What should I do if Samsung Note2 can t turn on, there is a boot screen, but the boot screen loops i

Hello: According to your description, it is recommended that you try the following methods:

1. It is recommended that when the phone starts, the screen of the phone model logo appears, and press and hold the menu button to enter the safe mode.

2. After the phone enters the safe mode, please back up the important data of the phone and then restore the factory settingsTry to set it up-reset-restore the factory settings (rule out software problems).

As Android, it's no surprise;

Enter the random self-contained recovery,Double clear data,It is double wipe,So to a certain extent, restore the factory settings,If this is not good,,Then study the flash,Remember,If there are conditions, be sure to brush the original system,Other third-party so-called streamlining and optimization speed ......No guy is responsible for the stability of the system.

In the case of being able to enter the original REC again, you can choose to swipe the original ROM first, and when you can't get into the REC that comes with it, you need to flash it into the RECOVry, which is generally a third-party higher function, this REC is dedicated to the special machine, and only exists in a small range of different models of machines for interoperability, brushing the wrong one, or it is a brick, or it can't be turned on, and the hardware is bad.

After flashing the new REC, you can swipe it, if it is difficult to flash the REC, you need to connect the computer cable to brush.

Usually it's not that easy to break down along with the hardware.

System problems, flashing is very common.

Samsung note series should be the baseband part of the partition are encrypted, if you flash the machine must distinguish between different versions, sure which one can be used, available, otherwise it is easy to brush into mp4, lose the baseband, can't play**.。!

Samsung Note2 phone appears to be unable to turn onGo to the system page, appearedStuck screenCrashIn the case of the squire brother burning, you can passForce shutdown and restartandRemove the batteryTwo methods for repair and inspection.

Method 1: (Forced shutdown and restart).

Press and holdPower buttonRestart the machine in 8-10 seconds.

Method 2: (Remove the battery).

Please take out the battery and insert it back in after shutting it off.

If the problem persists after restarting the machine, it is recommended to bring the purchase invoice, warranty card and machine to the Samsung service center for inspection.

Samsung Note2 can't turn on for no reasonThe solution is as follows:

Charge with a cable charge for a while and try to turn it on, or replace a phone battery of the same model.

Take out the SIM card and SD card at the same time and try to power on again.

In the power-off state, press and hold [Volume Up] + [Home Button] + [Power Button] to enter recovery.

Move the left volume button up and down, and select the [Home button] or [Power button].

Select Wipe Data Factory Reset and confirm, Select"yes -delete all user data"And confirm.

Select [Wipe Cache Partition] and confirm, then select"yes-wipe cache"and confirm, the operation is complete.

Select [Reboot System Now] to restart your phone.

The Samsung Note2 phone won't turn on, and the possible reasons are as follows:

1. The battery is broken, and the mobile phone cannot be powered normally or the mobile phone battery is seriously fed;

2. When flashing the machine, I accidentally brushed the wrong version;

3. Hardware failure caused by water ingress into the mobile phone;

4. The mobile phone plays games for a long time, and the temperature is too high, which is automatically protected;

5. The screen of the mobile phone is completely broken;

5. The mobile phone malfunction caused by other reasons leads to the failure to turn on normally.

Samsung phone won't turn on: Solution.

1.Check your phone's battery. The reaction when the phone is turned on proves that the battery is still working, and in addition to the aging of the battery and water ingress, the battery problem can be ruled out. If the battery is aging, you can try it with the same type of battery, and if it can be turned on normally, then replace it with a battery.

2.Check your phone screen. Under the destruction of external forces, the screen fails, especially some mobile phones themselves are soldered, which is particularly prone to "fake not booting" caused by the screen.

3.Check if you can enter the recovery, consider flashing. This step is a detection method for software or system problems, and in many cases, it is also a software or system problem that causes the phone to not turn on.

4.If you can't enter the recovery, you can flash the machine. Flashing the phone is equivalent to an official forced upgrade, and the phone can be operated as long as it responds.

Hello !

According to your description, the problem with your Samsung Galaxy Note2 phone.

We recommend that you try this by following these steps:

Back up the SD Card data on your computer, format the SD Card and insert it back into your phone.

When the phone is fully charged, press and hold the [Power Button] and [Volume+] buttons when the phone is off (OFF), and then move the cursor with [Volume+], Volume-] to enter Recovery mode (see figure below).

Select backup and restore > yes; backup > yes ;backup to sd > yes [home] confirmation.

Back up your phone data to SD Card, then unplug SD Card

Then do a factory reset.

Select Wipe Data Factory Reset > yes, home] to confirm.

Select reboot system now > yes , home] to confirm.

After this operation, the phone restarts, and the above problem can be solved.

Hope this helps you!!

Samsung Note2 stuck on the boot screen does not boot properly, it may be due to system crash, or hardware failure.

Users can try to flash the system by themselves, and they can go into Recovery to flash the machine.

Then enter the card mode, that is, the recovery interface, to shut down the computer first, press the volume on and the power button until the recovery interface appears.

Before flashing, you need to double wipe, in fact, it is to clear the data, cache, and restore it to the exit mode.

Select the fifth option, install zip from sdcard.

The phone will automatically execute the flashing procedure, and the phone will automatically enter the system when the flashing is completed.

If the flashing cannot be completed or the system cannot be accessed after flashing, it is likely that the hardware is faulty, and it is recommended that the user send the mobile phone to the brand's customer service for testing and repair.

If the mobile phone cannot enter the system page after booting up, and the screen is stuck or frozen, it is recommended that: 1Press and hold the power button for 8-10 seconds to restart the machine.

If it is a built-in battery, please press and hold the power button and the down volume button at the same time for more than 7 seconds to restart the device. 2.If you can access the system, please check whether the mobile phone has a system update push, if so, please upgrade the machine to the latest system version.

3.If it doesn't work, please back up the data in your phone and try to restore the machine to factory settings. If the problem persists, it may be a problem with the system program of the mobile phone, please bring the purchase invoice, warranty card and machine to the Samsung service center for inspection.

Which is deleted something in the system.,Brush the machine and fix it.。

The main factors that the mobile phone cannot be turned on are the battery, mobile phone software, and hardware that will cause the failure to turn on. We recommend that you perform the following steps:

1. Charge with wire for a period of time and try to turn it on.

2. Take out the SIM card and SD card at the same time, and then press the power button for more than 10 seconds to test whether it can be turned on.

3. If you can enter the boot interface, but your phone cannot enter the home page, please restart your phone to try. The operation steps are as follows: Press and hold the power button and the down volume button at the same time for more than 7 seconds to restart the device.

Note: Some models require you to press and hold the power button for 8-10 seconds to restart the phone).

If it still can't be turned on normally, there may be a problem with the system program or hardware, and it is recommended to send the phone to the nearest service center for testing.