What should I do if there are small water droplets outside the toilet tank, is it a quality problem?

It's not a quality issue. The temperature of the water in the tank is low, which forms a temperature difference with the indoor temperature, which makes the moist air around the toilet liquefy and form water droplets. It's just a physical liquefaction phenomenon.

This condition is more common in summer, or when taking a bath, just wipe it dry; The toilet is made of ceramic, which is inherently waterproof and does not have any bad effects on the toilet itself. This can be avoided by separating wet and dry in the bathroom, or by using a heated toilet.

It could be water vapor, and if the tank was leaking, it couldn't be all over the tank, and it wouldn't be droplets, it should be a line of water going down.

The outer wall of the toilet tank is full of small water droplets, not that the toilet is broken. The temperature of the water in the tank is low, and there is a temperature difference between the water in the tank and the indoor temperature, which causes the water around the toilet to liquefy and form water droplets.

Liquefaction refers to the process of changing a substance from a gaseous state to a liquid state, which will release heat to the outside world. There are two ways to achieve liquefaction, one is to reduce the temperature, and the other is to compress the volume.

The critical temperature is the maximum temperature at which a gas can liquefy. Because usually the volume of gas liquefaction will become one thousandth of the original, which is convenient for storage and transportation, so in reality, some gases (such as ammonia and natural gas) are usually liquefied, because the critical point of these two gases is higher, so it can become liquid under pressure at room temperature, and the critical point of some other gases such as hydrogen and nitrogen is very low, and deep cooling must be carried out while pressurizing, which is called liquefaction.

Occasionally, it may be sprayed.

Often, there may be cracks.

Call the repairer to take a look.

There is a sound of running water in the toilet, generally there is a problem with the water tank, open the water tank lid and check it according to the following steps:

1. Whether there is water in the water tank, if there is no water, press the drain valve button lightly, check whether the drain valve has fallen, the water level of the water tank rises with the water inlet valve, and the sound of flowing water disappears; If water is still flowing into the toilet, the drain valve gasket is damaged.

Solution: The drain valve body needs to be replaced.

2. Whether the water level is higher than the overflow pipe and flows down from the overflow pipe.

Solution: Adjust the water level of the inlet valve to control the float and reduce the water level to the lower end of the overflow valve.

3.The float valve is not completely closed, there is a little gap, so there is a constant flow of water.

Solution: Replace the float valve.

Small water droplets appear in the toilet, which not only affects the use of the toilet, but also is easy to breed bacteria and produce peculiar smells, so it should be dealt with in time.

1.Check the water valve spine.

First, check that the flush valve is working properly. If the water valve is loose or aging, it can cause the toilet to produce too much or too little water, resulting in small water droplets. At this time, it is necessary to let the seepage change valve.

2.Check the width of the water tank.

If the width of the tank is not enough, it may lead to the water flow not hitting hard enough, resulting in the appearance of small water droplets. At this point, the tank needs to be replaced.

3.Clean the toilet.

Cleaning the toilet bowl frequently can effectively reduce the appearance of water droplets. It is recommended to use detergent to clean the toilet seat, the inside of the toilet bowl and the toilet seat, and to clean or replace the seat cushion daily.

4.Adjust the internal structure of the toilet.

If the structure of the tank and toilet bowl is not suitable, it may cause water beads to drip and leak. At this time, it is necessary to adjust the structure of the toilet bowl and cistern or replace the accessories.

5.Use waterproof beads.

Adding some waterproof beads to the toilet bowl can hold the water droplets together and prevent them from dripping. However, the waterproofing beads need to be replaced regularly.

In conclusion, there are many reasons for the appearance of small water droplets that need to be treated on a case-by-case basis. If the above methods do not solve the problem, it is recommended to ask a professional to check and repair.