Why can t I split it in CAD, can anyone tell me the answer! Thank you!

You try to use .x Doesn't look good.

In the setting window of the CAD software insertion block, the block can be split, please refer to the following steps for the specific operation.

1. Use the insert block command to directly place the block that has been set, and you can see that after placing the block, you can only select the block as a whole.

2. Then click the "Insert" option in the menu bar above Changxi, and in the pop-up menu options, click "Block" to enter the insert block command.

3. Then the setting window for inserting the block will pop up, in the "Name" setting of the window, click the drop-down arrow, and select the image you want to insert in the drop-down box.

4. In the lower right corner of the window, you can see the option of "Decompose", click the box in front of you, check the "Decompose" setting, and then click the OK button.

5. Go back to the drawing area, click the left mouse button directly to place the block, and find that you can select the line separately. Once you have done the above settings, you can split the blocks with CAD.

If it is an assembly CAD model, you can move each drawing a distance with the move tool to form a part drawing.

If it is a single shape, use the explode command to explode the shape to form a single face or wire.

What does splitting mean? Is it a decomposition command? Or what?

Tools Materials.

Computer CAD software BAI

Here's how. du1, first of all, in the CAD software to open the diagram can not be decomposed dao paper, as shown in the following figure:

2. Then switch to the special "Affiliator" property window. Select the exploded tile and click "Select" "Blocker", as shown in the following figure

3. Then click on the "Blow All" option on the right, as shown in the figure below

4. Finally, click on the "Breakdown" option on the page.

Encounter not bai

The block that can be decomposed should be du

1. Double-click the tile to enter the tile.

2.Don't select anything, crt+1 brings up the attributes.

3.Find the bottom block, change it to Yes, and exit the blocker. ok

If not, you can dig it out. Treasure. The web can help you get it done.

Normally, I will also encrypt the files sent to the outside so that others can't modify them! There is still a way for you to crack this, but I don't want you to use this way to get the fruits of other people's labor!

This general bai

It is the drawing of the design institute encryption, a little.

Du is a whole piece, and it is impossible to make it up

Tools Raw materials.

Computer CAD software.

Method steps.

1. Open the CAD software, draw a graphic composed of straight lines, click "Drawing", click "Block", "Create".

2. Name the block 101, click "Pick Point", pick the location of the marked point in the map, click "Select Object", select all the shapes, and click OK.

3. Click "Insert" and click "Block" in the drop-down menu.

4. In'Insert an option box", select the block name, select "Explode" in the lower left corner, and click OK.

5. At the designated position on the screen, close the state and click the left button, and the sail lead will get the figure after the block is disassembled, and the block disassembly will be completed.

The method of CAD splitting blocks is as follows:

Open the CAD software, find the "Split" button in the menu bar to use, and then select the block that needs to be decomposed in the drawing, and then the block will be automatically divided into benches.

Tools Materials.

Computer CAD software.

Here's how. 1. First of all, open the drawings that cannot be decomposed in the CAD software, which mountain is shown in the following figure:

<>3. Then click the "Explosion Surprise" option on the right side, as shown in the figure below

4. Finally, click on the "Decompose" option on the page.