What should I do if I add too much oil? Can the car continue to drive?

Updated on Car 2024-05-04
13 answers
  1. Anonymous users2024-02-09

    It is best not to continue to drive the engine oil if it is too much oil, but to take out the engine oil, otherwise it will affect the driving experience. My engine oil is added in the repair shop, so this has never happened, I think you can still go to the repair shop, although the repair shop has many fakes, but the oil must be reliable. Although I always go to the repair shop to change the engine oil, but the engine oil is all brought by myself, I buy GT Magic Red engine oil imported from Germany, and the official is the only sales channel.

  2. Anonymous users2024-02-08

    If the engine oil is added, the engine power is lost, too much oil will jump into the combustion chamber, the engine burns the oil, and the exhaust gas emits blue smoke, the oil consumption increases significantly, and the carbon deposit inside the engine increases, and even leads to premature ignition, detonation, and cylinder pulling, which seriously damages the engine.

    Generally, add it to the middle of the two scales, and find a place to put the oil off a little.

  3. Anonymous users2024-02-07

    It's okay to have a little more, not too much, too much can be released a little, just look at the oil dipstick of the engine and don't go over the upper limit.

  4. Anonymous users2024-02-06

    It is recommended to use a large syringe with an infusion tube to draw from the plug hole of the oil dipstick, and the clean oil can be stored and continued to be used, which is the safest method.

    If the oil level touches the crankshaft, it is best to pull out some, it is not recommended to disassemble the oil drain screw, because the gasket of the oil drain screw should also be replaced when changing the oil, the gasket material is very soft, and it will be deformed after tightening, which plays the role of full sealing, and the sealing effect is greatly reduced after disassembly, and the gasket must be replaced with a new one. Moreover, it is difficult to control the flow rate by disassembling the oil drain screw, and the released oil can no longer be used.

  5. Anonymous users2024-02-05

    If you fill up too much gasoline, first of all, don't take any chances, thinking that you will be fine after a while.

    If you add too much oil, don't be naïve to think about actively burning and consuming it, you can reduce the pressure on the car, which is very bad for your car. In this way, the crankcase oil seal and piston ring will be injured, the carbon deposit in the combustion chamber is definitely more than normal, and the oil content of the exhaust gas of the secondary combustion will be super high. Similarly, due to the fact that more than the normal amount of engine oil is involved in combustion, in addition to the formation of carbon deposits in the combustion chamber, valve seats, and near the spark plug electrodes, the other part of the oil will burn the engine oil.

    If your car is smoky, be prepared to pay for it.

    If you are very concerned about your car and you have never turned your car upside down, it is recommended that you go to a professional store to find a professional to help you solve it. Just tell him the specifics of your car and they'll get it done for you in no time.

    If you think you can pour it out, teach you how to use a syringe + a plastic tube for a drip to suck out the excess oil. There are also scales on the medical plastic tubes, which are easy to reference. However, it is still recommended to find a professional to deal with it.

  6. Anonymous users2024-02-04

    Solution: Find a needle tube, as well as the tube that is usually used to hang the needle, and then start pumping after sticking through the hole of the oil ruler, but this method will be more laborious.

    If the oil is added too much, there will be a phenomenon of burning the engine oil. As the pressure increases due to the increase in oil, the amount of fuel injected through the piston ring increases, and the oil vapor through the crankshaft forced ventilation also increases;

    As a result, the pressure of the oil-gas separator increases, and the separation is not complete, resulting in a large amount of oil entering the throttle valve through the exhaust pipe to re-participate in the combustion, so there will be a situation of burning engine oil.

    In addition, the residue of the combustion of the engine oil (which is mainly made of carbon, which is very hard) will accumulate on the combustion chamber wall, reducing the combustion chamber space, thereby reducing the compression ratio of the engine, and also accelerating the wear of the cylinders and pistons, thus reducing the service life of the vehicle.

  7. Anonymous users2024-02-03

    In the past few days, the car has reached about 2000 rpm (1 and 5 gears are the same, and it is more displayed when the car is cold), and the shaking is obvious, and the engine sound is relatively loud. Less than 2000 or above 2200 is not the case, is this a sign of more oil? If not, what is the cause?

  8. Anonymous users2024-02-02

    If there is too much oil, the balance weight and the big end of the connecting rod will cause the oil in the oil pan to stir violently, which will not only increase the internal power loss of the engine, but also increase the oil splashed on the cylinder wall, resulting in the failure of burning oil.

