Can the crystal lamp controlled by segments change the order of its lighting?

Change the order of the lights, dismantle the lights first, see that there is a remote control receiver behind, the shell has a drawing description of the order of lights and the color of the line, according to the order of the lights you want, re-wired by color, if it doesn't work, the remote control receiver device is broken After buying again, according to the newly bought wiring method, it is very much according to the order of the lights you need.

Segmented control lamp wiring diagram.

Is the included controller that LZ says is a remote control?

You just want to change the order of the lights, which requires changing the circuit of the sectionalizer.

Then change the circuit of the remote control, LZ can study the circuit on the back of the lamp, and replace the circuit.

The indicator light of the remote control is on, but the light does not respond, which is usually a problem with the receiver receiving the signal, and some remote controls need to be aligned to be controlled. It is recommended to remove the remote control, use the wall switch, or replace a *** remote control, because if the remote control is broken, the circuit of the whole lamp may not work, and the general brands of the remote control are: Japan Binqi, chasing stick (I think these 2 brands of remote control are good, and some brands of lamps and lanterns come with their own brand of remote control is also good).

1. Check your remote control battery first and try a new one, if it works, you don't need to dismantle the light to solve it, which is the most convenient for you.

2. Change the order of the lights, disassemble the lights first, and see that there is a remote control receiver behind the shell, and there is a drawing description of the order of the lights and the color of the lines, so you can re-wire the lights according to the order you want.

3. If it doesn't work, the remote control receiving device is broken, and after buying it again, according to the wiring method you bought it, it can be wired in the order of the lights you need.

As for the piece that involves dismantling the lights and wiring, it's best to hire an electrician, safety first, you just do the first step, and the second and third electricians, he will.

You're not going to change the noise control device. Reconnect the cable and you're good to go.

I bought a crystal lamp on the Internet, and the store sent a segmented remote control switch, I don't know how to install it, and there are three possible connections according to the antenna: 1Connect a piece of wire of about 30 cm, and the other end is vacant. 2.Receive.

In this case, the method of elimination is used.

First check the light source, that is, whether there is a problem with the bulb, and the problem of the bulb can be solved by replacing it directly.

If there is no problem, then the next thing to check is the segmented controller, if it is broken, it can be replaced, the lamp store has accessories, and you can ask the master of the lamp shop to come over if you don't know how to overhaul it.

Bertinburgh Illuminations.

There are usually two reasons why the light source is not bright, one is that the driver is broken, and the other is that there is a problem with the light source itself. If both accessories are available, the broken set can be replaced at the same time.

You merge two of them into one road, so that it becomes 3 segments.

With a single switch, add one or two sectionalizers to the lamp.

This is simple, use the triple dual control switch Oh specific method to see the figure below, two methods.

The third switch of the third method of the second method needs to use the intermediate switch.

Please click on my avatar to find the answer, I have solved similar problems.

I've already answered another question. The key problem is to find the control IC of the segment switch and adjust the pin output order.

I'm an expert, but I don't understand what you say, can I send **?

If you want to realize the crystal lamp remote control switch, you need to install a splitter inside.

Is the remote control broken?,Generally, it will be equipped with a segmented remote control.。