-
In fact, xp install win7 does not need u disk you have win7 original image does not first unzip to the drive letter of other disks do not unzip to c disk and other disk folders and then**an nt6 hard disk installation tool click on install and then prompt to find win7 win8 installer click below restart after reboot when booting select mode two that is, the bottom one and then the installer starts point custom installation and then your hard disk partition will appear select the partition you want to install below there is A drive advanced options button Click that and then there is a format button Click to format the C disk and then click Next about 10 minutes Win7 can be installed But the reminder is that it is best to back up the network card driver after installation and then**a driver wizard to update the driver in the installation of soft and commonly used software.
win7 32-bit Ultimate Original Image。
The activation tool is also available with Windows Loader, an NT6 hard drive installation tool that can be searched on the Internet.
If you want to take detailed steps, you can add my buckle 319101761 install the system There are many ways to install the system 1 Optical drive installation 2 U disk installation 3 Hard disk installation 4 U disk boot hard disk installation 5 Virtual optical drive installation However, the U disk installation is generally a ghost system Win7 is not recommended to use the ghost version It is better to use the original image At present, most of the original images used by everyone are MSDN version It is "MSDN I tell you" on this **.
-
Directly** a system image, win7....ISO, open it with a floppy disk, then burn it in, press F2 when you boot up, set the U disk to start, and then choose to install it to the C disk, and wait for about half an hour to be OK.
-
Hello. If there is a network,In fact, you can go to the system home** installed version of the system,**After unzipping and opening,Run the program,It will automatically pop up the directory of the system for you to select,After selection, click OK,It will be automatically installed,It's very simple。
If you want to use a USB flash drive to install the system, I found a tutorial, with **, I think it should be useful to you, you refer to it, if you are satisfied.
-
However, it should be noted that there are viruses on the Internet, so remember to kill the virus immediately after installing it, otherwise it will be very painful.
If you can't say it clearly, you can just chat and ask me Anyway, I'm bored right now = =.
-
= It's so troublesome. To do the boot disk program of the USB flash drive first.。。
-
When a laptop has a system failure, we usually reinstall it. If you need to reinstall the notebook XP system, then you can use a USB flash drive to reinstall it. If you are not sure about the steps to reinstall, then you can refer to the steps introduced below to reinstall the notebook XP system with a USB flash drive.
G left and right U disk, make U disk PE to start changing hunger disk.
2. System image: Notebook ghostxp pure version.
3. Boot settings: Set the boot to start from the USB flash drive.
2. How to reinstall the notebook XP system with a USB flash drive
2. Insert the boot disk of the USB flash drive into the laptop, and after restarting, keep pressing the corresponding shortcut keys such as F12 F11 ESC, and select Start from the USB flash drive;
3. After successfully booting to the main interface of the USB flash drive, select to run PE Enhanced Edition;
4. After entering the PE system, double-click to open the [PE one-click installation], select the location of the system, usually the C drive, and click OK;
5. Then enter the following interface, start to perform the system decompression operation, and wait for the operation to complete;
6. After the above operations are completed, the computer will automatically restart, then pull out the USB flash drive and continue the XP system reinstallation process;
7. During the reinstallation process, it needs to be restarted many times, and after success, it will be restarted and enter the desktop of the notebook XP system.
The above is the introduction of the specific steps to reinstall the notebook XP system with a USB flash drive, and users who need it can refer to it.
-
I haven't understood it after reading so much on the Internet, so it's difficult for others to do it no matter how hard they work, spend some money and let others install it for you, and you can watch it when others decorate it.
Also, try to enter safe mode, if you can, go in, cancel Kaspersky's auto-start, and then enter normally. It's not easy to reinstall the old machine.
1. Generally, there are two modes of hard disk, one is SATA mode, which is newer, and the other is PATA mode, which is older, and they all need to configure drivers, but their drivers are not the same. >>>More
1. The data of the C disk of the reinstalled system must be overwritten and power-off, and the files of other disks can be retained, but the applications need to be reinstalled. >>>More
To enter the BIOS of an ASUS laptop, press the power switch and click the F2 button. >>>More
When you installed the system, you just partitioned the hard disk, but you must format the hard disk before it can be used normally, so you didn't format the hard disk, and now you can't see the hard disk when you enter the operating system. It must be formatted, you can use the DOS operating system, which is the command prompt, enter the following command: format d: >>>More
Internet ** a virtual drive wizard and then from the depth **** an xp disc image, and then use the virtual disc wizard to load the image, after the loading is completed, open my computer will have one more disc drive letter and then open to find the installer and choose to restore the system to c disk The rest is to wait, restart twice and enter the XP. Specifically, the virtual optical drive system is used, and this method is relatively simple. I hope to solve the problem, in addition to the boot disk, you also have to set up the computer startup items with a USB flash drive. >>>More