  9. Anonymous users2024-02-01

    Hello, it is recommended to find a repair shop immediately to put it out or have the best to suck it out directly from the oil dipstick, it can not be used for a long time, it will damage the three-way catalytic converter, I hope it can help you, car problems, ask the car master, if you are not sure, please log in to the car master to find me!

  10. Anonymous users2024-01-31

    If the oil is filled too much, it will cause too much internal resistance in the engine, affect the power of the engine, and damage the three-way catalysis!

  11. Anonymous users2024-01-30

    Just let go of a little bit and fit! But are you sure if your car is parked on flat ground, and if you are parked on a slope, your dipstick will have more or less oil, check carefully.

  12. Anonymous users2024-01-29

    If there is an increase in oil in the car, do not continue to use it. When this happens, check the cause of the oil increase, and continue to use it after the fault is repaired. The oil level of the automobile engine cannot be lower than the minimum scale of the oil dipstick or higher than the maximum scale of the oil dipstick, otherwise the normal operation of the engine will be affected.

    The oil is called the blood of the engine. If the engine has no oil, the engine cannot run.

    Engine oil not only plays a lubricating role in the engine, but also cleans, seals, buffers, prevents rust and dissipates heat.

    When the engine is running, the oil will form a layer of oil film on the surface of each component in the engine, which can avoid friction caused by direct contact between the various parts in the engine.

    If the parts in the engine are in direct contact and cause friction, it will instantly cause a lot of heat in the engine and affect the normal operation of the engine.

    The performance of the engine oil will deteriorate after a long period of use, and the oil needs to be changed regularly.

    It is recommended that you change the oil regularly and change the oil filter element with each oil change.

    The oil filter element is used to filter the oil. If there is no oil filter, the oil will become dirty after a period of use, affecting the lubrication of the engine.

    When buying an oil filter, be sure to choose a big brand**.

    Millions of car purchase subsidies.

  13. Anonymous users2024-01-28

    If you add too much oil, be sure to pull out the excess part, and you can also release the excess part. Adding too much oil is harmful to the engine, adding too much oil may damage the three-way catalysis, and may also lead to poor lubrication of the engine. Be sure to deal with it immediately after adding more.

    When adding engine oil, you must make sure that the oil is between the min scale and the max scale of the oil dipstick, you are actually not tied in, it is necessary to add the oil scale to the max scale of the oil dipstick.

    Engine oil is something that many car owners often come into contact with when using the car, engine oil is called the blood of the engine, and the oil not only plays a lubricating role in the engine, but also plays a role in cleaning, sealing, buffering, heat dissipation, and rust prevention.

    If there is no oil in the engine, the engine will not function properly at all.

    Engine oil needs to be changed regularly, if used for a long time, the performance of all aspects of the engine oil will be reduced, if not changed for a long time, it will aggravate the wear and tear of the engine.

    Every time you change the oil, you must remember to replace the oil filter element together, the oil filter element is used to filter the oil, if there is no oil filter element, the oil will become dirty after a period of use, which will also affect the normal lubrication of the oil.

    When buying engine oil and oil filter elements, we must choose regular channels, we should not be greedy for cheap and choose fake and shoddy products, and the long-term use of fake oil is relatively harmful to the engine.

Related questions
17 answers2024-05-04

Take a slender and clean hose, pinch the hose tightly and suck it slowly with your mouth (don't pinch it to death), which can prevent you from sucking the oil into the mouth too hard, and wait for the oil level of the hose to be close to the mouth for ten to twenty centimeters, pinch the tube with your hands, put the mouth of the tube into the container on the ground, use the difference in the height of the liquid level to release the oil, and then go back if you put more.

10 answers2024-05-04

Effects of adding more oil to a car:

"Engine oil" is a necessary lubricant to ensure the normal operation of the engine, its specific role is to lubricate metal parts, reduce the friction between parts, take away the huge heat generated by the engine when doing work, clean the fine metal debris produced after wear, as well as sealing, shock absorption, rust prevention and other functions. However, when filling the oil, it should be noted that the amount of oil should not be too much or too little, and should be between the "low" and "full" positions of the dipstick. >>>More

17 answers2024-05-04

Hello, if the oil only exceeds the scale point on the dipstick, this basically has no effect, if you want to get it out, you can use the leather tube or go to the repair shop to ask them to help you pull out the point.

10 answers2024-05-04

There is a fault of burning engine oil in the vehicle, and the common fault points are as follows: >>>More

11 answers2024-05-04

Hello! Adding too much oil to the car can easily cause the problem of burning engine oil, and in serious cases, it will damage the engine of your car, so you must pay attention to not being higher than the oil scale when replacing the added oil. >>>More