lu Sui to try, if some keys can not be used or the feel has changed, either change the shaft yourself, or return to the factory for repair or replacement (Razer.

Within two years, it is generally replaced with a new stupid one).

Pure hand-to-hand, I hope it can help you.

First of all, every button on the laptop can be cut open. For standard-sized keys, you can pick them open with a strong pick from top to bottom with your fingernails, and then you will see a rubber pad, and it has something to do with the fact that the keys can't bounce up.

For users who can't press the button, you can press this rubber pad with your hand, if you can't bounce it up yourself, you can use the rubber pad of other keys that are not commonly used to replace it, or go to the second-hand market of the laptop to buy one, **Very cheap.

For users with water on the keyboard, you need to cut off all the keys of the piece of water that enter the water, and carefully check it after the collapse of the suspected hand, if it is determined that the liquid has not leaked into the computer, then for distilled water or tap water, etc., it can be dried, for drinks, such as Coca-Cola, etc., the water of these drinks will leave sticky sugar after evaporation, then you need to use low-concentration alcohol to wipe. Pay attention to every corner when wiping, especially the part of the rubber pad.

If you're hands-on, remove the keyboard. Just remove the sticky buttons and wipe them clean with a damp cloth